Guidelines for the hosting capacity evaluation of distribution networks for distributed energy resources

IEC TS 63276:2024 specifies methods for the evaluation of the maximum export capacity of distributed energy resources (DER) that distribution networks can accommodate. It provides guidance on the technical constraints that should be considered in evaluating hosting capacity, information required to be collected to undertake a hosting capacity evaluation, and evaluation methods. This document is applicable to AC distribution networks operating at a nominal frequency of 50 Hz or 60 Hz.
This document does not specify allowable values of system parameters that can be impacted by the addition of DER on a distribution network, such as maximum or minimum voltage, maximum current, etc. These values are to be determined by the user, from international or national standards, local regulations or the like, and used as an input to the evaluation methods described in this document. This document is mainly used by distribution system operators (DSO) and other organizations with corresponding qualifications and capabilities. The evaluation results can serve the DER investors, DSO, energy sector regulators and other stakeholders as a decision-making basis.

General Information

Status
Published
Publication Date
16-Sep-2024
Current Stage
PPUB - Publication issued
Start Date
30-Aug-2024
Completion Date
17-Sep-2024
Ref Project

Buy Standard

Technical specification
IEC TS 63276:2024 - Guidelines for the hosting capacity evaluation of distribution networks for distributed energy resources Released:17. 09. 2024 Isbn:9782832296080
English language
30 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)


IEC TS 63276 ®
Edition 1.0 2024-09
TECHNICAL
SPECIFICATION
colour
inside
Guidelines for the hosting capacity evaluation of distribution networks for
distributed energy resources
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester. If you have any questions about IEC
copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or
your local IEC member National Committee for further information.

IEC Secretariat Tel.: +41 22 919 02 11
3, rue de Varembé info@iec.ch
CH-1211 Geneva 20 www.iec.ch
Switzerland
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.

About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigendum or an amendment might have been published.

IEC publications search - webstore.iec.ch/advsearchform IEC Products & Services Portal - products.iec.ch
The advanced search enables to find IEC publications by a Discover our powerful search engine and read freely all the
variety of criteria (reference number, text, technical publications previews, graphical symbols and the glossary.
committee, …). It also gives information on projects, replaced With a subscription you will always have access to up to date
and withdrawn publications. content tailored to your needs.

IEC Just Published - webstore.iec.ch/justpublished
Electropedia - www.electropedia.org
Stay up to date on all new IEC publications. Just Published
The world's leading online dictionary on electrotechnology,
details all new publications released. Available online and once
containing more than 22 500 terminological entries in English
a month by email.
and French, with equivalent terms in 25 additional languages.

Also known as the International Electrotechnical Vocabulary
IEC Customer Service Centre - webstore.iec.ch/csc
(IEV) online.
If you wish to give us your feedback on this publication or need

further assistance, please contact the Customer Service
Centre: sales@iec.ch.
IEC TS 63276 ®
Edition 1.0 2024-09
TECHNICAL
SPECIFICATION
colour
inside
Guidelines for the hosting capacity evaluation of distribution networks for

distributed energy resources
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
ICS 29.240.01  ISBN 978-2-8322-9608-0

– 2 – IEC TS 63276:2024 © IEC 2024
CONTENTS
FOREWORD . 4
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 7
4 Basic requirements of the evaluation . 8
4.1 Evaluation principle . 8
4.2 Evaluation scope and objects . 9
4.3 Impact factors . 9
4.3.1 Structure of distribution network . 9
4.3.2 Composition of existing power generation . 9
4.3.3 DER under construction or approved . 9
4.3.4 Load characteristics . 9
5 Evaluation contents . 9
5.1 Thermal rating . 9
5.2 Short-circuit current . 10
5.3 Voltage deviation . 11
5.4 Harmonic voltage . 11
5.5 Voltage unbalance . 11
5.6 Protection configuration . 12
6 Data preparation . 12
6.1 Data preparation . 12
6.1.1 Distribution network . 12
6.1.2 Equipment parameter . 12
6.1.3 Operating state . 13
6.1.4 Operating limit . 13
6.2 Data processing . 13
7 Evaluation method and process . 13
8 Evaluation results . 14
Annex A (informative) Sources and uses of data needed for hosting capacity
evaluation . 15
Annex B (normative) Evaluation process . 17
Annex C (normative) Evaluation grade . 18
Annex D (informative) Example of evaluation . 19
D.1 Basic information of the example . 19
D.2 Calculation of hosting capacity for DER . 20
Bibliography . 30

Figure B.1 – Evaluation process . 17
Figure D.1 – Single-line diagram of the example . 19
Figure D.2 – Operation data of typical day . 20
Figure D.3 – Result graph of hosting capacity evaluation . 29

Table A.1 – Data needed for hosting capacity evaluation . 15
Table C.1 – Evaluation grade . 18
Table D.1 – Sheet of thermal rating evaluation. 20

Table D.2 – Sheet of short-circuit current check . 21
Table D.3 – Sheet of voltage deviation check . 22
Table D.4 – Sheet of harmonic voltage check . 23
Table D.5 – Sheet of thermal rating evaluation (after adjustment) . 24
Table D.6 – Sheet of short-circuit current check (after adjustment) . 25
Table D.7 – Sheet of voltage deviation check (after adjustment) . 26
Table D.8 – Sheet of harmonic voltage check . 27
Table D.9 – Evaluation grades of the hosting capacity of distribution network for DER . 28

– 4 – IEC TS 63276:2024 © IEC 2024
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
GUIDELINES FOR THE HOSTING CAPACITY EVALUATION OF
DISTRIBUTION NETWORKS FOR DISTRIBUTED ENERGY RESOURCES

FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international
co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and
in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports,
Publicly Available Specifications (PAS) and Guides (hereafter referred to as "IEC Publication(s)"). Their
preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with
may participate in this preparatory work. International, governmental and non-governmental organizations liaising
with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for
Standardization (ISO) in accordance with conditions determined by agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence between
any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) IEC draws attention to the possibility that the implementation of this document may involve the use of (a)
patent(s). IEC takes no position concerning the evidence, validity or applicability of any claimed patent rights in
respect thereof. As of the date of publication of this document, IEC had not received notice of (a) patent(s), which
may be required to implement this document. However, implementers are cautioned that this may not represent
the latest information, which may be obtained from the patent database available at https://patents.iec.ch. IEC
shall not be held responsible for identifying any or all such patent rights.
IEC TS 63276 has been prepared by Subcommittee 8B: Decentralized electrical energy
systems, of IEC Technical Committee 8: System aspects of electrical energy supply. It is a
Technical Specification.
The text of this Technical Specification is based on the following documents:
Draft Report on voting
8B/212/DTS 8B/225/RVDTS
Full information on the voting for its approval can be found in the report on voting indicated in
the above table.
The language used for the development of this Technical Specification is English.

This document was drafted in accordance with ISO/IEC Directives, Part 2, and developed in
accordance with ISO/IEC Directives, Part 1 and ISO/IEC Directives, IEC Supplement, available
at www.iec.ch/members_experts/refdocs. The main document types developed by IEC are
described in greater detail at www.iec.ch/publications.
The committee has decided that the contents of this document will remain unchanged until the
stability date indicated on the IEC website under webstore.iec.ch in the data related to the
specific document. At this date, the document will be
• reconfirmed,
• withdrawn, or
• revised.
IMPORTANT – The "colour inside" logo on the cover page of this document indicates
that it contains colours which are conside
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.