ISO 13521:2015

Austenitic manganese steel castings

ISO 13521:2015 specifies austenitic manganese cast steels for wear-resistant service. The grades covered by this International Standard will experience maximum service life in applications where the surface of the casting is subject to impact.

Pièces moulées en acier austénitique au manganèse

General Information

• Status: Withdrawn
• Publication Date: 30-Sep-2015
• ICS: 77.140.80 - Iron and steel castings
• Technical Committee: ISO/TC 17/SC 11 - Steel castings
• Drafting Committee: ISO/TC 17/SC 11 - Steel castings
• Current Stage: 9599 - Withdrawal of International Standard
• Completion Date: 10-Feb-2023

Relations

• Revised: ISO 13521:2023 - Austenitic manganese steel castings
• Effective Date: 06-Jun-2022
• Revises: ISO 13521:1999 - Austenitic manganese steel castings
• Effective Date: 12-Feb-2011

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 13521
Second edition
2015-10-01
Austenitic manganese steel castings
Pièces moulées en acier austénitique au manganèse
Reference number
ISO 13521:2015(E)
©
ISO 2015

---------------------- Page: 1 ----------------------
ISO 13521:2015(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2015 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 13521:2015(E)

Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 General conditions of delivery . 1
4 Heat treatment . 1
5 Chemical composition . 1
6 Mechanical tests . 2
6.1 General . 2
6.2 Bend test . 2
6.3 Hardness test . 2
7 Microstructure . 2
8 Supplementary requirements . 3
Bibliography . 4
© ISO 2015 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 13521:2015(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
...