SIST EN 61755-3-6:2007

Fibre optic connector optical interfaces -- Part 3-6: Optical interface - 2,5 mm and 1,25 mm diameter cylindrical 8 degrees angled-PC composite ferrule using Cu-Ni-alloy as fibre surrounding material, single mode fibre

This part of IEC 61755 defines dimensional limits and material properties of a 2,5 mm and a 1,25 mm diameter cylindrical composite ferrule optical interface to meet specific requirements for APC fibre-to-fibre interconnection. The composite ferrule uses different materials in the end face contact zone and in the ferrule to sleeve contact zone. The specified materials for each zone are Zirconia (ZrO2) for the ferrule to sleeve contact zone and Cu-Ni-alloy for the end face contact zone. Ferrules made from the material specified in this document are suitable for use in categories C, U and O as defined in IEC 61753-1.

Optische Schnittstellen von Lichtwellenleiter-Steckverbindern -- Teil 3-6: Optische Schnittstelle - Zylindrische, 8 Grad angeschrägte PC-Ferrulen mit 2,5 mm und 1,25 mm Durchmesser für Einmodenfaser, mit Cu-Ni-Legierung als Material für die Faserfassung

Interfaces optiques de connecteurs pour fibres optiques -- Partie 3-6: Interfaces optiques - Férules composites cylindriques PC-orientées 8 degrés de diamètre 2,5 mm et 1,25 mm, utilisant un alliage Cu-Ni comme matériau entourant la fibre, fibres unimodales

La présente partie de la CEI 61755 définit les dimensions limites et les propriétés du matériau de l'interface optique d'une férule composite cylindrique, de diamètre 2,5 mm et 1,25 mm, afin de satisfaire aux exigences spécifiques des interconnexions fibre-à-fibre APC.

Optični vmesniki za optične konektorje – 3-6. del: Optični vmesnik – Cilindrične polikarbonatne kompozitne tulke s premerom 2,5 mm in 1,25 mm, s kotom 8 stopinj, ki uporabljajo zlitino Cu-Ni za obod vlakna, enorodno vlakno (IEC 61755-3-5:2006)

Ta del standarda IEC 61755 določa dimenzijske omejitve in materialne lastnosti optičnega vmesnika s cilindrično kompozitno tulko s premerom 2,5 mm in 1,25 mm za izpolnjevanje posebnih zahtev za medsebojno povezovanje vlaken APC. Kompozitna tulka ima na območju stika na končnem delu ter na območju stika tulke z obojko različne materiale. Materiali za posamezno območje so cirkonij (ZrO2) za območje stika tulke z obojko ter zlitina Cu-Ni za območje stika na končnem delu. Tulke, izdelane iz materialov, ki so določeni v tem dokumentu, so primerne za uporabo v kategorijah C, U in O, kot je določeno v standardu IEC 61753-1.

General Information

• Status: Published
• Publication Date: 16-Jul-2007
• ICS: 33.180.20 - Fibre optic interconnecting devices
• Technical Committee: iTEL - Communication cables
• Current Stage: 6060 - National Implementation/Publication (Adopted Project)
• Start Date: 21-May-2007
• Due Date: 26-Jul-2007
• Completion Date: 30-May-2007
• Ref Project: EN 61755-3-6:2006 - Fibre optic connector optical interfaces - Part 3-6: Optical interface - 2,5 mm and 1,25 mm diameter cylindrical 8 degrees angled-PC composite ferrule using Cu-Ni-alloy as fibre surrounding material, single mode fibre

Relations

• Amended By: SIST EN 61755-3-6:2007/A1:2012 - Fibre optic connector optical interfaces - Part 3-6: Optical interface - 2,5 mm and 1,25 mm diameter cylindrical 8 degrees angled-PC composite ferrule using Cu-Ni-alloy as fibre surrounding material, single mode fibre (IEC 61755-3-6:2006/A1:2012)
• Effective Date: 29-Jan-2023
• Amended By: SIST EN 61755-3-6:2007/A1:2012 - Fibre optic connector optical interfaces - Part 3-6: Optical interface - 2,5 mm and 1,25 mm diameter cylindrical 8 degrees angled-PC composite ferrule using Cu-Ni-alloy as fibre surrounding material, single mode fibre (IEC 61755-3-6:2006/A1:2012)
• Effective Date: 01-Jul-2012

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 61755-3-6:2007
01-september-2007
2SWLþQLYPHVQLNL]DRSWLþQHNRQHNWRUMH±GHO2SWLþQLYPHVQLN±&LOLQGULþQH
SROLNDUERQDWQHNRPSR]LWQHWXONHVSUHPHURPPPLQPPVNRWRP
VWRSLQMNLXSRUDEOMDMR]OLWLQR&X1L]DRERGYODNQDHQRURGQRYODNQR,(&

Fibre optic connector optical interfaces -- Part 3-6: Optical interface - 2,5 mm and 1,25
mm diameter cylindrical 8 degrees angled-PC composite ferrule using Cu-Ni-alloy as
fibre surrounding material, single mode fibre (IEC 61755-3-5:2006)
Optische Schnittstellen von Lichtwellenleiter-Steckverbindern -- Teil 3-6: Optische
Schnittstelle - Zylindrische, 8 Grad angeschrägte PC-Ferrulen mit 2,5 mm und 1,25 mm
Durchmesser für Einmodenfaser, mit Cu-Ni-Legierung als Material für die Faserfassung
(IEC 61755-3-5:2006)
Interfaces optiques de connecteurs pour fibres optiques -- Partie 3-6: Interfaces optiques
- Férules composites cylindriques PC-orientées 8 degrés de diametre 2,5 mm et 1,25
mm, utilisant un alliage Cu-Ni comme matériau entourant la fibre, fibres unimodales (IEC
61755-3-5:2006)
Ta slovenski standard je istoveten z: EN 61755-3-6:2006
ICS:
33.180.20 3RYH]RYDOQHQDSUDYH]D Fibre optic interconnecting
RSWLþQDYODNQD devices
SIST EN 61755-3-6:2007 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

EUROPEAN STANDARD
EN 61755-3-6

NORME EUROPÉENNE
December 2006
EUROPÄISCHE NORM

ICS 33.180.20


English version


Fibre optic connector optical interfaces
Part 3-6: Optical interface -
2,5 mm and 1,25 mm diameter cylindrical 8 degrees angled-PC composite
ferrule using Cu-Ni-alloy as fibre surrounding material, single mode fibre
(IEC 61755-3-6:2006)


Interfaces optiques de connecteurs  Optische Schnittstellen
pour fibres optiques von Lichtwellenleiter-Steckverbindern
Partie 3-6: Interfaces optiques - Teil 3-6: Optische Schnittstelle -
Férules composites cylindriques Zylindrische, 8 Grad angeschrägte
PC-orientées 8 degrés de diamètre PC-Ferrulen mit 2,5 mm und 1,25 mm
2,5 mm et 1,25 mm, utilisant un alliage Durchmesser für Einmodenfaser,
Cu-Ni comme matériau entourant la fibre, mit Cu-Ni-Legierung als Material
fibres unimodales für die Faserfassung
(CEI 61755-3-6:2006) (IEC 61755-3-6:2006)



This European Standard was approved by CENELEC on 2006-12-01. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Cyprus, the Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Central Secretariat: rue de Stassart 35, B - 1050 Brussels


© 2006 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61755-3-6:2006 E

---------------------- Page: 2 ----------------------

EN 61755-3-6:2006 - 2 -
Foreword
The text of document 86B/2260/CDV, future edition 1 of IEC 61755-3-6, prepared by SC 86B, Fibre optic
interconnecting devices and passive components, of IEC TC 86, Fibre optics, was submitted to the
IEC-CENELEC Parallel Unique Acceptance Procedure and was approved by CENELEC as
EN 61755-3-6 on 2006-12-01.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2007-09-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2009-12-01
__________
Endorsement notice
The text of the International Standard IEC 61755-3-6:2006 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards indicated:
IEC 61753-1 NOTE Harmonized as EN 61753-1:2001 (not modified).
IEC 61755-3 NOTE Harmonized in EN 61755-3 series (not modified).
__________

---------------------- Page: 3 ----------------------

NORME CEI
INTERNATIONALE
IEC



61755-3-6
INTERNATIONAL


Première édition
STANDARD

First edition

2006-11


Interfaces optiques de connecteurs
pour fibres optiques –
Partie 3-6:
Interfaces optiques –
Férules composites cylindriques PC-orientées
8 degrés de diamètre 2,5 mm et 1,25 mm, utilisant
un alliage Cu-Ni comme matériau entourant la
fibre, fibres unimodales

Fibre optic connector optical interfaces –
Part 3-6:
Optical interface –
2,5 mm and 1,25 mm diameter cylindrical
8 degrees angled-PC composite ferrule using
Cu-Ni-alloy as fibre surrounding material, single
mode fibre
© IEC 2006 Droits de reproduction réservés ⎯ Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in any
utilisée sous quelque forme que ce soit et par aucun procédé, form or by any means, electronic or mechanical, including
électronique ou mécanique, y compris la photocopie et les photocopying and microfilm, without permission in writing from
microfilms, sans l'accord écrit de l'éditeur. the publisher.
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: [phone] Telefax: [phone] E-mail: [e-mail] Web: www.iec.ch
CODE PRIX
K
PRICE CODE
Commission Electrotechnique Internationale
International Electrotechnical Commission
МеждународнаяЭлектротехническаяКомиссия
Pour prix, voir catalogue en vigueur
For price, see current catalogue

---------------------- Page: 4 ----------------------

61755-3-6 © IEC:2006 – 3 –
CONTENTS

FOREWORD.5

1 Scope.9
2 Description .9
3 Interface parameters .11

Annex A (informative) .17

Bibliography.19

Figure 1 – Interface dimensions for APC ferrule.11
Figure 2 – Fibre core location .11
Figure 3 – Interface dimension of the end face contact zone.13

Table 1 – Optical interface parameter values for 2,5 mm diameter APC ferrule .13
Table 2 – Optical interface parameter values for 1,25 mm diameter APC ferrule .15

---------------------- Page: 5 ----------------------

61755-3-6 © IEC:2006 – 5 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
___________

FIBRE OPTIC CONNECTOR OPTICAL INTERFACES −

Part 3-6: Optical interface –
2,5 mm and 1,25 mm diameter cylindrical 8 degrees angled-PC composite
ferrule using Cu-Ni-alloy as fibre surrounding material, single mode fibre


FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an
...