ISO 17949:2013/Amd 1:2017

Impact test procedures for road vehicles — Seating and positioning procedures for anthropomorphic test devices — Procedure for the WorldSID 5Oth percentile male side-impact dummy in front outboard seating positions — Amendment 1

Procédures d'essai de choc pour véhicules routiers — Procédures d'installation et de positionnement des dispositifs d'essais anthropomorphes — Procédure pour le mannequin WorldSID, 50ème percentile homme, de choc latéral pour positions de conducteur et passager avant droit — Amendement 1

General Information

• Status: Published
• Publication Date: 16-May-2017
• ICS: 43.180 - Diagnostic, maintenance and test equipment
• Technical Committee: ISO/TC 22/SC 36 - Safety and impact testing
• Drafting Committee: ISO/TC 22/SC 36/WG 1 - Car collision test procedures
• Current Stage: 6060 - International Standard published
• Due Date: 17-Dec-2017
• Completion Date: 17-May-2017

Relations

• Amends: ISO 17949:2013 - Impact test procedures for road vehicles — Seating and positioning procedures for anthropomorphic test devices — Procedure for the WorldSID 5Oth percentile male side-impact dummy in front outboard seating positions
• Effective Date: 09-May-2020

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 17949
First edition
2013-05-01
AMENDMENT 1
2017-05
Impact test procedures for road
vehicles — Seating and positioning
procedures for anthropomorphic test
devices — Procedure for the WorldSID
5Oth percentile male side-impact
dummy in front outboard seating
positions
AMENDMENT 1
Procédures d’essai de choc pour véhicules routiers — Procédures
d’installation et de positionnement des dispositifs d’essais
anthropomorphes — Procédure pour le mannequin WorldSID, 50ème
percentile homme, de choc latéral pour positions de conducteur et
passager avant droit
AMENDEMENT 1
Reference number
ISO 17949:2013/Amd.1:2017(E)
©
ISO 2017

---------------------- Page: 1 ----------------------
ISO 17949:2013/Amd.1:2017(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2017 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 17949:2013/Amd.1:2017(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
describe
...