EN IEC 63203-406-1:2022
(Main)Wearable electronic devices and technologies - Part 406-1: Test method for measuring surface temperature of wrist-worn wearable electronic devices while in contact with human skin
Wearable electronic devices and technologies - Part 406-1: Test method for measuring surface temperature of wrist-worn wearable electronic devices while in contact with human skin
This part of IEC 63203 defines the terms, definitions, symbols, configurations, and test methods to be used to specify the standard measurement conditions and methods for determining the contact-surface temperature of wrist-worn wearable electronic devices intended to be worn directly on a human wrist and that can be worn continuously during use. The conditions of the test do not consider perfusion and results are therefore considered conservatively. The temperature increase is induced by the thermal energy of wearable electronic devices during operation. This document gives the general procedure for the test method applicable to various wrist-worn wearable electronic devices for use by ordinary persons which in the context of this document is a healthy human adult.
Tragbare elektronische Geräte und Technologien – Teil 406-1: Prüfverfahren zur Messung der Oberflächenkontakttemperatur von am Handgelenk getragenen elektronischen Geräten
Technologies et dispositifs électroniques prêts-à-porter - Partie 406-1 : Méthode d’essai pour le mesurage de la température de surface des dispositifs électroniques prêts-à-porter placés au poignet au contact de la peau humaine
L‘IEC 63203-406-1:2021 définit les termes, les définitions, les symboles, les configurations et les méthodes d'essai à utiliser pour spécifier les conditions de mesure normalisées et les méthodes de détermination de la température à la surface de contact des dispositifs électroniques prêts-à-porter placés au poignet, destinés à être portés directement sur le poignet humain et qui peuvent être portés de manière continue pendant leur utilisation. Les conditions de l’essai ne prennent pas en considération la diffusion et les résultats sont par conséquent considérés avec prudence. L'augmentation de la température est induite par l'énergie thermique des dispositifs électroniques prêts-à-porter pendant leur fonctionnement. Le présent document donne la procédure générale pour la méthode d'essai applicable à divers dispositifs électroniques prêts-à-porter placés au poignet et destinés à être utilisés par des personnes ordinaires qui, dans le contexte de ce document, sont des adultes humains en bonne santé.
Nosljive elektronske naprave in tehnologije - 406-1. del: Preskusna metoda za merjenje površinske temperature zapestno nošenih elektronskih naprav pri dotiku s človeško kožo (IEC 63203-406-1:2021)
Ta del standarda IEC 63203 opredeljuje izraze, definicije, simbole, konfiguracije in preskusne metode, ki se uporabljajo za določitev standardnih merilnih pogojev in metod za določanje temperature stične površine zapestno nošenih elektronskih naprav, ki so namenjene nošenju neposredno na zapestju in jih je mogoče med uporabo nositi neprekinjeno. Pogoji preskusa ne upoštevajo perfuzije, zato se rezultati obravnavajo konzervativno. Dvig temperature povzroči toplotna energija nosljivih elektronskih naprav med delovanjem. Ta dokument podaja splošni postopek za preskusno metodo, ki se uporablja za različne zapestno nošene elektronske naprave, namenjene za splošno uporabo pri posameznikih (v kontekstu tega dokumenta je to zdrav odrasel človek).
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
01-april-2022
Nosljive elektronske naprave in tehnologije - 406-1. del: Preskusna metoda za
merjenje površinske temperature zapestno nošenih elektronskih naprav pri dotiku
s človeško kožo (IEC 63203-406-1:2021)
Wearable electronic devices and technologies - Part 406-1: Test method for measuring
surface temperature of wrist worn wearable electronic devices while in contact with
human skin (IEC 63203-406-1:2021)
Tragbare elektronische Geräte und Technologien – Teil 406-1: Prüfverfahren zur
Messung der Oberflächenkontakttemperatur von am Handgelenk getragenen
elektronischen Geräten (IEC 63203-406-1:2021)
Technologies et dispositifs électroniques prêts-à-porter - Partie 406-1 : Méthode d’essai
pour le mesurage de la température de surface des dispositifs électroniques prêts-à-
porter placés au poignet au contact de la peau humaine (IEC 63203-406-1:2021)
Ta slovenski standard je istoveten z: EN IEC 63203-406-1:2022
ICS:
59.080.80 Inteligentne tekstilije Smart textiles
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN IEC 63203-406-1
NORME EUROPÉENNE
EUROPÄISCHE NORM February 2022
ICS 31.020
English Version
Wearable electronic devices and technologies - Part 406-1: Test
method for measuring surface temperature of wrist-worn
wearable electronic devices while in contact with human skin
(IEC 63203-406-1:2021)
Technologies et dispositifs électroniques prêts-à-porter - Tragbare elektronische Geräte und Technologien - Teil 406-
Partie 406-1 : Méthode d'essai pour le mesurage de la 1: Prüfverfahren zur Messung der
température de surface des dispositifs électroniques prêts- Oberflächenkontakttemperatur von am Handgelenk
à-porter placés au poignet au contact de la peau humaine getragenen elektronischen Geräten
(IEC 63203-406-1:2021) (IEC 63203-406-1:2021)
This European Standard was approved by CENELEC on 2022-01-20. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2022 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 63203-406-1:2022 E
European foreword
The text of document 124/161/FDIS, future edition 1 of IEC 63203-406-1, prepared by IEC/TC 124
“Wearable electronic devices and technologies” was submitted to the IEC-CENELEC parallel vote and
approved by CENELEC as EN IEC 63203-406-1:2022.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2022–10–20
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2025–01–20
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
Endorsement notice
The text of the International Standard IEC 63203-406-1:2021 was approved by CENELEC as a
European Standard without any modification.
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod), the
relevant EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is available
here: www.cenelec.eu.
Publication Year Title EN/HD Year
IEC 62368-1 2018 Audio/video, information and EN IEC 62368-1 2020
communication technology equipment -
Part 1: Safety requirements
- - AC 2020–
- - A11 2020
IEC 63203-406-1 ®
Edition 1.0 2021-12
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Wearable electronic devices and technologies –
Part 406-1: Test method for measuring surface temperature of wrist-worn
wearable electronic devices while in contact with human skin
Technologies et dispositifs électroniques prêts-à-porter –
Partie 406-1: Méthode d’essai pour le mesurage de la température de surface
des dispositifs électroniques prêts-à-porter placés au poignet au contact de la
peau humaine
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 31.020 ISBN 978-2-8322-1061-5
– 2 – IEC 63203-406-1:2021 © IEC 2021
CONTENTS
FOREWORD . 3
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Test conditions and test setup . 7
4.1 Environmental conditions . 7
4.2 Human skin-imitating fixture . 7
4.2.1 General . 7
4.2.2 Structure of the human skin-imitating fixture . 7
4.2.3 Monitoring skin-imitating temperature and heater control . 7
4.3 Stabilization time . 7
4.4 Test setup . 8
4.4.1 General . 8
4.4.2 Placement of device under test (DUT) . 8
4.4.3 Thermocouple placement . 9
4.4.4 Device operating conditions . 9
5 Test method . 9
6 Test report . 10
Annex A (informative) Low-temperature burn caused by wearable electronic devices. 11
A.1 General . 11
A.2 Low-temperature burn threshold . 11
Annex B (informative) Human skin-imitating fixture . 12
B.1 General structure . 12
B.2 Heater for imitating skin temperature . 12
Annex C (informative) Device operation scenario for the temperature test . 14
C.1 Normal operating condition scenario . 14
C.2 Abnormal operating condition scenario . 14
Bibliography . 15
Figure 1 – Test setup for evaluating the contact-surface temperature of a wearable
electronic device . 8
Figure B.1 – Structure of human skin-imitating fixture . 12
Figure B.2 – Minimum size of cover, heater, and the position of thermocouple to
monitor skin-imitating temperature . 13
Figure C.1 – Working period and duty cycle under device operating conditions . 14
IEC 63203-406-1:2021 © IEC 2021 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
WEARABLE ELECTRONIC DEVICES AND TECHNOLOGIES –
Part 406-1: Test method for measuring surface temperature of wrist-worn
wearable electronic devices while in contact with human skin
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international
co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and
in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports,
Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their
preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with
may participate in this preparatory work. International, governmental and non-governmental organizations liaising
with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for
Standardization (ISO) in accordance with conditions determined by agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence between
any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent
rights. IEC shall not be held responsible for identifying any or all such patent right
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.