prEN 4709-001

Aerospace series - Unmanned Aircraft Systems - Part 001: Product requirements and verification

This document provides means of compliance with Parts 1 to 6 of Commission delegated (EU) .../... of XXX on making available on the market of unmanned aircraft intended for use in the ‘open’ category and on third-country UAS operators proposed in the Opinion 01/2018.
This includes compliance with product requirements for all UAS authorized to operate in the ‘open’ category (class C0, C1, C2, C3 and C4 UAS) and the electronic identification system.
This document does not cover "Specific" or "Certified" category of UAS.
Compliance with this document assists in complying with CE marking technical requirements and covers, but is not limited to:
I.   Physical and mechanical properties;
II.   Flammability;
III.   Electrical properties;
IV.   Functional Safety.
This European Standard is only applicable for UA with energy sources based on electro-chemical technologies.
Additional hazards that occur from the characteristics of the payload are excluded and are under the responsibility of the manufacturer and operator.

Luft- und Raumfahrt - Unbemannte Luftfahrzeugsysteme - Teil 001: Anforderungen und Prüfverfahren

Série aérospatiale - Aéronefs télépilotés - Partie 001 : Exigences produit et méthodes de vérification

Le présent document fournit les moyens de se conformer aux Parties 1 à 6 de/du ... de la
Commission (UE) .../... du XXX sur la mise à disposition sur le marché d'aéronefs télé-pilotés (UA)
destinés à être utilisés dans la catégorie « ouverte » et sur les exploitants d'UAS de pays tiers proposés
dans le document « Opinion n° 01/2018 ».
Cela comprend la conformité aux exigences du produit pour tous les UAS autorisés à fonctionner dans la
catégorie « ouverte » (UAS de classe C0, C1, C2, C3 et C4) et le système d'identification électronique.
Le présent document ne couvre pas les catégories « spécifique » ou « certifiée » des UAS.
La conformité au présent document aide à se conformer aux exigences techniques du marquage CE et
couvre, sans toutefois s'y limiter, les caractéristique suivantes :
I. Propriétés physiques et mécaniques ;
II. Inflammabilité ;
III. Propriétés électriques ;
IV. Sécurité fonctionnelle.
La présente norme ne s'applique qu'aux aéronefs télé-pilotés (UA) utilisant des sources d'énergie
basées sur des technologies électrochimiques.
Les risques supplémentaires liés aux caractéristiques de la charge utile sont exclus et relèvent de la
responsabilité du fabricant et de l'exploitant.

Aeronavtika - Letalski sistemi brez posadke - 001. del: Zahteve za proizvod in preverjanje proizvodov

General Information

• Status: Not Published
• Publication Date: 09-Aug-2020
• Withdrawal Date: 09-Feb-2021
• ICS: 49.020 - Aircraft and space vehicles in general
• Technical Committee: ASD-STAN - Aerospace
• Drafting Committee: ASD-STAN/D 1/S 4 - UAS Unmanned Air Systems
• Current Stage: 4060 - Closure of enquiry - Enquiry
• Start Date: 26-Aug-2021
• Completion Date: 26-Aug-2021
• Directive: 2019/945 - Commission Delegated Regulation (EU) 2019/945 of 12 March 2019 on unmanned aircraft systems and on third-country operators of unmanned aircraft systems
• Mandate: M/567 - Standardisation Request to the European Committee for Standardisation as regards unmanned aircraft systems intended to be operated in the ‘open’ category of operations in support of Commission Delegated Regulation (EU) 2019/945
• Ref Project: oSIST prEN 4709-001:2021 - Aerospace series - Unmanned Aircraft Systems - Part 001: Product requirements and verification

Standards Content (Sample)

SLOVENSKI STANDARD
oSIST prEN 4709-001:2019
01-april-2019
Aeronavtika - Letalski sistemi brez posadke - Zahteve za proizvod in preverjanje
proizvodov za odprto kategorijo
Aerospace series - Unmanned Aircraft Systems - Product requirements and verification
for the Open category
Ta slovenski standard je istoveten z: prEN 4709-001
ICS:
49.020 Letala in vesoljska vozila na Aircraft and space vehicles in
splošno general
oSIST prEN 4709-001:2019 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 4709-001:2019

---------------------- Page: 2 ----------------------
oSIST prEN 4709-001:2019


DRAFT
EUROPEAN STANDARD
prEN 4709-001
NORME EUROPÉENNE

EUROPÄISCHE NORM

January 2019
ICS 49.020
English Version

Aerospace series - Unmanned Aircraft Systems - Product
requirements and verification for the Open category

This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee ASD-
STAN.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 4709-001:2019 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
oSIST prEN 4709-001:2019
prEN 4709-001:2019 (E)
Contents Page
European foreword . 6
Introduction . 7
1 Scope . 8
2 Normative references . 8
3 Terms and definitions . 9
4 Product Requirements and Compliance for Class 0 UAS . 11
4.1 MTOM . 11
4.2 Manufacturer’s Instructions on Safe Flight . 12
4.2.1 General . 12
4.2.2 User and maintenance manuals (include instructions and warnings) . 12
4.2.3 Aviation regulation awareness leaflet. 12
4.3 Follow-Me Mode . 12
4.3.1 General . 12
4.3.2 Distance measurements
...

SLOVENSKI STANDARD
oSIST prEN 4709-001:2021
01-julij-2021
Aeronavtika - Letalski sistemi brez posadke - 001. del: Zahteve za proizvod in
preverjanje proizvodov
Aerospace series - Unmanned Aircraft Systems - Part 001: Product requirements and
verification
Luft- und Raumfahrt - Unbemannte Luftfahrzeugsysteme - Teil 001: Anforderungen und
Prüfverfahren
Série aérospatiale - Aéronefs télépilotés - Partie 001 : Exigences produit et méthodes de
vérification
Ta slovenski standard je istoveten z: prEN 4709-001
ICS:
49.020 Letala in vesoljska vozila na Aircraft and space vehicles in
splošno general
oSIST prEN 4709-001:2021 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 4709-001:2021

---------------------- Page: 2 ----------------------
oSIST prEN 4709-001:2021


DRAFT
EUROPEAN STANDARD
prEN 4709-001
NORME EUROPÉENNE

EUROPÄISCHE NORM

June 2021
ICS 49.020
English Version

Aerospace series - Unmanned Aircraft Systems - Part 001:
Product requirements and verification
Série aérospatiale - Aéronefs télépilotés - Partie 001 : Luft- und Raumfahrt - Unbemannte
Exigences produit et méthodes de vérification Luftfahrzeugsysteme - Teil 001: Anforderungen und
Prüfverfahren
This draft European Standard is submitted to CEN members for second enquiry. It has been drawn up by the Technical
Committee ASD-STAN.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 4709-001:2021 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
oSIST prEN 4709-001:2021
prEN 4709-001:2021 (E)
Contents Page

European foreword . 6
1 Scope . 7
2 Normative references . 7
3 Terms and definitions . 8
4 Product Requirements and Compliance for Class 0 UAS . 14
4.1 MTOM . 14
4.1.1 Performance requirements . 14
4.1.2 Verification method . 15
4.1.3 Pass Criteria . 15
4.2 Maximum Speed . 16
4.2.1 Performance requirements .
...