ISO 7176-14:2022/Amd 1:2025

Wheelchairs — Part 14: Power and control systems for electrically powered wheelchairs and scooters — Requirements and test methods — Amendment 1: Correction of referred standard

Fauteuils roulants — Partie 14: Systèmes d'alimentation et de commande des fauteuils roulants et des scooters électriques — Exigences et méthodes d'essai — Amendement 1: Correction de la norme de référence

General Information

• Status: Published
• Publication Date: 13-Mar-2025
• ICS: 11.180.10 - Aids and adaptation for moving
• Technical Committee: ISO/TC 173/SC 1 - Wheelchairs
• Drafting Committee: ISO/TC 173/SC 1/WG 10 - Requirements and test methods for electro-technical systems for wheelchairs
• Current Stage: 6060 - International Standard published
• Start Date: 14-Mar-2025
• Due Date: 14-Mar-2025
• Completion Date: 14-Mar-2025

Relations

• Amends: ISO 7176-14:2022 - Wheelchairs — Part 14: Power and control systems for electrically powered wheelchairs and scooters — Requirements and test methods
• Effective Date: 23-Dec-2023

Standards Content (Sample)

International
Standard
ISO 7176-14
Third edition
Wheelchairs —
2022-03
Part 14:
AMENDMENT 1
Power and control systems for
2025-03
electrically powered wheelchairs
and scooters — Requirements and
test methods
AMENDMENT 1: Correction of referred
standard
Fauteuils roulants —
Partie 14: Systèmes d'alimentation et de commande des fauteuils
roulants et des scooters électriques — Exigences et méthodes d'essai
AMENDEMENT 1: Correction de la norme de référence
Reference number
ISO 7176-14:2022/Amd.1:2025(en) © ISO 2025

ISO 7176-14:2022/Amd.1:2025(en)
© ISO 2025
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii
ISO 7176-14:2022/Amd.1:2025(en)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out through
ISO technical committees. Each member body interested in a subject for which a technical committee
has been established has the right to be represented on that committee. International organizations,
governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely
with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are described
in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the different types
of ISO documents should be noted. This document was drafted in
...