EN ISO 6185-1:2001

Inflatable boats - Part 1: Boats with a maximum motor power rating of 4,5 kW (ISO 6185-1:2001)

Migrated from Progress Sheet (TC Comment) (2000-07-10): ISO/TC/Secr. Oct 93: WG meeting Oct. 93. The CD was approved, and comments are ++ to be considered. PV perhaps 94-02. (2 changes of Conveners).

Aufblasbare Boote - Teil 1: Boote mit einer Motorhöchstleistung von 4,5 kW (ISO 6185-1:2001)

Dieser Teil der ISO 6185 legt die minimalen sicherheitstechnischen Anforderungen an die Konstruktion, Werk-stoffeigenschaften, Verarbeitung und Prüfung von aufblasbaren Booten, (einschließlich RIBs = Rigid Inflatable Boats) von einer Gesamtlänge von weniger als 8 m und mit einem Mindestauftrieb von 1 800 N fest.
Dieser Teil der ISO 6185 gilt für die folgenden Kategorien von aufblasbaren Booten, die für einen Einsatz im
Tempe-raturbereich von - 5 °C bis + 60 °C vorgesehen sind:
¾ Kategorie I:   Aufblasbare Boote ausschließlich manuell angetrieben;
¾ Kategorie II:  Aufblasbare Boote mit einer Motorhöchstleistung von 4,5 kW;
¾ Kategorie III: Aufblasbare Kanus und Kajaks (siehe normativen Anhang A);
¾ Kategorie IV: Aufblasbare Boote mit Segelantrieb mit einer maximalen Segelfläche von 6 m2
(siehe normativen Anhang B).
ANMERKUNG 1   Aufbau und Hauptbestandteile von typischen Booten der Kategorien I, II und III werden jeweils in den
Anhängen C, D und E angegeben.
ANMERKUNG 2   Für Boote mit einer Leistung von 4,5 kW und mehr wird auf ISO 6185-2 und ISO 6185-3 verwiesen.
Dieser Teil der ISO 6185 schließt Ein-Kammer-Boote aus und gilt nicht für Wasserspielzeuge und aufblasbare Rettungsflöße.

Bateaux pneumatiques - Partie 1: Bateaux équipés d'un moteur d'une puissance maximale de 4,5 kW (ISO 6185-1:2001)

La présente partie de l'ISO 6185 spécifie les caractéristiques minimales de sécurité relatives à la conception, aux matériaux utilisés, à la fabrication et aux essais des bateaux pneumatiques (y compris les bateaux pneumatiques rigides) d'une longueur totale inférieure à 8 m et présentant une flottabilité d'au moins 1800 N. La présente partie de l'ISO 6185 s'applique aux types suivants de bateaux pneumatiques, destinés à être utilisés dans une plage de températures de service comprises entre - 5 °C et + 60 °C: - type I: bateaux pneumatiques à propulsion uniquement manuelle; - type Il: bateaux pneumatiques pouvant être équipés d'un moteur d'une puissance maximale de 4,5 kW; - type Ill: canoës et kayaks gonflables (voir l'annexe normative A); - type IV: bateaux pneumatiques à voile dont la surface de voilure ne dépasse pas 6 m2 (voir l'annexe normative B).
NOTE 1 Des exemples de disposition générale pour les bateaux des types I, Il et III sont donnés dans les annexes C, D et E.
NOTE 2 Pour les bateaux ayant une puissance supérieure ou égale à 4,5 kW, se reporter à l'ISO 6185-2 et à l'ISO 6185-3. La présente partie de l'ISO 6185 ne s'applique pas aux bateaux à chambre unique, ni aux jouets aquatiques ni aux radeaux de sauvetage pneumatiques.

Napihljivi čolni – 1. del: Čolni z motorjem z največjo močjo 4,5 kW (ISO 6185-1:2001)

General Information

• Status: Withdrawn
• Publication Date: 14-Nov-2001
• Withdrawal Date: 02-Oct-2018
• ICS: 47.080 - Small craft
• Technical Committee: CEN/SS T01 - Shipbuilding and maritime structures
• Drafting Committee: CEN/SS T01 - Shipbuilding and maritime structures
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Completion Date: 03-Oct-2018
• Directive: 2003/44/EC - Approximation of the laws, regulations and administrative provisions of the Member States relating to recreational craft
• Directive: 2013/53/EU - Directive 2013/53/EU of the European Parliament and of the Council of 20 November 2013 on recreational craft and personal watercraft and repealing Directive 94/25/EC
• Directive: 94/25/EC - Directive 94/25/EC of the European Parliament and of the Council of 16 June 1994 on the approximation of the laws, regulations and administrative provisions of the Member States relating to recreational craft
• Mandate: M/075 - Revised mandate to CEN for standardization in the field of recreational craft
• Ref Project: SIST EN ISO 6185-1:2002 - Inflatable boats - Part 1: Boats with a maximum motor power rating of 4,5 kW (ISO 6185-1:2001)

Relations

• Replaced By: EN ISO 6185-1:2018 - Inflatable boats - Part 1: Boats with a maximum motor power rating of 4,5 kW (ISO 6185-1:2001)
• Effective Date: 10-Oct-2018

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 6185-1:2002
01-december-2002
1DSLKOMLYLþROQL±GHOýROQL]PRWRUMHP]QDMYHþMRPRþMRN:,62

Inflatable boats - Part 1: Boats with a maximum motor power rating of 4,5 kW (ISO 6185-
1:2001)
Aufblasbare Boote - Teil 1: Boote mit einer Motorhöchstleistung von 4,5 kW (ISO 6185-
1:2001)
Bateaux pneumatiques - Partie 1: Bateaux équipés d'un moteur d'une puissance
maximale de 4,5 kW (ISO 6185-1:2001)
Ta slovenski standard je istoveten z: EN ISO 6185-1:2001
ICS:
47.080
SIST EN ISO 6185-1:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

EUROPEAN STANDARD
EN ISO 6185-1
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2001
ICS 47.080
English version
Inflatable boats - Part 1: Boats with a maximum motor power
rating of 4,5 kW (ISO 6185-1:2001)
Bateaux pneumatiques - Partie 1: Bateaux équipés d'un Aufblasbare Boote - Teil 1: Boote mit einer
moteur d'une puissance maximale de 4,5 kW (ISO 6185- Motorhöchstleistung von 4,5 kW (ISO 6185-1:2001)
1:2001)
This European Standard was approved by CEN on 10 November 2001.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2001 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 6185-1:2001 E
worldwide for CEN national Members.

---------------------- Page: 2 ----------------------

EN ISO 6185-1:2001 (E)
CORRECTED  2002-04-03
Foreword
This document (ISO 6185-1:2001) has been prepared by Technical Committee ISO/TC 188
"Small craft" in collaboration with CMC.
This European Standard shall be given the status of a national standard, either by publication of
an identical text or by endorsement, at the latest by May 2002, and conflicting national standards
shall be withdrawn at the latest by May 2002.
This document has been prepared under a mandate given to CEN by the European Commission
and the European Free Trade Association, and supports essential requirements of EU
Directive(s).
For relationship with EU Directive(s), see informative annex ZB, which is an integral part of this
document.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of
the following countries are bound to implement this European Standard: Austria, Belgium, Czech
Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg,
Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom.
Endorsement notice
The text of the International Standard ISO 6185-1:2001 has been approved by CEN as a
European Standard without any modifications.
NOTE Normative references to International Standards are listed in annex ZA (normative).
2

---------------------- Page: 3 ----------------------

EN ISO 6185-1:2001 (E)
Annex ZA
(normative)
Normative references to international publications
with their relevant European publications
This European Standard incorporates by dated or undated reference, provisions from other
publications. These normative references are cited at the appropriate places in the text and the
publications are listed hereafter. For dated references, subsequent amendments to or revisions of
any of these publications apply to this European Standard only when incorporated in it by
amendment or revision. For undated references the latest edition of the publication referred to
applies (including amendments).
NOTE Where an International Publication has been modified by common modifications, indicated
by (mod.), the relevant EN/HD applies.
Publication Year Title EN Year
ISO 8665 1994 Small craft - Marine propulsion EN ISO 8665 1995
engines and systems - Power
measurements and declarations
ISO 9775 1990 Small craft - Remote steering EN 29775 1993
systems for single outboard motors
of 15 kW to 40 kW power
ISO 11591 2000 Small craft, engine-driven - Field of EN ISO 11591 2000
vision from helm position
ISO 12215-1 2000 Small craft - Hull construction
...