ISO 16004:2017

Aircraft ground equipment — Passenger boarding bridge or transfer vehicle — Interface requirements with aircraft doors

ISO 16004:2017 specifies dimensional interface and unobstructed space requirements applicable to the aircraft mating section of either a) passenger boarding bridges, or b) passenger transfer vehicles used at airports for boarding and disembarkation of passengers on the types of civil transport aircraft which have been listed hereafter. These types of aircraft have a door sill height greater than 2,0 m (80 in) over the ground. Lower aircraft usually do not require such means of access, and have not been taken into account.

Matériel au sol pour aéronefs — Passerelle passagers ou autobus élévateur — Exigences d'interface avec les portes d'aéronefs

General Information

• Status: Published
• Publication Date: 08-Jan-2017
• ICS: 49.100 - Ground service and maintenance equipment
• Technical Committee: ISO/TC 20/SC 9 - Air cargo and ground equipment
• Drafting Committee: ISO/TC 20/SC 9 - Air cargo and ground equipment
• Current Stage: 9093 - International Standard confirmed
• Completion Date: 07-Jun-2024

Relations

• Revises: ISO 16004:2005 - Aircraft ground equipment — Passenger boarding bridge or transfer vehicle — Requirements for interface with aircraft doors
• Effective Date: 28-May-2016

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 16004
Second edition
2017-01
Aircraft ground equipment —
Passenger boarding bridge or transfer
vehicle — Interface requirements with
aircraft doors
Matériel au sol pour aéronefs — Passerelle passagers ou autobus
élévateur — Exigences d’interface avec les portes d’aéronefs
Reference number
ISO 16004:2017(E)
©
ISO 2017

---------------------- Page: 1 ----------------------
ISO 16004:2017(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2017 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 16004:2017(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 2
3 Terms and definitions . 2
4 General safety requirements . 2
5 Equipment requirements for interface with aircraft . 2
5.1 Reference planes . 2
5.2 Critical areas . 3
5.3 Minimum requirements . 3
5.4 Automatic levelling . 3
5.5 Back-up system . 3
6 Operating requirements . 3
Bibliography . 6
© ISO 2017 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 16004:2017(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the I
...