Inorganic fertilizers - Determination of specific contaminants

This document specifies references to methods for the determination of the following contaminants: mercury, cadmium, nickel, copper, zinc, arsenic, lead, chromium (VI), biuret, perchlorate and total chromium content in inorganic fertilizers.
This document is applicable to EU fertilizing products classified as PFC 1(C) and PFC 7 as long as the blend only consists of EU fertilizing products classified as PFC 1(C), PFC 2 and PFC 5 as specified in the Regulation (EU) 2019/1009 [3].
An overview of the references to methods for the determination of the specific contaminants is given in Table 1.
NOTE 1   The determination of copper and zinc in inorganic fertilizers as micronutrients is covered by CEN/TS 17754:2022.
NOTE 2   The determination of copper in ammonium nitrate fertilizers of high nitrogen content is covered by CEN/TS 17751:2022.

Anorganische Düngemittel - Bestimmung spezifischer Kontaminanten

Dieses Dokument legt Verweisungen auf Verfahren zur Bestimmung der folgenden Kontaminanten fest: Quecksilber, Cadmium, Nickel, Kupfer, Zink, Arsen, Blei, Chrom(VI), Biuret, Perchlorat und der Gesamtgehalt an Chrom in anorganischen Düngemitteln.
Dieses Dokument ist anwendbar auf EU Düngeprodukte der Kategorien PFC 1(C) und PFC 7, vorausgesetzt, die Mischung besteht ausschließlich aus EU Düngeprodukten der Kategorie PFC 1(C), PFC 2 und PFC 5 der Verordnung (EU) 2019/1009 [3].
Ein Überblick über die Verweisungen auf Verfahren zur Bestimmung der spezifischen Kontaminanten wird in Tabelle 1 gegeben.
ANMERKUNG 1   Die Bestimmung von Kupfer und Zink als Spurennährstoffe in anorganischen Düngemitteln wird in CEN/TS 17754:2022 behandelt.
ANMERKUNG 2   Die Bestimmung von Kupfer in Ammoniumnitratdüngemitteln mit hohem Stickstoffgehalt wird in CEN/TS 17751:2022 behandelt.

Engrais inorganiques - Détermination des contaminants spécifiques

Le présent document spécifie les références des méthodes de détermination des contaminants suivants : la teneur en mercure, en cadmium, en nickel, en cuivre, en zinc, en arsenic, en plomb, en chrome (VI), en biuret, en perchlorate et en chrome total dans les engrais inorganiques.
Le présent document est applicable aux fertilisants UE classés en PFC 1(C) et PFC 7 tant que la combinaison ne se compose que de fertilisants UE classés en PFC 1(C), PFC 2 et PFC 5 comme spécifié dans le règlement (UE) 2019/1009 [3].
Un aperçu des références aux méthodes de détermination des contaminants spécifiques est donné dans le Tableau 1.
NOTE 1   Le dosage du cuivre et du zinc dans les engrais inorganiques en tant qu'oligo-éléments est couvert par la CEN/TS 17754:2022.
NOTE 2   Le dosage du cuivre dans les engrais à base de nitrate d'ammonium à forte teneur en azote est couvert par la CEN/TS 17751:2022.

Anorganska gnojila - Določevanje specifičnih onesnaževal

Ta dokument navaja metode za določevanje vsebnosti biureta, živega srebra, kadmija, niklja, bakra, cinka, arzena, svinca, perklorata, kroma VI in celotnega kroma v anorganskih gnojilih.

General Information

Status
Published
Publication Date
05-Apr-2022
Current Stage
6060 - Definitive text made available (DAV) - Publishing
Start Date
06-Apr-2022
Due Date
18-Jan-2023
Completion Date
06-Apr-2022

Buy Standard

Technical specification
TS CEN/TS 17753:2023
English language
9 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)


SLOVENSKI STANDARD
01-februar-2023
Anorganska gnojila - Določevanje specifičnih onesnaževal
Inorganic fertilizers - Determination of specific contaminants
Anorganische Düngemittel - Bestimmung spezifischer Kontaminanten
Engrais inorganiques - Détermination des contaminants spécifiques
Ta slovenski standard je istoveten z: CEN/TS 17753:2022
ICS:
65.080 Gnojila Fertilizers
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

CEN/TS 17753
TECHNICAL SPECIFICATION
SPÉCIFICATION TECHNIQUE
April 2022
TECHNISCHE SPEZIFIKATION
ICS 65.080
English Version
Inorganic fertilizers - Determination of specific
contaminants
Engrais inorganiques - Détermination des Anorganische Düngemittel - Bestimmung spezifischer
contaminants spécifiques Kontaminanten
This Technical Specification (CEN/TS) was approved by CEN on 13 March 2022 for provisional application.

The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to
submit their comments, particularly on the question whether the CEN/TS can be converted into a European Standard.

CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS
available promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in
parallel to the CEN/TS) until the final decision about the possible conversion of the CEN/TS into an EN is reached.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2022 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 17753:2022 E
worldwide for CEN national Members.

Contents Page
European foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 6
4 Sampling and sample preparation . 6
4.1 Sampling . 6
4.2 Sample preparation . 6
5 Determination of specific contaminants . 6
5.1 Mercury (Hg) . 6
5.2 Cadmium (Cd), nickel (Ni), arsenic (As) and lead (Pb) . 6
5.3 Copper (Cu) and zinc (Zn) . 7
5.4 Chromium(VI) (Cr(VI)) . 7
5.5 Biuret (C H N O ) . 7
2 5 3 2
5.6 Perchlorate (ClO -) . 7
5.7 Total chromium (Cr(total)) . 7
Bibliography . 9

European foreword
This document (CEN/TS 17753:2022) has been prepared by Technical Committee CEN/TC 260
“Fertilizers and liming materials”, the secretariat of which is held by DIN.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a standardization request given to CEN by the European
Commission and the European Free Trade Association.
Any feedback and questions on this document should be directed to the users’ national standards body.
A complete listing of these bodies can be found on the CEN website.
According to the CEN/CENELEC Internal Regulations, the national standards organisations of the
following countries are bound to announce this Technical Specification: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of
North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United
Kingdom.
Introduction
Regulation (EU) 2019/1009 [3] lays down the rules on the making available on the market of EU
fertilizing products and the specific safety and quality requirements for the defined product function
categories (PFCs). Inorganic fertilizers have been classified into PFC 1(C).
The specific safety and quality requirements in relation to specific contaminants (i.e. the mercury,
cadmium, nickel, copper, zinc, arsenic, lead, chromium VI, biuret, perchlorate and total chromium
content) are defined in this document as well as normative references of the test methods to be used in
order to measure the compliance with the related requirement in the Regulation (EU) 2019/1009 [3].

1 Scope
This document specifies references to methods for the determination of the following contaminants:
mercury, cadmium, nickel, copper, zinc, arsenic, lead, chromium(VI), biuret, perchlorate and total
chromium content in inorganic fertilizers.
This document is applicable to EU fertilizing products classified as PFC 1(C) and PFC 7 as long as the
blend only consists of EU fertilizing products classified as PFC 1(C), PFC 2 and PFC 5 as specified in the
Regulation (EU) 2019/1009 [3].
An overview of the references to methods for the determination of the specific contaminants is given in
Table 1.
NOTE 1 The determination of copper and zinc in inorganic fertilizers as micronutrients is covered by
CEN/TS 17754:2022.
NOTE 2 The determination of copper in ammonium nitrate fertilizers of high nitrogen content is covered by
CEN/TS 17751:2022.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments) applies.
EN 1482
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.