EN 3155-016:2019

Aerospace series - Electrical contacts used in elements of connection - Part 016: Contacts, electrical, male, type A, crimp, class S - Product standard

This document specifies the required characteristics, tests and tooling applicable to male electrical contacts, type A, crimp, class S, used in elements of connection according to EN 3155-002.
It shall be used together with EN 3155-001.
The tests as applied in this standard do not permit the full qualification and shall be completed with associated components.

Luft und Raumfahrt - Elektrische Kontakte zur Verwendung in Verbindungselementen - Teil 016: Elektrische Stiftkontakte, Typ A, crimpbar, Klasse S - Produktnorm

Dieses Dokument legt die Anforderungen, Prüfungen und Werkzeuge für elektrische Stiftkontakte, Typ A, crimpbar, Klasse S, zur Verwendung in elektrischen Verbindungselementen nach EN 3155 002 fest.
Sie ist in Verbindung mit EN 3155 001 anzuwenden.
Bei den Prüfungen nach dieser Norm kann eine vollständige Qualifikation nur erlangt werden, wenn sie mit den zugehörigen Bauteilen durchgeführt werden.

Série aérospatiale - Contacts électriques utilisés dans les organes de connexion - Partie 016 : Contacts électriques, mâles, type A, à sertir, classe S - Norme de produit

Le présent document spécifie les caractéristiques requises, les essais et l’outillage applicables aux contacts électriques mâles, de type A, à sertir, de classe S, utilisés dans les organes de connexion suivant l’EN 3155-002.
Il doit être utilisé conjointement avec l’EN 3155-001.
Les essais tels qu’ils sont appliqués dans la présente norme ne permettent pas la qualification complète et doivent être complétés avec des composants associés.

Aeronavtika - Električni kontakti za uporabo v veznih elementih - 016. del: Kontakti, električni, moški, tip A, stisljivi, razred S - Standard za proizvod

Ta dokument določa zahtevane značilnosti, preskuse in orodja za moške električne kontakte tipa A, nagubane, razreda S, ki se uporabljajo v veznih elementih v skladu s standardom EN 3155-002. Uporabljati ga je treba skupaj s standardom EN 3155-001. Preskusi, kot so upoštevani v tem standardu, ne dovoljujejo polne kvalifikacije in jih je treba dokončati s povezanimi komponentami.

General Information

• Status: Published
• Publication Date: 10-Dec-2019
• Withdrawal Date: 29-Jun-2020
• ICS: 49.060 - Aerospace electric equipment and systems
• Technical Committee: ASD-STAN - Aerospace
• Drafting Committee: ASD-STAN/D 2 - Electrical
• Current Stage: 6060 - Definitive text made available (DAV) - Publishing
• Start Date: 11-Dec-2019
• Completion Date: 11-Dec-2019
• Ref Project: SIST EN 3155-016:2020 - Aerospace series - Electrical contacts used in elements of connection - Part 016: Contacts, electrical, male, type A, crimp, class S - Product standard

Relations

• Replaces: EN 3155-016:2006 - Aerospace series - Electrical contacts used in elements of connection - Part 016: Contacts, electrical, male, type A, crimp, class S - Product standard
• Effective Date: 18-Dec-2019
• Revised: FprEN 3155-016 - Aerospace series - Electrical contacts used in elements of connection - Part 016: Contacts, electrical, male, type A, crimp, class S - Product standard
• Effective Date: 02-Aug-2023

Standards Content (Sample)

SLOVENSKI STANDARD
01-februar-2020
Nadomešča:
SIST EN 3155-016:2009
Aeronavtika - Električni kontakti za uporabo v veznih elementih - 016. del:
Kontakti, električni, moški, tip A, stisljivi, razred S - Standard za proizvod
Aerospace series - Electrical contacts used in elements of connection - Part 016:
Contacts, electrical, male, type A, crimp, class S - Product standard
Luft- und Raumfahrt - Elektrische Kontakte zur Verwendung in Verbindungselementen -
Teil 016: Elektrischer Buchsenkontakt, Typ A, crimpbar, Klasse S - Produktnorm
Série aérospatiale - Contacts électriques utilisés dans les organes de connexion - Partie
016 : Contacts électriques, mâles, type A, à sertir, classe S - Norme de produit
Ta slovenski standard je istoveten z: EN 3155-016:2019
ICS:
49.060 Letalska in vesoljska Aerospace electric
električna oprema in sistemi equipment and systems
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EN 3155-016
EUROPEAN STANDARD
NORME EUROPÉENNE
December 2019
EUROPÄISCHE NORM
ICS 49.060 Supersedes EN 3155-016:2006
English Version
Aerospace series - Electrical contacts used in elements of
connection - Part 016: Contacts, electrical, male, type A,
crimp, class S - Product standard
Série aérospatiale - Contacts électriques utilisés dans Luft- und Raumfahrt - Elektrische Kontakte zur
les organes de connexion - Partie 016 : Contacts Verwendung in Verbindungselementen - Teil 016:
électriques, mâles, type A, à sertir, classe S - Norme de Elektrischer Buchsenkontakt, Typ A, crimpbar, Klasse S
produit - Produktnorm
This European Standard was approved by CEN on 26 August 2019.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 3155-016:2019 E
worldwide for CEN national Members.

Contents Page
European foreword . 3
1 Scope . 4
2 Normative references . 4
3 Terms and definitions . 4
4 Required characteristics . 5
5 Designation . 13
6 Marking . 13
7 Technical specification . 13

European foreword
This document (EN 3155-016:2019) has been prepared by the Aerospace and Defence Industries
Association of Europe - Standardization (ASD-STAN).
After enquiries and votes carried out in accordance with the rules of this Association, this Standard has
received the approval of the National Associations and the Official Services of the member countries of
ASD, prior to its presentation to CEN.
This document shall be given the status of a national standard, either by publication of an identical text
or by endorsement, at the latest by June 2020, and conflicting national standards shall be withdrawn at
the latest by June 2020.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN 3155-016:2006.
According to the CEN-CENELEC Internal Regulations, the national standards organisations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia,
Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland,
Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of North
Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United
Kingdom.
1 Scope
This document specifies the required characteristics, tests and tooling applicable to male electrical
contacts, type A, crimp, class S, used in elements of connection according to EN 3155-002.
It shall be used together with EN 3155-001.
The tests as applied in this standard do not permit the full qualification and shall be completed with
associated components.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments) applies.
EN 2083, Aerospace series — Copper or copper alloy conductors for electrical cables — Product standard
EN 2591 (all parts), Aerospace series — Elements of electrical and optical connection — Test methods
EN 3155-001, Aerospace series — Electrical contacts used in elements of connection — Part 001: Technical
specification
EN 3155-002, Aerospace series — Electrical contacts used in elements of connection — Part 002: List and
utilization of contacts
EN 3708-001, Aerospace series — Modular interconnection systems — Terminal junction systems —
Part 001: Technical specification
EN 4008-007, Aerospace series — Elements of electrical and optical connection — Crimping tools and
associated accessories — Part 007: Positioner for crimping tool M22520/2-01 — Product standard
EN 4008-008, Aerospace series — Elements of electrical and optical connection — Crimping tools and
associated accessories — Part 008: Positioner for crimping tool M22520/7-01 — Product standard
EN 4434, Aerospace series — Copper or copper alloy lightweight conductors for electrical cables —
Product standard (Normal and tight tolerances)
1)
SAE-AS22520, Crimping tools, wire termination, general specification for
1)
SAE-AS81969, Installing and removal tools, connector electrical contact, general specification for
3 Terms and definitions
For the purpo
...