CEN/TS 15717:2008
(Main)Parquet flooring - General guideline for installation
Parquet flooring - General guideline for installation
This Technical specification gives guidelines for installation of parquet flooring. Products which are defined in EN 13226, EN 13227, EN 13228, EN 13488, EN 13489, EN 13629, and EN 14761 are concerned.
This Technical specification applies for installations indoors, and does not apply to the installation of joists and sub floors.
This Technical specification does not cover installations in service class 3 (see 3.4).
Parkett - Allgemeine Verlegenanleitung
Die vorliegende Technische Spezifikation enthält Leitlinien für die Verlegung von Parkettfußböden. Behandelt werden Produkte, die in EN 13226, EN 13227, EN 13228, EN 13488, EN 13489, EN 13629 und EN 14761 definiert sind.
Diese Technische Spezifikation gilt für die Verlegung in Innenräumen, sie gilt nicht für den Einbau von Deckenbalken und Unterböden.
Die vorliegende Technische Spezifikation behandelt keine Verlegung der Nutzungsklasse 3 (siehe 3.4).
Parquet en bois - Guide général de mise en oeuvre
La présente spécification technique donne des recommandations pour la pose du parquet en bois. Les
produits concernés sont définis dans l’EN 13226, l’EN 13227, l’EN 13228, l’EN 13488, l’EN 13489,
l’EN 13629, et l’EN 14761.
La présente spécification technique s'applique aux poses en intérieur et ne s’applique pas à la pose des
solives et des sols sous-jacents.
La présente spécification technique ne couvre pas les poses dans la classe de service 3 (voir 3.4).
Parketne talne obloge - Splošne smernice za polaganje
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST-TS CEN/TS 15717:2008
01-september-2008
Parketne talne obloge - Splošne smernice za polaganje
Parquet flooring - General guideline for installation
Parkett - Allgemeine Verlegeanleitung
Parquet en bois - Guide général de mise en oeuvre
Ta slovenski standard je istoveten z: CEN/TS 15717:2008
ICS:
97.150 Netekstilne talne obloge Non-textile floor coverings
SIST-TS CEN/TS 15717:2008 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST-TS CEN/TS 15717:2008
---------------------- Page: 2 ----------------------
SIST-TS CEN/TS 15717:2008
TECHNICAL SPECIFICATION
CEN/TS 15717
SPÉCIFICATION TECHNIQUE
TECHNISCHE SPEZIFIKATION
April 2008
ICS 97.150
English Version
Parquet flooring - General guideline for installation
Parquet en bois - Guide général de mise en oeuvre Parkett - Allgemeine Verlegenanleitung
This Technical Specification (CEN/TS) was approved by CEN on 28 February 2008 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to submit their
comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS available
promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in parallel to the CEN/TS)
until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2008 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 15717:2008: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST-TS CEN/TS 15717:2008
CEN/TS 15717:2008 (E)
Contents Page
Foreword.3
Introduction .4
1 Scope.4
2 Normative references.4
3 Terms and definitions .5
4 Exchange of information.5
5 General.5
6 Control before installation .5
6.1 Storage and handling.5
6.2 Materials and components used for installation.6
6.3 Site conditions.7
6.4 Sub floor.7
7 Installation.8
7.1 Glued installation (description and characteristics).8
7.2 Floating installation (description and characteristics).8
7.3 Screwed/nailed installation (description and characteristics).9
7.4 Under floor heating.
...
SLOVENSKI STANDARD
SIST-TS CEN/TS 15717:2008
01-september-2008
Parketne talne obloge - Splošne smernice za polaganje
Parquet flooring - General guideline for installation
Parkett - Allgemeine Verlegeanleitung
Parquet en bois - Guide général de mise en oeuvre
Ta slovenski standard je istoveten z: CEN/TS 15717:2008
ICS:
97.150 Talne obloge Floor coverings
SIST-TS CEN/TS 15717:2008 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST-TS CEN/TS 15717:2008
---------------------- Page: 2 ----------------------
SIST-TS CEN/TS 15717:2008
TECHNICAL SPECIFICATION
CEN/TS 15717
SPÉCIFICATION TECHNIQUE
TECHNISCHE SPEZIFIKATION
April 2008
ICS 97.150
English Version
Parquet flooring - General guideline for installation
Parquet en bois - Guide général de mise en oeuvre Parkett - Allgemeine Verlegenanleitung
This Technical Specification (CEN/TS) was approved by CEN on 28 February 2008 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to submit their
comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS available
promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in parallel to the CEN/TS)
until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2008 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 15717:2008: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST-TS CEN/TS 15717:2008
CEN/TS 15717:2008 (E)
Contents Page
Foreword.3
Introduction .4
1 Scope.4
2 Normative references.4
3 Terms and definitions .5
4 Exchange of information.5
5 General.5
6 Control before installation .5
6.1 Storage and handling.5
6.2 Materials and components used for installation.6
6.3 Site conditions.7
6.4 Sub floor.7
7 Installation.8
7.1 Glued installation (description and characteristics).8
7.2 Floating installation (description and characteristics).8
7.3 Screwed/nailed installation (description and characteristics).9
7.4 Under floor heating.9
7.5 Finishing and/o
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.