EN 1408:2023
(Main)Chemicals used for treatment of water intended for human consumption - Poly(diallyldimethylammonium chloride)
Chemicals used for treatment of water intended for human consumption - Poly(diallyldimethylammonium chloride)
This document is applicable to poly(diallyldimethylammonium chloride) used for treatment of water intended for human consumption. It describes the characteristics of poly(diallyldimethylammonium chloride) and specifies the requirements and the corresponding test methods for poly(diallyldimethylammonium chloride). It gives information on their use in water treatment.
Produkte zur Aufbereitung von Wasser für den menschlichen Gebrauch - Poly(diallyldimethylammoniumchlorid)
Dieses Dokument ist anwendbar für Poly(diallyldimethylammoniumchlorid) zur Aufbereitung von Wasser für den menschlichen Gebrauch. Es beschreibt die Eigenschaften von Poly(diallyldimethylammoniumchlorid) und legt die Anforderungen sowie die entsprechenden Prüfverfahren für Poly(diallyldimethylammoniumchlorid) fest. Es gibt Informationen für seine Anwendung in der Wasseraufbereitung.
Produits chimiques utilisés pour le traitement de l'eau destinée à la consommation humaine - Poly(chlorure de diméthyldiallylammonium)
Le présent document est applicable au poly(chlorure de diméthyldiallylammonium) utilisé pour le traitement de l’eau destinée à la consommation humaine. Il décrit les caractéristiques et spécifie les exigences et les méthodes d’essai correspondantes pour le poly(chlorure de diméthyldiallylammonium). Il donne des informations pour leur emploi dans le traitement de l’eau.
Kemikalije, ki se uporabljajo za pripravo pitne vode - Poli(dialildimetil amonijev klorid)
Ta dokument se uporablja za poli(dialildimetil amonijev klorid), ki se uporablja za pripravo pitne vode. Opisuje lastnosti poli(dialildimetil amonijev klorida) ter določa zahteve in ustrezne preskusne metode zanj. Dokument podaja informacije o uporabi poli(dialildimetil amonijev klorida) pri pripravi vode.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-december-2023
Nadomešča:
SIST EN 1408:2008
Kemikalije, ki se uporabljajo za pripravo pitne vode - Poli(dialildimetil amonijev
klorid)
Chemicals used for treatment of water intended for human consumption - Poly
(diallyldimethylammonium chloride)
Produkte zur Aufbereitung von Wasser für den menschlichen Gebrauch - Poly
(diallyldimethylammoniumchlorid)
Produits chimiques utilisés pour le traitement de l'eau destinée à la consommation
humaine - Poly(chlorure de diméthyldiallylammonium)
Ta slovenski standard je istoveten z: EN 1408:2023
ICS:
13.060.20 Pitna voda Drinking water
71.100.80 Kemikalije za čiščenje vode Chemicals for purification of
water
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EN 1408
EUROPEAN STANDARD
NORME EUROPÉENNE
October 2023
EUROPÄISCHE NORM
ICS 71.100.80 Supersedes EN 1408:2008
English Version
Chemicals used for treatment of water intended for human
consumption - Poly(diallyldimethylammonium chloride)
Produits chimiques utilisés pour le traitement de l'eau Produkte zur Aufbereitung von Wasser für den
destinée à la consommation humaine - Poly(chlorure menschlichen Gebrauch -
de diméthyldiallylammonium) Poly(diallyldimethylammoniumchlorid)
This European Standard was approved by CEN on 14 August 2023.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 1408:2023 E
worldwide for CEN national Members.
Contents Page
European foreword . 4
Introduction . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 6
4 Description . 6
4.1 Identification . 6
4.1.1 Chemical name(s) . 6
4.1.2 Synonym(s) or common name(s) . 6
4.1.3 Relative molecular mass . 6
4.1.4 Empirical formula . 6
4.1.5 Chemical formula . 7
4.1.6 CAS Registry Numbers . 7
4.1.7 EINECS reference . 7
4.2 Commercial form . 8
5 Physical properties . 8
5.1 Appearance . 8
5.2 Density . 8
5.3 Solubility . 8
5.4 Vapour pressure . 8
5.5 Boiling point at 100 kPa . 8
5.6 Freezing point . 8
5.7 Specific heat . 8
5.8 Viscosity dynamic . 9
5.9 Critical temperature . 9
5.10 Critical pressure . 9
5.11 Physical hardness . 9
6 Chemical properties . 9
6.1 General. 9
6.2 Purity criteria . 9
6.2.1 General. 9
6.2.2 Impurities and main by-products . 9
6.3 Composition of commercial product . 9
6.4 Chemical parameters. 10
7 Test methods . 10
7.1 Sampling . 10
7.1.1 General. 10
7.1.2 Sampling from drums and bottles . 10
7.2 Analyses. 11
7.2.1 General. 11
7.2.2 Main product . 11
7.2.3 Impurities . 13
8 Labelling - transportation – storage. 17
8.1 Means of delivery . 17
8.2 Labelling according to the EU Legislation . 17
8.3 Transportation regulations and labelling . 18
8.4 Marking . 18
8.5 Storage . 18
8.5.1 Long term stability . 18
8.5.2 Storage incompatibilities . 18
Annex A (informative) General information on polyDADMAC . 19
A.1 Origin . 19
A.1.1 Raw materials . 19
A.1.2 Manufacturing process . 19
A.2 Use . 19
A.2.1 Function . 19
A.2.2 Form in which it is used . 19
A.2.3 Treatment dose . 19
A.2.4 Means of application. 19
A.2.5 Secondary effects . 19
A.2.6 Removal of excess product . 19
A.3 Rules for safe handling and use . 19
A.4 Emergency procedures . 20
A.4.1 First aid . 20
A.4.2 Spillage . 20
A.4.3 Fire . 20
Bibliography . 21
European foreword
This document (EN 1408:2023) has been prepared by Technical Committee CEN/TC 164 “Water supply”,
the secretariat of which is held by AFNOR.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by April 2024, and conflicting national standards shall be
withdrawn at the latest by April 2024.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN 1408:2008.
In comparison with the previous edition EN 1408:2008, the following technical modifications have been
made:
a) updating in line with current legislation;
b) modification of 8.3 on transportation regulations and labelling, adding the sentence “The user shall
be aware of the incompatibilities between transported products.”;
c) modification of 8.4 on marking. The requirements of marking are also applied to the accompanying
documents.
Annex A is informative and gives information on origin, use and handling of po
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.