prEN 50483-6
(Main)Test requirements for low voltage aerial bundled cable accessories - Part 6: Environmental testing
Test requirements for low voltage aerial bundled cable accessories - Part 6: Environmental testing
EN 50483 series applies to overhead line fittings for tensioning, supporting and connecting aerial bundled cables (ABC) of rated voltage U0/U (Um): 0,6/1 (1,2) kV. This Part 6 defines the environmental tests in particular the climatic and corrosion ageing tests. The objective of these tests is to predict the behaviour of ABC accessories when subjected to sun radiation, to weather conditions (humidity, spraying water, heat, cold) and pollution. EN 50483 1, EN 50483 2, EN 50483 3 and EN 50483 4 specify which type tests included in this part of the standard are needed.
Prüfanforderungen für Bauteile für isolierte Niederspannungsfreileitungen - Teil 6: Umweltprüfungen
Prescriptions relatives aux essais des accessoires pour réseaux aériens basse tension torsadés - Partie 6: Essais d’environnement
Zahteve za preskušanje pribora za nizkonapetostne izolirane nadzemne kable - 6. del: Okoljsko preskušanje
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-december-2024
Zahteve za preskušanje pribora za nizkonapetostne izolirane nadzemne kable - 6.
del: Okoljsko preskušanje
Test requirements for low voltage aerial bundled cable accessories - Part 6:
Environmental testing
Prüfanforderungen für Bauteile für isolierte Niederspannungsfreileitungen - Teil 6:
Umweltprüfungen
Prescriptions relatives aux essais des accessoires pour réseaux aériens basse tension
torsadés - Partie 6: Essais d’environnement
Ta slovenski standard je istoveten z: prEN 50483-6
ICS:
29.240.20 Daljnovodi Power transmission and
distribution lines
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD DRAFT
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2024
ICS 29.240.20 Will supersede EN 50483-6:2009
English Version
Test requirements for low voltage aerial bundled cable
accessories - Part 6: Environmental testing
Prescriptions relatives aux essais des accessoires pour Prüfanforderungen für Bauteile für isolierte
réseaux aériens basse tension torsadés - Partie 6: Essais Niederspannungsfreileitungen - Teil 6: Umweltprüfungen
d'environnement
This draft European Standard is submitted to CENELEC members for enquiry.
Deadline for CENELEC: 2025-01-10.
It has been drawn up by CLC/TC 20.
If this draft becomes a European Standard, CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CENELEC in three official versions (English, French, German).
A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to
the CEN-CENELEC Management Centre has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Türkiye and the United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2024 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Project: 79843 Ref. No. prEN 50483-6 E
Contents Page
1 European foreword . 3
2 Introduction . 4
3 1 Scope . 5
4 2 Normative references . 5
5 3 Terms and definitions . 5
6 4 Symbols . 6
7 5 Marking . 6
8 6 Type tests . 6
9 6.1 Number of test samples and number of cycles . 6
10 6.2 Requirements . 6
11 6.3 Cleaning . 7
12 6.4 Corrosion ageing tests . 7
13 6.5 Climatic ageing test . 12
14 Annex A (informative) Salt mist and gas atmosphere corrosion test justification . 20
15 Annex B (informative) Example of specific reaction to obtain sulphur dioxide . 21
16 Annex C (informative) Climatic areas . 22
17 Annex D (informative) Test equipment . 23
18 D.1 Calibration of the radiometers. 24
19 D.2 Black standard thermometer . 24
20 Bibliography . 26
Figures
21 Figure 1 — Suggested arrangement for connections — Optional immersion test Method
22 1 10
23 Figure 2 — Informative diagram of the conditioning cycle — Weekly cycle . 17
24 Figure 3 — Temperature — Radiation — Time relationships . 19
25 Figure D.1 — Typical test arrangement. 23
26 Tables
27 Table 1 — Quantities for acid solution components . 11
28 Table 2 — Minimum and maximum levels of the relative spectral irradiance . 18
29 Table C.1 — Climatic conditions — Appropriate tests . 22
30 European foreword
31 This document [prEN 50483-6:2024] has been prepared by WG 11 of CLC/TC 20, “Electric cables”.
32 This document is currently submitted to the Enquiry.
33 The following dates are proposed:
• latest date by which the existence of this (doa) dav + 6 months
document has to be announced at national
level
• latest date by which this document has to be (dop) dav + 12 months
implemented at national level by publication of
an identical national standard or by
endorsement
• latest date by which the national standards (dow) dav + 36 months
conflicting with this document have to be (to be confirmed or
withdrawn modified when voting)
34 This document will supersede EN 50483-6:2009 and all of its amendments and corrigenda (if any).
35 prEN 50483-6:2024 includes the following significant technical changes with respect to EN 50483-6:2009:
36 This is Part 6 of CENELEC standard EN 50483 “Test requirements for low voltage aerial bundled cable
37 accessories”, which has six parts:
38 — Part 1: Generalities;
39 — Part 2: Tension and suspension clamps, fittings and brackets for self supporting system;
40 — Part 3: Tension and suspension clamps for neutral messenger system;
41 — Part 4: Connectors;
42 — Part 5: Electrical ageing test;
43 — Part 6: Environmental testing.
44 Introduction
45 The objective of the EN 50483 series is to provide a method of testing the suitability of accessories when used
46 under normal operating conditions with low voltage aerial bundled cables (ABC) complying with HD 626.
47 Climate differs across Europe and in order to meet the differing geographic climatic conditions it is necessary
48 to provide a range of tests to meet these variations. A range of optional, additional tests is provided to meet
49 the varying climatic needs and these should be agreed between the customer and the manufacturer and/or
50 the supplier (see Annex C).
51 This European Standard does not invalidate existing approvals of products achieved on the basis of national
52 standards and specifications and/or the demonstration of satisfactory service performance. However, products
53 approved according to such national standards or specifications cannot directly claim approval to this
54 European Standard. It may be possible, subject to agreement between the customer and the manufacturer
55 and/or the supplier, and/or the relevant conformity assessment body, to demonstrate that conformity to the
56 earlier standard can be used to claim conformity to this standard, provided an assessment is made of any
57 additional type testing that may need to be carried out. Any such additional testing that is part of a sequence
58 of testing cannot be done separately.
59 1 Scope
60 EN 50483 series applies to overhead line fittings for tensioning, supporting and connecting aerial bundled
61 cables (ABC) of rated voltage U /U (U ): 0,6/1 (1,2) kV.
0 m
62 This Part 6 defines the environmental tests in particular the climatic and corrosion ageing tests. The objective
63 of these tests is to predict the behaviour of ABC accessories when subjected to sun radiation, to weather
64 conditions (humidity, spraying water, heat, cold) and pollution. EN 50483-1, EN 50483-2, EN 50483-3 and
65 EN 50483-4 specify which type tests included in this part of the standard are needed.
66 2 Normative references
67 The following documents are referred to in the text in such a way that some or all of their content constitutes
68 requirements of this document. For dated references, only the edition cited applies. For undated references,
69 the latest edition of the referenced document (including any amendments) applies.
70 prEN 50483:2024 (series), Test requirements for low voltage aerial bundled cable accessories
71 EN IEC 60068-2-5:2018, Environmental testing – Part 2-5: Tests – Test S: Simulated solar radiation at ground
72 level and guidance for solar radiation testing and weathering (IEC 60068-2-5:2018)
73 EN IEC 60068-2-11:2021, Environmental testing – Part 2: Tests – Test Ka: Salt mist (IEC 60068-2-11:2021)
74 EN ISO 22479, Corrosion of metals and alloys - Sulfur dioxide test in a humid atmosphere (fixed gas method)
75 (ISO 22479)
76 IEC 60050-461, International Electrotechnical Vocabulary (IEV) – Part 461: Electric cables
77 3 Terms and definitions
78 For the purposes of this document, the terms and definitions given in IEC 60050-461 and the following apply.
79 ISO and IEC maintain terminology databases for use in standardization at the following addresses:
80 — ISO Online browsing platform: available at https://www.iso.org/obp/
81 — IEC Electropedia: available at https://www.electropedia.org/
82 3.1
83 aerial bundled cable (ABC)
84 aerial cable consisting of a group of insulated conductors which are twisted together including, or not, a non
85 insulated conductor
86 Note 1 to entry: The terms bundled conductors, bundled cables, bundled cores, conductor bundles and bundle could be
87 used as equivalent to the term aerial bundled cable (ABC).
88 [SOURCE: IEV 461-08-02, modified]
89 3.2
90 aerial-insulated-cable
91 insulated cable designed to be suspended overhead and outdoors
92 [SOURCE: IEV 461-08-01]
93 3.3
94 conductor (of a cable)
95 part of a cable which has the specific function of carrying current
96 [SOURCE: IEV 461-01-01]
97 3.4
98 core
99 assembly comprising conductor and its own insulation
100 [SOURCE: IEV 461-04-04, modified]
101 3.5
102 fixture (or fitting)
103 device for attaching ABC tension or/and suspension clamps to a pole or to a wall
104 3.6
105 insulation (of a cable)
106 insulating materials incorporated in a cable with the specific function of withstanding voltage
107 [SOURCE: IEV 461-02-01]
108 3.7
109 type test
110 test required to be made before supplying a type of material covered by this standard on a general
111 commercial basis, in order to demonstrate satisfactory performance characteristics to meet the intended
112 application
113 Note 1 to entry: These tests are of such a nature that, after they have been made, they need not be repeated unless
114 changes are made to the accessory materials, design or type of manufacturing process which might change the
115 performance characteristics.
116 4 Symbols
λ and λ wavelength of UV light source
1 2
E mean energy received by the samples
m
E radiated energy of the lamp
n number of cycles (defined in appropriate part of this standard)
θ temperature measured by the black standard thermometer
θ temperature of the chamber
E
117 5 Marking
118 Marking shall be according to Clause 6 of prEN 50483-1:2024.
119 6 Type tests
120 6.1 Number of test samples and number of cycles
121 The number of samples and number of cycles for each of the following tests are included in each relevant part
122 of EN 50483.
123 6.2 Requirements
124 The requirements for the following tests shall be as given in the relevant parts of this standard.
125 6.3 Cleaning
126 On completion of the environmental tests, and between different environmental tests when carried out as a
127 se
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.