Optical amplifiers - Test methods - Part 1-1: Power and gain parameters - Optical spectrum analyzer method (IEC 61290-1-1:2015)

This part of IEC 61290 applies to all commercially available optical amplifiers (OAs) and
optically amplified modules. It applies to OAs using optically pumped fibres (OFAs based on
either rare-earth doped fibres or on the Raman effect), semiconductor OAs (SOAs) and planar
optical waveguide amplifiers (POWAs).
The object of this standard is to establish uniform requirements for accurate and reliable
measurements, by means of the optical spectrum analyzer test method, of the following OA
parameters, as defined in IEC 61291-1:
a) nominal output signal power;
b) gain;
c) polarization-dependent gain;
d) maximum output signal power;
e) maximum total output power.
NOTE All numerical values followed by (‡) are suggested values for which the measurement is assured.
The object of this standard is specifically directed to single-channel amplifiers. For
multichannel amplifiers, one should refer to the IEC 61290-10 series [1]2.

Prüfverfahren für Lichtwellenleiter-Verstärker - Teil 1-1: Optische Leistungs- und Verstärkungsparameter - Verfahren mit optischem Spektralanalysator (IEC 61290-1-1:2015)

Amplificateurs optiques - Méthodes d'essai - Partie 1-1: Paramètres de puissance et de gain - Méthode de l'analyseur de spectre optique (IEC 61290-1-1:2015)

L'IEC 61290-1-1:2015 s'applique à tous les amplificateurs optiques et modules à amplification optique disponibles sur le marché. Elle s'applique aux amplificateurs optiques utilisant des fibres pompées optiquement (OFA basés sur des fibres dopées aux terres rares ou sur l'effet Raman), des amplificateurs optiques à semiconducteurs (SOA) et des amplificateurs à guide d'onde optique planaire (POWA). L'objet de la présente norme est d'établir des exigences uniformes pour des mesurages précis et fiables, par le biais de la méthode d'essai de l'analyseur de spectre optique, des paramètres d'amplificateurs optiques donnés ci-dessous, tels qu'ils sont définis dans l'IEC 61291-1:
- puissance nominale du signal de sortie;
- gain;
- gain dépendant de la polarisation;
- puissance maximale du signal en sortie;
- puissance totale maximale en sortie. L'objet de la présente norme est spécifiquement centré sur les amplificateurs à un seul canal. Pour les amplificateurs à canaux multiples, il convient de se reporter à la série IEC 61290-10. Cette troisième édition annule et remplace la deuxième édition parue en 2006 et constitue une  révision technique. La présente édition contient les principales modifications techniques suivantes par rapport à l'édition précédente: mises à jour des caractéristiques de l'appareillage de mesure; révision de la liste des paramètres relatifs aux amplificateurs optiques traités.
Mots clés: amplificateurs optiques, essai de l'analyseur de spectre optique, amplificateurs à un seul canal

Optični ojačevalniki - Preskusne metode - 1-1. del: Močnostni in ojačevalni parametri - Metoda z analizatorjem optičnega spektra (IEC 61290-1-1:2015)

Ta del standarda IEC 61290 se uporablja za vse komercialno dostopne optične ojačevalnike (OA) in optično ojačane module. Uporablja se za optične ojačevalnike z optično črpanimi vlakni (OFA, ki temeljijo na dopiranih vlaknih redke zemljine ali Ramanovem efektu), polprevodniške optične ojačevalnike (SOA) in ravninske optične valovodne ojačevalnike (POWA).
Cilj tega standarda je določiti enotne zahteve za točne in zanesljive meritve z uporabo preskusne metode z analizatorjem optičnega spektra, in sicer naslednjih parametrov optičnih ojačevalnikov, kot je določeno v standardu IEC 61291-1:
a) nazivne izhodne signalne moči;
b) ojačenja;
c) ojačenja, odvisnega od polarizacije;
d) največje izhodne signalne moči;
e) največje skupne izhodne moči.
OPOMBA: Vse številčne vrednosti, za katerimi je znak (‡), so predlagane vrednosti, za katere se zagotovi merjenje. Cilj tega standarda je obravnavati zlasti enokanalne ojačevalnike. Večkanalni ojačevalniki so obravnavani v skupini standardov IEC 61290-10 [1]2.

General Information

Status
Withdrawn
Publication Date
09-Sep-2015
Withdrawal Date
12-Oct-2023
Technical Committee
Current Stage
9900 - Withdrawal (Adopted Project)
Start Date
13-Oct-2023
Due Date
05-Nov-2023
Completion Date
13-Oct-2023

Relations

Buy Standard

Standard
EN 61290-1-1:2015
English language
15 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 61290-1-1:2015
01-oktober-2015
1DGRPHãþD
SIST EN 61290-1-1:2007
2SWLþQLRMDþHYDOQLNL3UHVNXVQHPHWRGHGHO0RþQRVWQLLQRMDþHYDOQL
SDUDPHWUL0HWRGD]DQDOL]DWRUMHPRSWLþQHJDVSHNWUD ,(&
Optical amplifiers - Test methods - Part 1-1: Power and gain parameters - Optical
spectrum analyzer method (IEC 61290-1-1:2015)
Prüfverfahren für Lichtwellenleiter-Verstärker - Teil 1-1: Optische Leistungs- und
Verstärkungsparameter - Verfahren mit optischem Spektralanalysator (IEC 61290-1-
1:2015)
Amplificateurs optiques - Méthodes d'essai - Partie 1-1: Paramètres de puissance et de
gain - Méthode de l'analyseur de spectre optique (IEC 61290-1-1:2015)
Ta slovenski standard je istoveten z: EN 61290-1-1:2015
ICS:
33.180.30 2SWLþQLRMDþHYDOQLNL Optic amplifiers
SIST EN 61290-1-1:2015 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 61290-1-1:2015

---------------------- Page: 2 ----------------------

SIST EN 61290-1-1:2015


EUROPEAN STANDARD EN 61290-1-1

NORME EUROPÉENNE

EUROPÄISCHE NORM
July 2015
ICS 33.180.30 Supersedes EN 61290-1-1:2006
English Version
Optical amplifiers - Test methods - Part 1-1: Power and gain
parameters - Optical spectrum analyzer method
(IEC 61290-1-1:2015)
Amplificateurs optiques - Méthodes d'essai -  Prüfverfahren für Lichtwellenleiter-Verstärker -
Partie 1-1: Paramètres de puissance et de gain - Méthode Teil 1-1: Optische Leistungs- und Verstärkungsparameter -
de l'analyseur de spectre optique Verfahren mit optischem Spektralanalysator
(IEC 61290-1-1:2015) (IEC 61290-1-1:2015)
This European Standard was approved by CENELEC on 2015-06-11. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.


European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2015 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
 Ref. No. EN 61290-1-1:2015 E

---------------------- Page: 3 ----------------------

SIST EN 61290-1-1:2015
EN 61290-1-1:2015
European foreword
The text of document 86C/1309/FDIS, future edition 3 of IEC 61290-1-1, prepared by SC 86C "Fibre
optic systems and active devices" of IEC/TC 86 "Fibre optics" was submitted to the IEC-CENELEC
parallel vote and approved by CENELEC as EN 61290-1-1:2015.
The following dates are fixed:
(dop) 2016-03-11
• latest date by which the document has to be implemented at
national level by publication of an identical national
standard or by endorsement
(dow) 2018-06-11
• latest date by which the national standards conflicting with
the document have to be withdrawn

This document supersedes EN 61290-1-1:2006 and constitutes a technical revision.
EN 61290-1-1:2015 includes the following significant technical changes with respect to the previous
edition:
a) updates on the characteristics of measurement apparatus;
b) revised list of addressed optical amplifier parameters.
EN 61290-1-1:2015 shall be used in conjunction with EN 61290-1 and EN 61291-1.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such
patent rights.
Endorsement notice
The text of the International Standard IEC 61290-1-1:2015 was approved by CENELEC as a
European Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards indicated:
IEC 61290-10 NOTE Harmonized in EN 61290-10 series (not modified).
IEC 60793-2-50 NOTE Harmonized as EN 60793-2-50.
2

--------------------
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.