Electromagnetic compatibility and Radio spectrum Matters (ERM); Radio telephone transmitters and receivers for the maritime mobile service operating in the VHF bands used on inland waterways; Part 1: Technical characteristics and methods of measurement

To update references. References to Appendix 18 of the Radio Regulations should refer to the Radio regulations dated 2001 and consequential changes.

Elektromagnetna združljivost in zadeve v zvezi z radijskim spektrom (ERM) – Radiotelefonski oddajniki in sprejemniki za pomorsko mobilno storitev, uporabljeno na celinskih vodnih poteh, ki delujejo v pasovih VHF – 1. del: Tehnične karakteristike in merilne metode

General Information

Status
Published
Publication Date
30-Nov-2003
Current Stage
6060 - National Implementation/Publication (Adopted Project)
Start Date
01-Dec-2003
Due Date
01-Dec-2003
Completion Date
01-Dec-2003

Buy Standard

Standard
EN 300 698-1 V1.3.1:2003
English language
49 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.LWHYElectromagnetic compatibility and Radio spectrum Matters (ERM); Radio telephone transmitters and receivers for the maritime mobile service operating in the VHF bands used on inland waterways; Part 1: Technical characteristics and methods of measurement47.020.70Navigacijska in krmilna opremaNavigation and control equipment33.100.01Elektromagnetna združljivost na splošnoElectromagnetic compatibility in general33.060.20Sprejemna in oddajna opremaReceiving and transmitting equipmentICS:Ta slovenski standard je istoveten z:EN 300 698-1 Version 1.3.1SIST EN 300 698-1 V1.3.1:2003en01-december-2003SIST EN 300 698-1 V1.3.1:2003SLOVENSKI
STANDARD



SIST EN 300 698-1 V1.3.1:2003



ETSI EN 300 698-1 V1.3.1 (2003-12)European Standard (Telecommunications series) Electromagnetic compatibilityand Radio spectrum Matters (ERM);Radio telephone transmitters and receiversfor the maritime mobile service operatingin the VHF bands used on inland waterways;Part 1: Technical characteristics andmethods of measurement
SIST EN 300 698-1 V1.3.1:2003



ETSI ETSI EN 300 698-1 V1.3.1 (2003-12) 2
Reference REN/ERM-TG26-063-1 Keywords maritime, radio, VHF ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00
Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88
Important notice Individual copies of the present document can be downloaded from: http://www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://portal.etsi.org/tb/status/status.asp If you find errors in the present document, send your comment to: editor@etsi.org Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2003. All rights reserved.
DECTTM, PLUGTESTSTM and UMTSTM are Trade Marks of ETSI registered for the benefit of its Members. TIPHONTM and the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. SIST EN 300 698-1 V1.3.1:2003



ETSI ETSI EN 300 698-1 V1.3.1 (2003-12) 3
Contents Intellectual Property Rights.7 Foreword.7 Introduction.7 1 Scope.8 2 References.8 3 Definitions and abbreviations.9 3.1 Definitions.9 3.2 Abbreviations.9 4 General requirements.9 4.1 Construction.9 4.2 Controls and indicators.10 4.3 Handset and loudspeaker.10 4.4 Switching time.10 4.5 Safety precautions.11 4.6 Class of emission and modulation characteristics.11 4.7 Facilities for DSC transmission and reception.11 4.8 Labelling.11 4.9 Warm up.12 5 Test conditions, power sources and ambient temperatures.12 5.1 Normal and extreme test conditions.12 5.2 Test power source.12 5.3 Normal test conditions.12 5.3.1 Normal temperature and humidity.12 5.3.2 Normal power sources.12 5.3.2.1 Mains voltage and frequency.12 5.3.2.2 Battery power source.12 5.3.2.3 Other power sources.12 5.4 Extreme test conditions.13 5.4.1 Extreme temperatures.13 5.4.2 Extreme values of test power sources.13 5.4.2.1 Mains voltage.13 5.4.2.2 Battery power source.13 5.4.2.3 Other power sources.13 5.5 Procedure for tests at extreme temperatures.13 6 General conditions of measurement.14 6.1 Arrangements for test signals applied to the receiver.14 6.2 Squelch.14 6.3 Normal test modulation.14 6.4 Artificial antenna.14 6.5 Arrangements for test signals applied to the transmitter.14 6.6 Tests on equipment with a duplex filter.14 6.7 Test channels.14 6.8 Measurement uncertainty and interpretation of the measured results.15 6.8.1 Measurement uncertainty.15 6.8.2 Interpretation of the measurement results.15 7 Environmental tests.15 7.1 Introduction.15 7.2 Procedure.16 7.3 Performance check.16 7.4 Vibration.16 7.5 Damp heat cycle.17 SIST EN 300 698-1 V1.3.1:2003



ETSI ETSI EN 300 698-1 V1.3.1 (2003-12) 4
8 Transmitter.17 8.1 Frequency error.17 8.1.1 Definition.17 8.1.2 Method of measurement.17 8.1.3 Limits.17 8.2 Carrier power.17 8.2.1 Definitions.17 8.2.2 Method of measurement.17 8.2.3 Limits.18 8.2.3.1 Normal test conditions.18 8.2.3.2 Extreme test conditions.18 8.3 Frequency deviation.18 8.3.1 Definition.18 8.3.2 The maximum frequency deviation at modulation frequencies below 3 kHz.18 8.3.2.1 Method of measurement.18 8.3.2.2 Limits.18 8.3.3 The maximum frequency deviation at modulation frequencies above 3 kHz.18 8.3.3.1 Method of measurement.18 8.3.3.2 Limits.19 8.4 Limitation characteristics of the modulator.19 8.4.1 Definition.19 8.4.2 Method of measurement.19 8.4.3 Limits.19 8.5 Sensitivity of the modulator, including microphone.20 8.5.1 Definition.20 8.5.2 Method of measurement.20 8.5.3 Limits.20 8.6 Audio frequency response.20 8.6.1 Definition.20 8.6.2 Method of measurement.20 8.6.3 Limit.20 8.7 Audio frequency harmonic distortion of the emission.21 8.7.1 Definition.21 8.7.2 Method of measurement.21 8.7.2.1 Normal test conditions.22 8.7.2.2 Extreme test conditions.22 8.7.3 Limit.22 8.8 Adjacent channel power.22 8.8.1 Definition.22 8.8.2 Method of measurement.22 8.8.3 Limits.22 8.9 Conducted spurious emissions conveyed to the antenna.23 8.9.1 Definition.23 8.9.2 Method of measurement.23 8.9.3 Limit.23 8.10 Residual modulation of the transmitter.23 8.10.1 Definition.23 8.10.2 Method of measurement.23 8.10.3 Limit.23 8.11 Transient frequency behaviour of the transmitter.23 8.11.1 Definitions.23 8.11.2 Method of measurement.24 8.11.3 Limits.25 8.12 Cabinet radiation and conducted spurious emissions other than those conveyed to the antenna.27 8.12.1 Definitions.27 8.12.2 Method of measurement.27 8.12.3 Limits.28 9 Receiver.28 9.1 Harmonic distortion and rated audio frequency output power.28 9.1.1 Definition.28 9.1.2 Method of measurement.28 SIST EN 300 698-1 V1.3.1:2003



ETSI ETSI EN 300 698-1 V1.3.1 (2003-12) 5
9.1.3 Limits.29 9.2 Audio frequency response.29 9.2.1 Definition.29 9.2.2 Method of measurement.29 9.2.3 Limits.30 9.3 Maximum usable sensitivity.30 9.3.1 Definition.30 9.3.2 Method of measurement.31 9.3.3 Limits.31 9.4 Co-channel rejection.31 9.4.1 Definition.31 9.4.2 Method of measurement.31 9.4.3 Limit.31 9.5 Adjacent channel selectivity.31 9.5.1 Definition.31 9.5.2 Method of measurement.32 9.5.3 Limits.32 9.6 Spurious response rejection.32 9.6.1 Definition.32 9.6.2 Method of measurement.32 9.6.3 Limit.32 9.7 Intermodulation response.33 9.7.1 Definition.33 9.7.2 Method of measurement.33 9.7.3 Limit.33 9.8 Blocking or desensitization.33 9.8.1 Definition.33 9.8.2 Method of measurement.33 9.8.3 Limit.34 9.9 Conducted spurious emissions conveyed to the antenna.34 9.9.1 Definition.34 9.9.2 Method of measurement.34 9.9.3 Limit.34 9.10 Amplitude response of the receiver limiter.34 9.10.1 Definition.34 9.10.2 Method of measurement.34 9.10.3 Limit.34 9.11 Receiver noise and hum level.34 9.11.1 Definition.34 9.11.2 Method of measurement.35 9.11.3 Limit.35 9.12 Squelch operation.35 9.12.1 Definition.35 9.12.2 Method of measurement.35 9.12.3 Limits.35 9.13 Squelch hysteresis.36 9.13.1 Definition.36 9.13.2 Method of measurement.36 9.13.3 Limit.36 9.14 Radiated spurious emissions.36 9.14.1 Definition.36 9.14.2 Method of measurements.36 9.14.3 Limit.37 10 Duplex operation.37 10.1 Receiver desensitization with simultaneous transmission and reception.37 10.1.1 Definition.37 10.1.2 Method of measurement.
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.