ASTM D5556-95(2001)e1
(Test Method)Standard Test Method for Determination of the Moisture and Other Volatile Matter Contained in Fats and Oils Used in Fat Liquors and Softening Compounds
Standard Test Method for Determination of the Moisture and Other Volatile Matter Contained in Fats and Oils Used in Fat Liquors and Softening Compounds
SCOPE
1.1 This test method covers the determination of moisture and other volatile material under conditions of the test. It is applicable to all fats and oils, including emulsions.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
General Information
Relations
Standards Content (Sample)
NOTICE: This standard has either been superseded and replaced by a new version or withdrawn. Contact ASTM
International (www.astm.org) for the latest information.
e1
Designation:D5556–95 (Reapproved 2001)
Standard Test Method for
Determination of the Moisture and Other Volatile Matter
Contained in Fats and Oils Used in Fat Liquors and
Softening Compounds
This standard is issued under the fixed designation D 5556; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (e) indicates an editorial change since the last revision or reapproval.
e NOTE—3.1 was changed editorially in March 2005.
1. Scope beaker gently, by hand, to avoid spattering that may result from
too rapid ebullition of moisture.
1.1 This test method covers the determination of moisture
4.2 Judge the approach of the end-point by the cessation of
and other volatile material under conditions of the test. It is
the rising bubbles of steam as well as by the absence of foam.
applicable to all fats and oils, including emulsions.
Another good method of judging the end-point is to place a
1.2 The values stated in SI units are to be regarded as the
clean, dry watch glass on top of the beaker. The evolution of
standard.
steam is indicated by condensation on the watch glass. The
1.3 This standard does not purport to address all of the
temperatureofthesampleshallatnotimebeallowedtoexceed
safety concerns, if any, associated with its use. It is the
130°C, except at the end of test.
responsibility of the user of this standard to establish appro-
4.3 When the apparent end-point has been reached, heat the
priate safety and health practices and determine the applica-
sample momentarily to the point of incipient smoking, using
bility of regulatory limitations prior to use.
caution not to overheat, and then cool to room temperature in
2. Significance and Use
a desiccator and weigh.
2.1 This test method is intended for use in the determination
5. Calculation and Report
of the moisture and other volatile matter contained in fats and
5.1 Report the moisture and volatile matter in percent, by
oils used in the softening and stuffing of leather, as well as
weight, employing the calculation:
those used in the manufacture of products for such purpose.
loss in weight 3 100
%moisture and volatile matter 5 (1)
3. Apparatus
weight of sample
3.1 Electric Hot Plate, with ceramic top and uniform heat
5.2 Reference this test method in the test report.
transfer across the surface, chemical and scratch resistant.
3.2 Glass Beakers, 100 to 150 mL, 6. Precision and Bias
3.3 Desiccator, containing an efficient desiccant.
6.1 This test method is adopted from the procedure
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.