Hard coal — Size analysis by sieving

ISO 1953:2015 specifies reference methods for the size analysis of coal by manual sieving (wet or dry), using test sieves of aperture sizes between 125 mm and 45 μm. A guide to sampling is given in Annex A. This International Standard is applicable to all hard coals. It is not applicable to coke or other manufactured fuels. In the case of pulverized coal which has been ground so that a high proportion passes through the test sieve of smallest aperture size, the methods described in this International Standard will determine only the percentage oversize.

Houille — Analyse granulométrique par tamisage

Črni premog - Določanje zrnatosti s sejalno analizo

Ta mednarodni standard določa referenčne metode za sejalno analizo premoga z ročnim sejanjem (mokrim ali suhim) pri uporabi preskusnih sejalnikov z velikostjo odprtine sita od 125 mm do 45 μm. Navodila za takšno vzorčenje so podana v dodatku A.
Ta mednarodni standard se uporablja za vse vrste črnega premoga. Ne uporablja se za koks ali druga proizvedena goriva.
V primeru premoga v prahu, ki je bil zmlet tako, da najmanjša velikost odprtine preskusnega sita prepusti velik delež premoga, metode, opisane v tem mednarodnem standardu, določajo le nadmerni odstotni delež.

General Information

Status
Published
Publication Date
09-Nov-2015
Current Stage

Relations

Buy Standard

Standard
ISO 1953:2016
English language
18 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day
Standard
ISO 1953:2015 - Hard coal -- Size analysis by sieving
English language
13 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

SLOVENSKI STANDARD
SIST ISO 1953:2016
01-maj-2016
1DGRPHãþD
SIST ISO 1953:1998
ýUQLSUHPRJ'RORþDQMH]UQDWRVWLVVHMDOQRDQDOL]R
Hard coal - Size analysis by sieving
Houille - Analyse granulométrique par tamisage
Ta slovenski standard je istoveten z: ISO 1953:2015
ICS:
73.040 Premogi Coals
SIST ISO 1953:2016 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST ISO 1953:2016

---------------------- Page: 2 ----------------------

SIST ISO 1953:2016
INTERNATIONAL ISO
STANDARD 1953
Third edition
2015-11-15
Hard coal — Size analysis by sieving
Houille — Analyse granulométrique par tamisage
Reference number
ISO 1953:2015(E)
©
ISO 2015

---------------------- Page: 3 ----------------------

SIST ISO 1953:2016
ISO 1953:2015(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved

---------------------- Page: 4 ----------------------

SIST ISO 1953:2016
ISO 1953:2015(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Apparatus . 1
4.1 For all methods . 1
4.2 For dry sieving . 2
4.3 For wet sieving . 2
5 Sampling of test sample . 2
5.1 General . 3
5.2 Drying . 3
5.3 Division (other than wet coal of nominal top size less than 4 mm) . 3
5.4 Division of wet coal of nominal top size less than 4 mm . 4
6 Procedure. 4
6.1 General . 4
6.2 Dry s
...

INTERNATIONAL ISO
STANDARD 1953
Third edition
2015-11-15
Hard coal — Size analysis by sieving
Houille — Analyse granulométrique par tamisage
Reference number
ISO 1953:2015(E)
©
ISO 2015

---------------------- Page: 1 ----------------------
ISO 1953:2015(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 1953:2015(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Apparatus . 1
4.1 For all methods . 1
4.2 For dry sieving . 2
4.3 For wet sieving . 2
5 Sampling of test sample . 2
5.1 General . 3
5.2 Drying . 3
5.3 Division (other than wet coal of nominal top size less than 4 mm) . 3
5.4 Division of wet coal of nominal top size less than 4 mm . 4
6 Procedure. 4
6.1 General . 4
6.2 Dry sieving . 4
6.2.1 Sample of maximum particle size greater than 22,4 mm . 4
6.2.2 Sample of maximum particle size between 4 mm and 22,4 mm—
manual method . 5
6.2.3 Sample of maximum particle size less than 4 mm—ma
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.