EN 15182-2:2019
(Main)Portable equipment for projecting extinguishing agents supplied by firefighting pumps - Hand-held branchpipes for fire service use - Part 2: Combination branchpipes PN 16
Portable equipment for projecting extinguishing agents supplied by firefighting pumps - Hand-held branchpipes for fire service use - Part 2: Combination branchpipes PN 16
In addition to the requirements given in EN 15182-1:2019, this document applies to hand-held combination branchpipes (nozzles), with a nominal pressure of 16 bar (1,6 MPa) PN 16, with a maximum flow rate up to 1 000 l/min at a reference pressure of 6 bar (0,6 MPa). It deals with:
- safety requirements;
- performance requirements;
- test methods.
This document applies to branchpipes as defined in Annex A of EN 15182-1:2019.
Tragbare Geräte zum Ausbringen von Löschmitteln, die mit Feuerlöschpumpen gefördert werden - Strahlrohre für die Brandbekämpfung - Teil 2: Hohlstrahlrohre PN 16
Zusätzlich zu den in EN 15182-1:2019 angegebenen Anforderungen gilt dieses Dokument für Hohlstrahlrohre (Mundstücke) mit einem Nenndruck von 16 bar (1,6 MPa) PN 16 und mit einem maximalen Volumenstrom bis zu 1 000 l/min bei einem Referenzdruck von 6 bar (0,6 MPa). Behandelt werden:
- Sicherheitsanforderungen;
- Leistungsanforderungen;
- Prüfverfahren.
Dieses Dokument gilt für Strahlrohre nach EN 15182-1:2019, Anhang A.
Equipement portable de projection d’agents d’extinction alimenté par des pompes à usage incendie - Lances à main destinées aux services d'incendie et de secours - Partie 2 : Lances combinées PN 16
En complément des prescriptions données dans l’EN 15182-1:2019, le présent document s‘applique aux lances à main combinées, de pression nominale 16 bar (1,6 MPa) PN 16, d’un débit maximum jusqu’à 1 000 l/min à une pression de référence de 6 bar (0,6 MPa). Il traite :
- des prescriptions de sécurité ;
- des prescriptions de performances ;
- des méthodes d’essai.
Le présent document s’applique aux lances définies dans l’Annexe A de l'EN 15182-1:2019.
Prenosna oprema za črpanje in uporabo gasilnega sredstva iz gasilskih črpalk - Gasilski ročniki - 2. del: Kombinirani ročniki PN 16
Poleg zahtev, navedenih v standardu EN 15182-1, se ta dokument uporablja za kombinirane ročnike (šobe) PN 16 z največjim pretokom 1000 l/min pri referenčnem tlaku 6 barov (0,6 MPa). Obravnava:
– varnostne zahteve;
– zahteve glede zmogljivosti;
– – preskusne metode.
Ta dokument se uporablja za ročnike, kot je opredeljeno v dodatku A standarda EN 15182-1.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 15182-2:2019
01-november-2019
Nadomešča:
SIST EN 15182-2:2007+A1:2010
Prenosna oprema za črpanje in uporabo gasilnega sredstva iz gasilskih črpalk -
Gasilski ročniki - 2. del: Kombinirani ročniki PN 16
Portable equipment for projecting extinguishing agents supplied by firefighting pumps -
Hand-held branchpipes for fire service use - Part 2: Combination branchpipes PN 16
Tragbare Geräte zum Ausbringen von Löschmitteln, die mit Feuerlöschpumpen gefördert
werden - Strahlrohre für die Brandbekämpfung - Teil 2: Hohlstrahlrohre PN 16
Equipement portable de projection d’agents d’extinction alimenté par des pompes à
usage incendie - Lances à main destinées aux services d'incendie et de secours - Partie
2 : Lances combinées PN 16
Ta slovenski standard je istoveten z: EN 15182-2:2019
ICS:
13.220.10 Gašenje požara Fire-fighting
SIST EN 15182-2:2019 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 15182-2:2019
---------------------- Page: 2 ----------------------
SIST EN 15182-2:2019
EN 15182-2
EUROPEAN STANDARD
NORME EUROPÉENNE
September 2019
EUROPÄISCHE NORM
ICS 13.220.10 Supersedes EN 15182-2:2007+A1:2009
English Version
Portable equipment for projecting extinguishing agents
supplied by firefighting pumps - Hand-held branchpipes
for fire service use - Part 2: Combination branchpipes PN
16
Equipement portable de projection d'agents Tragbare Geräte zum Ausbringen von Löschmitteln, die
d'extinction alimenté par des pompes à usage incendie mit Feuerlöschpumpen gefördert werden - Strahlrohre
- Lances à main destinées aux services d'incendie et de für die Brandbekämpfung - Teil 2: Hohlstrahlrohre PN
secours - Partie 2 : Lances combinées PN 16 16
This European Standard was approved by CEN on 10 June 2019.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 15182-2:2019 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 15182-2:2019
EN 15182-2:2019 (E)
Contents Page
European foreword . 3
1 Scope . 4
2 Normative references . 4
3 Terms and definitions . 4
4 Requirements and verification . 5
4.1 General . 5
4.2 Mechanical characteristics . 6
4.2.1 Dimensions and mass . 6
4.2.2 Operating and handling elements . 6
4.2.3 Flow adjustment positions.
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.