SIST ETS 300 105 E1:2003
(Main)Terminal Equipment (TE); International Videotex interworking
Terminal Equipment (TE); International Videotex interworking
Further handling of T/TE 06-20, 21, 22 after the completion of the public Enquiry and attempt to allign with CCITT Rec. T.101 (1992)
Terminalska oprema (TE) – Mednarodno medsebojno delovanje sistema Videotex
General Information
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Terminalska oprema (TE) – Mednarodno medsebojno delovanje sistema VideotexTerminal Equipment (TE); International Videotex interworking35.180Terminalska in druga periferna oprema ITIT Terminal and other peripheral equipment33.160.99Druga avdio, video in avdiovizuelna opremaOther audio, video and audiovisual equipmentICS:Ta slovenski standard je istoveten z:ETS 300 105 Edition 1SIST ETS 300 105 E1:2003en01-december-2003SIST ETS 300 105 E1:2003SLOVENSKI
STANDARD
SIST ETS 300 105 E1:2003
EUROPEANETS 300 105TELECOMMUNICATIONDecember 1991STANDARDSource: TE1Reference: TE-01020ICS:33.020Key words:TE; VideotexTerminal Equipment (TE);International Videotex InterworkingETSIEuropean Telecommunications Standards InstituteETSI SecretariatPostal address: F-06921 Sophia Antipolis CEDEX - FRANCEOffice address: 650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCEX.400: c=fr, a=atlas, p=etsi, s=secretariat - Internet: secretariat@etsi.frTel.: +33 92 94 42 00 - Fax: +33 93 65 47 16Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and theforegoing restriction extend to reproduction in all media.© European Telecommunications Standards Institute 1991. All rights reserved.SIST ETS 300 105 E1:2003
Page 2ETS 300 105: December 1991Whilst every care has been taken in the preparation and publication of this document, errors in content,typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to"ETSI Editing and Committee Support Dept." at the address shown on the title page.SIST ETS 300 105 E1:2003
Page 3ETS 300 105: December 1991ContentsForeword.51Scope.72Normative references.73Abbreviations.94Interworking between Videotex services.104.1General.105International interworking of Videotex services.105.1International interworking configurations.105.1.1Gateway to gateway interworking.105.1.2Terminal to host interworking.106International interworking between gateways.106.1International interworking at network level.116.2Transport layer.116.3Session layer.116.4Presentation layer.126.4.1Presentation protocol.126.4.2Coding of Videotex information.126.5Application layer.126.6Relationship with Document Architecture Transfer And Manipulation (DATAM).127International interworking between a terminal and a host.127.1Access via PSTN or ISDN bearer service.137.2Access via PSPDN or ISDN bearer service.137.3Access via PSPDN/PAD.147.4Access via PSPDN through a Videotex Interface Unit (VIU) (2).147.5Access via PSPDN through a Videotex Service Unit (VSU).15History.16SIST ETS 300 105 E1:2003
Page 4ETS 300 105: December 1991Blank pageSIST ETS 300 105 E1:2003
Page 5ETS 300 105: December 1991ForewordThis European Telecommunication Standard (ETS) has been prepared by the Terminal Equipment (TE)Technical Committee of the European Telecommunications Standards Institute (ETSI).This ETS has been produced in the light of:a)Videotex services being implemented in different countries using different data syntax profiles (asdescribed in ETS 300 072 [32]);b)the International Radio Consultative Committee (CCIR) expressing the view that terminal equipmentcompatibility should exist between broadcast Teletext 1)
systems for general reception and publicnetwork-based database systems;c)the right of different countries to use their existing systems;d)the possible requirement for transcoding and/or conversion to permit interworking between Videotexservices in different countries;e)interworking between Videotex services may be provided by using different types of networks suchas the Public Switched Telephone Network (PSTN), Packet Switched Public Data Network(PSPDN), Circuit Switched Public Data Network (CSPDN), Integrated Services Digital Network(ISDN), etc;f)the need for Videotex interworking protocols to offer a large degree of compatibility with thoseprotocols used in other telematic services.This ETS provides a number of technical provisions to enable the interworking of different Videotexservices at the international level, identifies the parameters required to communicate with Videotexterminals and certain technical recommendations for the potential interworking of other telematic serviceswith Videotex services.This ETS is also closely related , and normatively references, to three other ETSs (ETSs 300 072 [32],300 106 [33] and 300 107 [34]). Full details are given in Clause 2 (Normative references) of this Standard.
1)The term "Teletex" has not yet been definitively adopted by the CCIR.SIST ETS 300 105 E1:2003
Page 6ETS 300 105: December 1991Blank pageSIST ETS 300 105 E1:2003
Page 7ETS 300 105: December 19911ScopeThis ETS describes the characteristics of coded information that is exchanged between countriesparticipating in the international interactive Videotex service.Videotex systems are text communication systems having, in addition, the capability of a given level ofpictorial representation and a repertoire of display attributes. The text and pictures obtained are intendedto be displayed using the current television (TV) raster standards of the different countries.Different data syntax profiles are offered as a choice for the service providers to implement their services.Substantial degrees of compatibility exist between these options, but some transcoding and/or conversionmay be necessary to facilitate interworking.For the purpose of the international service, different data syntax profiles have been identified in ETS 300072 [32]:a)Profile 1;b)Profile 2;c)Profile 3;d)Profile 4;e)"ASCII";f)other data syntaxes are for further study.NOTE 1:"ASCII" uses the International Reference Version of the character set of the CCITTRecommendation T.50 and additional control functions for characters specified in ISOstandard 6429.NOTE 2:The use of this non-videotex data syntax is provisional and is pending the result of thework undertaken in the ETSI TE1/VT group as well as in CCITT.2Normative referencesThis ETS incorporates by dated or undated reference, provisions from other publications. Thesenormative references are cited at the appropriate places in the text and the publications are listedhereafter. For dated references, subsequent amendments to, or revisions of any of these publicationsapply to this ETS only when incorporated in it by amendment or revision. For undated references the latestedition of the publication referred to applies.[1]CCITT Recommendation X.3 (1988): "Packet assembly disassembly facility(PAD) in a public data network".[2]CCITT Recommendation X.25 (1988): "Interface between Data TerminalEquipment (DTE) and Data Circuit-terminating Equipment (DCE) for terminalsoperating in the packet mode and connected to Public Data Networks bydedicated circuit".[3]CCITT Recommendation X.28 (1988): "DTE/DCE interface for a start-stopmode data terminal equipment accessing the packet assembly/disassemblyfacility (PAD) in a public data network situated in the same country".[4]CCITT Recommendation X.29 (1988): "Procedures for the exchange of controlinformation and user data between a packet assembly/disassembly (PAD)facility and a packet mode DTE or another PAD".[5]CCITT Recommendation X.75 (1988): "Packet-switched signalling systembetween public networks providing data transmission services".SIST ETS 300 105 E1:2003
Page 8ETS 300 105: December 1991[6]CCITT Recommendation X.200 (1988): "Reference model of open systemsinterconnection for CCITT applications".[7]CCITT Recommendation X.213 (1988): "Network service definition for opensystems interconnection for CCITT applications".[8]CCITT Recommendation X.214 (1988): "Transport service definition for opensystems interconnection for CCITT applications".[9]CCITT Recommendation X.224 (1988): "Transport protocol specification foropen systems interconnection for CCITT applications".[10]CCITT Recommendation X.215 (1988): "Session service definition for opensystems interconnection for CCITT applications".[11]CCITT Recommendation X.225 (1988): "Session protocol specification for opensystems interconnection for CCITT applications".[12]CCITT Recommendation X.216 (1988): "Presentation service definition for opensystems interconnection for CCITT applications".[13]CCITT Recommendation X.226 (1988): "Presentation protocol specification foropen systems interconnection for CCITT applications".[14]CCITT Recommendation X.217 (1988): "Association control service elementservice definition for open systems interconnection for CCITT applications".[15]CCITT Recommendation X.227 (1988): "Association control service elementprotocol specification for open systems interconnection for CCITT applications".[16]CCITT Recommendation T.90 (1988): "Characteristics and protocols forterminal for telematics services in ISDN".[17]CCITT Recommendation T.101 (1988): "International interworking for Videotexservices".[18]CCITT Recommendation T.400 (1988): "Introduction to document transfer,architecture and manipulation".[19]CCITT Recommendation T.411 (1988): "Open document architecture (ODA)and interchange format - Introduction and general principles".[20]CCITT Recommendation T.412 (1988): "Open document architecture (ODA)and interchange format - Document structures".[21]CCITT Recommendation T.414 (1988): "Open document architecture (ODA)and interchange format -Document profile".[22]CCITT Recommendation T.415 (1988): "Open document architecture (ODA)and interchange format - Open document interchange format (ODIF)".[23]CCITT Recommendation T.431 (1988): "Document transfer and manipulation(DTAM) - Introduction and general principles".[24]CCITT Recommendation T.432 (1988): "Document transfer and manipulation(DTAM) - Service definitions".[25]CCITT Recommendation T.433 (1988): "Document transfer and manipulation(DTAM) - Protocol specifications".[26]CCITT Recommendation T.441 (1988): "Document transfer and manipulation(DTAM) - Operational structure".SIST ETS 300 105 E1:2003
Page 9ETS 300 105: December 1991[27]CCITT Recommendation T.504 (1988): "Document application profile forvideotex interworking".[28]CCITT Recommendation T.523 (1988): "Communication application profile DM-1 for videotex interworking".[29]CCITT Recommendation T.541 (1988): "Operational application profile forvideotex interworking".[30]CCITT Recommendation T.564 (1988): "Gateway characteristics for videotexinterworking".[31]CEPT Recommendation T/SF-59: "Videotex Service".[32]ETS 300 072: "Terminal Equipment (TE); Videotex presentation layer protocol ;Videotex presentation layer data syntax".[33]ETS 300 106: "Terminal Equipment (TE) ; International Videotex interworkingbetween a terminal and a host".[34]ETS 300 107: "Terminal Equipment (TE) ; International Videotex interworkingbetween gateways".[35]CCITT Recommendation T.70 (1988): "Network independent basic transportservice for the telematic services".3AbbreviationsThe following abbreviations apply:ACSEAssociation Control Service ElementCCITTInternational Telegraph and Telephone Consultative CommitteeCCIRInternational Radiocommunication Consultative CommitteeCEPTConférence Européenne des Postes et TélécommunicationsCSPDNCircuit Switched Public Data NetworkDATAMDocument Architecture Transfer And ManipulationDTAMDocument Transfer And ManipulationETSEuropean Telecommun
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.