SIST EN ISO 6647-2:2020

Rice - Determination of amylose content - Part 2: Spectrophotometric routine method without defatting procedure and with calibration from rice standards (ISO 6647-2:2020)

This document specifies two simplified routine methods for the determination of the amylose mass
fraction of milled rice, non-parboiled. The main difference between the two methods is the dispersion
procedure: method A specifies hot dispersion, and method B specifies cold dispersion.
Both methods are applicable to rice with an amylose mass fraction higher than 5 %.
NOTE These methods describe simplified procedures for the preparation of samples, which are frequently
used in routine laboratories. The methods use the same reagents as the reference method (see ISO 6647-1), but
omit the defatting step. Rice samples where the amylose mass fraction has been determined by the reference
method are used as standards.

Reis - Bestimmung des Amylosegehalts - Teil 2: Routinemethode: Spektrophotometrische Routinemethode ohne Entfettungsverfahren und mit Kalibrierung nach Reisstandards (ISO 6647-2:2020)

Dieses Dokument legt zwei vereinfachte Routineverfahren zur Bestimmung des Amylose-Massenanteils von gemahlenem nicht-angekochten Reis fest. Der Hauptunterschied zwischen den beiden Verfahren besteht in der Vorgehensweise bei der Dispergierung: Verfahren A legt die Heiß-Dispergierung fest und Verfahren B legt die die Kalt-Dispergierung fest.
Beide Verfahren sind anwendbar auf Reis mit einem Amylose-Massenanteil von mehr als 5 %.
ANMERKUNG Diese Verfahren beschreiben vereinfachte Vorgehensweisen für die Herstellung von Proben, die in üblichen Laboratorien häufig genutzt werden. Die Verfahren nutzen als Referenzverfahren (siehe ISO 6647-1) dieselben Reagenzien, lassen jedoch den Schritt der Entfettung aus. Als Standards werden Reisproben genutzt, bei denen Amylose-Massenanteil mit dem Referenzverfahren bestimmt wurde.

Riz - Détermination de la teneur en amylose - Partie 2: Méthode spectrophotométrique de routine sans mode opératoire de dégraissage et avec étalonnage à l'aide d'étalons de riz (ISO 6647-2:2020)

Le présent document spécifie deux méthodes de routine simplifiées pour la détermination de la fraction massique d'amylose du riz usiné, non étuvé. La principale différence entre les deux méthodes est le mode opératoire de dispersion: la méthode A spécifie une dispersion à chaud et la méthode B spécifie une dispersion à froid.
Les deux méthodes sont applicables au riz avec une fraction massique d'amylose supérieure à 5 %.
NOTE    Ces méthodes décrivent des modes opératoires simplifiés pour la préparation d'échantillons, qui sont fréquemment utilisés en routine par les laboratoires. Les méthodes utilisent les mêmes réactifs que la méthode de référence (voir l'ISO 6647-1), mais omettent l'étape de dégraissage. Les échantillons de riz pour lesquels la fraction massique d'amylose a été déterminée par la méthode de référence sont utilisés comme étalons.

Riž - Določevanje amiloze - 2. del: Spektrofotometrijska rutinska metoda brez postopka razmaščevanja in s kalibracijo v skladu s standardi za riž (ISO 6647-2:2020)

General Information

• Status: Published
• Public Enquiry End Date: 19-Dec-2019
• Publication Date: 10-Sep-2020
• ICS: 67.060 - Cereals, pulses and derived products
• Technical Committee: KŽP - Agricultural food products
• Current Stage: 6060 - National Implementation/Publication (Adopted Project)
• Start Date: 25-Aug-2020
• Due Date: 30-Oct-2020
• Completion Date: 11-Sep-2020
• Ref Project: EN ISO 6647-2:2020 - Rice - Determination of amylose content - Part 2: Spectrophotometric routine method without defatting procedure and with calibration from rice standards (ISO 6647-2:2020)

Relations

• Replaces: SIST EN ISO 6647-2:2015 - Rice - Determination of amylose content - Part 2: Routine methods (ISO 6647-2:2015)
• Effective Date: 01-Oct-2020

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 6647-2:2020
01-oktober-2020
Nadomešča:
SIST EN ISO 6647-2:2015
Riž - Določevanje amiloze - 2. del: Spektrofotometrijska rutinska metoda brez
postopka razmaščevanja in s kalibracijo v skladu s standardi za riž (ISO 6647-
2:2020)
Rice - Determination of amylose content - Part 2: Spectrophotometric routine method
without defatting procedure and with calibration from rice standards (ISO 6647-2:2020)
Reis - Bestimmung des Amylosegehalts - Teil 2: Routinemethode:
Spektrophotometrische Routinemethode ohne Entfettungsverfahren und mit Kalibrierung
nach Reisstandards (ISO 6647-2:2020)
Riz - Détermination de la teneur en amylose - Partie 2: Méthode spectrophotométrique
de routine sans mode opératoire de dégraissage et avec étalonnage à l'aide d'étalons de
riz (ISO 6647-2:2020)
Ta slovenski standard je istoveten z: EN ISO 6647-2:2020
ICS:
67.060 Žita, stročnice in proizvodi iz Cereals, pulses and derived
njih products
SIST EN ISO 6647-2:2020 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN ISO 6647-2:2020

---------------------- Page: 2 ----------------------
SIST EN ISO 6647-2:2020


EN ISO 6647-2
EUROPEAN STANDARD

NORME EUROPÉENNE

August 2020
EUROPÄISCHE NORM
ICS 67.060 Supersedes EN ISO 6647-2:2015
English Version

Rice - Determination of amylose content - Part 2:
Spectrophotometric routine method without defatting
procedure and with calibration from rice standards (ISO
6647-2:2020)
Riz - Détermination de la teneur en amylose - Partie 2: Reis - Bestimmung des Amylosegehalts - Teil 2:
Méthode spectrophotométrique de routine sans mode Routinemethode: Spektrophotometrische
opératoire de dégraissage et avec étalonnage à l'aide Routinemethode ohne Entfettungsverfahren und mit
d'étalons de riz (ISO 6647-2:2020) Kalibrierung nach Reisstandards (ISO 6647-2:2020)
This European Standard was approved by CEN on 18 July 2020.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2020 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 6647-2:2020 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
SIST EN ISO 6647-2:2020
EN ISO 6647-2:2020 (E)
Contents Page
European foreword . 3

2

---------------------- Page: 4 ----------------------
SIST EN ISO 6647-2:2020
EN ISO 6647-2:2020 (E)
European foreword
This document (EN ISO 6647-2:2020) has been prepared by Technical Committee ISO/TC 34 "Food
products" in collaboration with Technical Committee CEN/TC 338 “Cereal and cereal products” the
secretariat of which is held by AFNOR.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by February 2021, and conflicting national standards
shall be withdrawn at the latest by February 2021.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 6647-2:2015.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republ
...