prEN 1-1
(Main)Residential liquid fuel burning appliances - Part 1: General requirements and test methods
Residential liquid fuel burning appliances - Part 1: General requirements and test methods
This document is applicable to residential liquid fuel burning appliances intended for space heating.
This document specifies requirements relating to the design, manufacture, construction, safety and performance (efficiency and emission) of appliances fired by liquid fuel (hereafter referred to as "appliance(s)") and provides instructions for them. Furthermore, it also gives provisions for the evaluation of conformity, i.e. initial type testing (ITT) and factory production control (FPC) and marking of these appliances.
This document specifies the test methods for the determination of the smoke number, and CO, NOx, and OGC emission test methods.
This document is not applicable for:
- built-in appliances;
- appliances equipped with an atomizing burner;
- appliances incorporating a boiler or connected to a water system.
Häusliche Feuerstätten für flüssige Brennstoffe - Teil 1: Allgemeine Anforderungen und Prüfverfahren
Dieses Dokument gilt für mit flüssigen Brennstoffen betriebene Haushaltsgeräte, die für die Beheizung von Räumen bestimmt sind.
Dieses Dokument legt Anforderungen an die Auslegung, die Herstellung, den Bau, die Sicherheit und die Leistung (Wirkungsgrad und Emissionen) von mit flüssigen Brennstoffen betriebenen Geräten (nachstehend "Gerät(e)" genannt) fest und enthält Anweisungen für diese Geräte. Darüber hinaus enthält es Bestimmungen für die Bewertung der Konformität, d. h. für die Erstprüfung (ITT) und die werkseigene Produktionskontrolle (WPK) sowie für die Kennzeichnung dieser Geräte.
Dieses Dokument legt die Prüfverfahren für die Bestimmung der Rauchzahl, sowie die Prüfverfahren für CO-, NOx- und OGC-Emissionen fest.
Dieses Dokument ist nicht anwendbar für:
- Einbaugeräte;
- Geräte, die mit einem Zerstäubungsbrenner ausgestattet sind;
- Geräte, die einen Heizkessel enthalten oder an ein Wassersystem angeschlossen sind.
Équipement de chauffage domestique à combustible liquide - Partie 1 : Exigences et méthodes d'essai générales
Grelne naprave na tekoča goriva za stanovanjske stavbe - 1. del: Splošne zahteve in preskusne metode
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
oSIST prEN 1-1:2023
01-september-2023
Grelne naprave na tekoča goriva za stanovanjske stavbe - 1. del: Splošne zahteve
in preskusne metode
Residential liquid fuel burning appliances - Part 1: General requirements and test
methods
Häusliche Feuerstätten für flüssige Brennstoffe - Teil 1: Allgemeine Anforderungen und
Prüfverfahren
Équipement de chauffage domestique à combustible liquide - Partie 1 : Exigences et
méthodes d'essai générales
Ta slovenski standard je istoveten z: prEN 1-1
ICS:
97.100.40 Grelniki na tekoče gorivo Liquid fuel heaters
oSIST prEN 1-1:2023 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 1-1:2023
---------------------- Page: 2 ----------------------
oSIST prEN 1-1:2023
DRAFT
EUROPEAN STANDARD
prEN 1-1
NORME EUROPÉENNE
EUROPÄISCHE NORM
June 2023
ICS 97.100.40 Will supersede EN 1:1998
English Version
Residential liquid fuel burning appliances - Part 1: General
requirements and test methods
Équipement de chauffage domestique à combustible Häusliche Feuerstätten für flüssige Brennstoffe - Teil 1:
liquide - Partie 1 : Exigences et méthodes d'essai Allgemeine Anforderungen und Prüfverfahren
générales
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 46.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 1-1:2023 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 1-1:2023
prEN 1-1:2023 (E)
Contents Page
European foreword . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 6
4 Descriptive features . 9
4.1 Heat output . 9
4.2 Construction and materials . 9
4.3 Combustion chamber . 10
4.4 Filter . 10
4.5 Fuel regulator . 10
4.6 Marking of operating settings . 10
4.7 Safety device .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.