EN 747-1:2012/FprA1

Furniture - Bunk beds and high beds - Part 1: Safety, strength and durability requirements

This European Standard specifies requirements for the safety, strength and durability of bunk beds and high beds for domestic and non-domestic use. The loads and forces in the strength and durability tests apply to beds with an internal length greater than 140 cm and a maximum bed base width of 120 cm.
The dimensional requirements are intended to minimise the risk of accidents, particularly to children.
The strength and durability requirements are intended to represent use by one occupant per bed.
Safety requirements for other products included in a bunk bed/high bed, for example a table or storage furniture, are not included in this standard.
This European Standard does not apply to bunk beds and high beds used for special purposes, including but not limited to prison, the military and fire brigades.

Möbel - Etagenbetten und Hochbetten - Teil 1: Anforderungen an die Sicherheit, Festigkeit und Dauerhaltbarkeit

Meubles - Lits superposés et lits surélevés - Partie 1: Exigences de sécurité, de résistance et de durabilité

Pohištvo - Pogradi in visoke postelje - 1. del: Zahteve za varnost, trdnost in trajnost - Dopolnilo A1

General Information

• Status: Not Published
• ICS: 97.140 - Furniture
• Technical Committee: CEN/TC 207 - Furniture
• Drafting Committee: CEN/TC 207 - Furniture
• Current Stage: 5060 - Closure of Vote - Formal Approval
• Start Date: 15-Mar-2015
• Due Date: 19-Feb-2016
• Completion Date: 15-Mar-2015
• Ref Project: SIST EN 747-1:2012/kFprA1:2015 - Furniture - Bunk beds and high beds - Part 1: Safety, strength and durability requirements

Relations

• Merged Into: EN 747-1:2012+A1:2015 - Furniture - Bunk beds and high beds - Part 1: Safety, strength and durability requirements
• Effective Date: 19-Jan-2023
• Amends: EN 747-1:2012 - Furniture - Bunk beds and high beds - Part 1: Safety, strength and durability requirements
• Effective Date: 23-May-2012

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 747-1:2012/oprA1:2013
01-november-2013
Pohištvo - Pogradi in visoke postelje - 1. del: Zahteve za varnost, trdnost in
trajnost - Dopolnilo A1
Furniture - Bunk beds and high beds - Part 1: Safety, strength and durability
requirements
Möbel - Etagenbetten und Hochbetten - Teil 1: Anforderungen an die Sicherheit,
Festigkeit und Dauerhaltbarkeit
Meubles - Lits superposés et lits surélevés - Partie 1: Exigences de sécurité, de
résistance et de durabilité
Ta slovenski standard je istoveten z: EN 747-1:2012/prA1
ICS:
97.140 Pohištvo Furniture
SIST EN 747-1:2012/oprA1:2013 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

SIST EN 747-1:2012/oprA1:2013
SIST EN 747-1:2012/oprA1:2013
EUROPEAN STANDARD
DRAFT
EN 747-1:2012
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
September 2013
ICS 97.140
English Version
Furniture - Bunk beds and high beds - Part 1: Safety, strength
and durability requirements
Meubles - Lits superposés et lits surélevés - Partie 1: Möbel - Etagenbetten und Hochbetten - Teil 1:
Exigences de sécurité, de résistance et de durabilité Anforderungen an die Sicherheit, Festigkeit und
Dauerhaltbarkeit
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 207.

This draft amendment A1, if approved, will modify the European Standard EN 747-1:2012. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.

This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has
the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.

EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2013 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 747-1:2012/prA1:2013: E
worldwide for CEN national Members.

SIST EN 747-1:2012/oprA1:2013
EN 747-1:2012/prA1:2013 (E)
Contents
Page
Foreword .3
1 Modification to Clause 1 .4
2 Modifications to Clause 3 .4
3 Modifications to Clause 4 .4
4 Modification to clause 5 .5
5 Modification to clause 6 .5

SIST EN 747-1:2012/oprA1:2013
EN 747-1:2012/prA1:2013 (E)
Foreword
This document (EN 747-1:2012/prA1:2013) has been prepared by Technical Committee CEN/TC 207
“Furniture”, the secretariat of which is held by UNI.
This document is currently submitted to the CEN Enquiry.
SIST EN 747-1:2012/oprA1:2013
EN 747-1:2012/prA1:2013 (E)
...