Cycles - Cycle trailers - Safety requirements and test methods

This European standard specifies safety requirements and test methods for two track cycle trailers (i.e. with one or two wheels) and their connecting devices. These cycle trailers are intended for the conveyance of cargo loads or up to two passive child passengers (i.e. not pedalling), both of whom are capable of sitting unaided and neither of whom weighs more than 22 kg. The maximum permitted weight of such a cycle trailer, including cargo and/or passenger(s), does not exceed 60 kg. This standard is not applicable to trailer cycles (one or two-track trailer for the transportation of one or two pedalling passengers, usually children, with device for connection behind cycle) and for type L trailers for professional use or with a single wheel (single track trailer) according to Table 1.

Fahrräder - Fahrradanhänger - Sicherheitstechnische Anforderungen und Prüfverfahren

Diese Europäische Norm legt sicherheitstechnische Anforderungen und die entsprechenden Prüfverfahren für zweispurige Fahrradanhänger (das heißt mit einem oder zwei Rädern) und deren Verbindungseinrichtungen fest.
Diese Fahrradanhänger sind für die Beförderung von Nutzlasten oder von bis zu 2 Kindern als passiv beförderte Personen bestimmt (das heißt nicht tretend), von denen beide ohne fremde Hilfe sitzen können und keines mehr als 22 kg wiegt.
Das zulässige Höchstgewicht eines solchen Fahrradanhängers, einschließlich der Last und/oder der beförderten Person(en), liegt bei 60 kg.
Diese Norm gilt nicht für Anhängerfahrräder (ein- oder zweispuriger Fahrradanhänger für die Beförderung von ein oder zwei tretenden Personen, üblicherweise Kinder, mit einer Vorrichtung zur Anbringung hinter einem Fahrrad) und für Typ-L-Anhänger für den beruflichen Gebrauch oder mit einem einzelnen Rad (einrädriger Anhänger) entsprechend Tabelle 1.

Cycles - Remorques pour cycles - Exigences de sécurité et méthodes d'essai

La présente Norme européenne spécifie des exigences de sécurité et des méthodes d'essai pour les remorques pour cycle à deux voies (c'est-à-dire à une ou deux roues) et leurs dispositifs d'attelage.
Ces remorques pour cycle sont destinées au transport de charges ou jusqu'à deux enfants passifs (ne pédalant pas) capables de se tenir assis sans aide dont aucun ne pèse plus de 22 kg.
La masse maximale autorisée d'une telle remorque pour cycle, charge et/ou passager(s) compris, ne dépasse pas 60 kg.
La présente norme n'est pas applicable aux vélos remorqués (remorque à une ou deux voies avec dispositif d'attelage derrière un cycle pour le transport d'un ou deux passagers pédalant, habituellement des enfants) ni aux remorques de type L pour usage professionnel ou à une seule roue (remorque à une seule voie) conformément au Tableau 1.

Kolesa - Prikolice za kolesa - Varnostne zahteve in preskusne metode

General Information

Status
Not Published
Public Enquiry End Date
29-Oct-2014
Technical Committee
Current Stage
5020 - Formal vote (FV) (Adopted Project)
Start Date
22-Nov-2016
Due Date
10-Jan-2017
Completion Date
22-Nov-2016

Relations

Buy Standard

Amendment
EN 15918:2011+A1:2013/kprA2:2014
English language
9 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 15918:2011+A1:2013/kprA2:2014
01-oktober-2014
Kolesa - Prikolice za kolesa - Varnostne zahteve in preskusne metode
Cycles - Cycle trailers - Safety requirements and test methods
Fahrräder - Fahrradanhänger - Sicherheitstechnische Anforderungen und Prüfverfahren
Cycles - Remorques pour cycles - Exigences de sécurité et méthodes d'essai
Ta slovenski standard je istoveten z: EN 15918:2011+A1:2013/prA2
ICS:
43.150 Kolesa Cycles
SIST EN en,fr,de
15918:2011+A1:2013/kprA2:2014
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 15918:2011+A1:2013/kprA2:2014

---------------------- Page: 2 ----------------------

SIST EN 15918:2011+A1:2013/kprA2:2014

EUROPEAN STANDARD
DRAFT
EN 15918:2011+A1:2013
NORME EUROPÉENNE

EUROPÄISCHE NORM
prA2
July 2014
ICS 43.150
English Version
Cycles - Cycle trailers - Safety requirements and test methods
Cycles - Remorques pour cycles - Exigences de sécurité et Fahrräder - Fahrradanhänger - Sicherheitstechnische
méthodes d'essai Anforderungen und Prüfverfahren
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 333.

This draft amendment A2, if approved, will modify the European Standard EN 15918:2011+A1:2013. If this draft becomes an amendment,
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration.

This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has
the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2014 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 15918:2011+A1:2013/prA2:2014 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 15918:2011+A1:2013/kprA2:2014
EN 15918:2011+A1:2013/prA2:2014 (E)
Contents
Page
Foreword .3
1 Modification to clause 4.4 "Tolerances" .4
2 Modification to 6.3 "Deflection device" .4
3 Modification to 6.11.2 .4
4 Modification to 6.15.2.3 .5
5 Modification to 6.16.1 .6
6 Modification to 6.16.2 .6
7 Modification to 6.18.2 .6
8 Modification to 6.19.2 .6
9 Modification to clause 8 .7
10 Modification to Annex A .7


2

---------------------- Page: 4 ----------------------

SIST EN 15918:2011+A1:2013/kprA2:2014
EN 15918:2011+A1:2013/prA2:2014 (E)
Foreword
This document (EN 15918:2011+A1:2013/prA2:2014) has been prepared by Technical Committee
CEN/TC 333 “Cycles”, the secretariat of which is held by UNI.
This document is currently submitted to the CEN Enquiry.
3

---------------------- Page: 5 ----------------------

SIST EN 15918:2011+A1:2013/kprA2:2014
EN 15918:2011+A1:2013/prA2:2014 (E)
1 Modification to clause 4.4 "Tolerances"
Replace in the Table 2 in the row temperatures the tolerance "± 10 °C" by "± 5 °C".
2 Modification to 6.3 "Deflection device"
Replace Figure 2 by the following:
"

Key
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.