ISO 18192-1:2011/Amd 1:2018

Implants for surgery — Wear of total intervertebral spinal disc prostheses — Part 1: Loading and displacement parameters for wear testing and corresponding environmental conditions for test — Amendment 1

Implants chirurgicaux — Usure des prothèses totales de remplacement des disques intervertébraux lombaires — Partie 1: Paramètres de charge et de déplacement pour essais d'usure et conditions environnementales correspondantes — Amendement 1

General Information

• Status: Published
• Publication Date: 17-Dec-2018
• ICS: 11.040.40 - Implants for surgery, prosthetics and orthotics
• Technical Committee: ISO/TC 150/SC 5 - Osteosynthesis and spinal devices
• Drafting Committee: ISO/TC 150/SC 5 - Osteosynthesis and spinal devices
• Current Stage: 6060 - International Standard published
• Due Date: 13-Aug-2019
• Completion Date: 18-Dec-2018

Relations

• Amends: ISO 18192-1:2011 - Implants for surgery — Wear of total intervertebral spinal disc prostheses — Part 1: Loading and displacement parameters for wear testing and corresponding environmental conditions for test
• Effective Date: 31-Jul-2021

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 18192-1
Second edition
2011-03-01
AMENDMENT 1
2018-12
Implants for surgery — Wear of
total intervertebral spinal disc
prostheses —
Part 1:
Loading and displacement parameters
for wear testing and corresponding
environmental conditions for test
AMENDMENT 1
Implants chirurgicaux — Usure des prothèses totales de
remplacement des disques intervertébraux lombaires —
Partie 1: Paramètres de charge et de déplacement pour essais d'usure
et conditions environnementales correspondantes
AMENDEMENT 1
Reference number
ISO 18192-1:2011/Amd.1:2018(E)
©
ISO 2018

---------------------- Page: 1 ----------------------
ISO 18192-1:2011/Amd.1:2018(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 18192-1:2011/Amd.1:2018(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO
...