ISO 19825:2018

Road vehicles — Liquefied petroleum gas (LPG) refuelling connector

This document applies to Liquefied Petroleum Gas vehicle nozzles and receptacles, hereinafter referred to as devices, constructed entirely of new, unused parts and materials. Liquefied Petroleum Gas fuelling connectors consist of the following components, as applicable: a) nozzle (mounted on dispenser side) (see Clause 5); b) receptacle (mounted on vehicle) (see Clause 7). This document applies to devices which have a gauge service pressure in the range of 110 kPa (Butane rich at 20 °C) and 840 kPa (Propane at 20 °C), hereinafter referred to as [see 9.1 c)]: — J15; — K15. This document also applies to: — devices with standardized mating components; — connectors which prevent Liquefied Petroleum Gas vehicles from being fuelled by other gaseous fuels station dispensers; and — Liquefied Petroleum Gas in accordance with ISO 9162. NOTE All references to pressures (kPa) throughout this document are considered gauge pressures unless otherwise specified. This document does not apply to the fuel system of vehicle, with the exception of the Liquefied Petroleum Gas receptacle.

Véhicules routiers — Connecteur de remplissage en gaz de pétrole liquéfié (GPL)

General Information

• Status: Published
• Publication Date: 25-Nov-2018
• ICS: 43.060.40 - Fuel systems
• Technical Committee: ISO/TC 22/SC 41 - Specific aspects for gaseous fuels
• Drafting Committee: ISO/TC 22/SC 41/WG 6 - Fuel system components and refuelling connector for vehicles propelled by Liquefied Petroleum Gas (LPG)
• Current Stage: 9093 - International Standard confirmed
• Completion Date: 22-Apr-2024

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 19825
First edition
2018-11
Road vehicles — Liquefied petroleum
gas (LPG) refuelling connector
Véhicules routiers — Connecteur de remplissage en gaz de pétrole
liquéfié (GPL)
Reference number
ISO 19825:2018(E)
©
ISO 2018

---------------------- Page: 1 ----------------------
ISO 19825:2018(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 19825:2018(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 General construction requirements . 3
5 Nozzles . 4
6 Standard receptacle dimensions J15 and K15 . 4
7 Receptacles . 6
8 Instructions . 7
9 Marking . 7
10 Tests . 8
10.1 General requirements . 8
10.2 Impact resistance . 8
10.2.1 Nozzle test . 8
10.2.2 Receptacle test . 9
10.3 Leakage at room temperature . 9
10.4 Abnormal loads . 9
10.4.1 General.
...