ISO 6182-12:2019

Fire protection — Automatic sprinkler systems — Part 12: Requirements and test methods for grooved-end components for steel pipe systems

This document specifies performance requirements, grooving dimensions, test methods and marking requirements for couplings used in the joining of grooved steel tubes, pipes, grooved-end fittings and other grooved-end components up to 300 DN nominal diameter.

Protection contre l'incendie — Systèmes d'extinction automatiques du type sprinkler — Partie 12: Exigences et méthodes d'essai pour les raccords de tuyauterie en acier à extrémités rainurées

General Information

• Status: Published
• Publication Date: 24-Apr-2019
• ICS: 13.220.20 - Fire protection
• Technical Committee: ISO/TC 21/SC 5 - Fixed firefighting systems using water
• Drafting Committee: ISO/TC 21/SC 5/WG 11 - Pipes and fittings
• Current Stage: 9020 - International Standard under periodical review
• Start Date: 15-Apr-2024
• Completion Date: 15-Apr-2024

Relations

• Revises: ISO 6182-12:2014 - Fire protection — Automatic sprinkler systems — Part 12: Requirements and test methods for grooved-end components for steel pipe systems
• Effective Date: 05-Nov-2015

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 6182-12
Third edition
2019-04
Fire protection — Automatic sprinkler
systems —
Part 12:
Requirements and test methods for
grooved-end components for steel
pipe systems
Protection contre l'incendie — Systèmes d'extinction automatiques du
type sprinkler —
Partie 12: Exigences et méthodes d'essai pour les raccords de
tuyauterie en acier à extrémités rainurées
Reference number
ISO 6182-12:2019(E)
©
ISO 2019

---------------------- Page: 1 ----------------------
ISO 6182-12:2019(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2019
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii © ISO 2019 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 6182-12:2019(E)

Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms, definitions and abbreviated terms . 1
3.1 Terms and definitions . 1
3.2 Abbreviated terms . 2
4 Product consistency . 2
5 Product assembly. 2
6 Requirements . 3
6.1 Grooved-end dimensions . 3
6.2 Minimum pipe wall thickness . 3
6.3 Mechanical coupling housing . 3
6.4 Pressure-responsive gasket . 3
6.5 Bolts . 3
6.6 Nuts . 3
6.7 Hinge pins . 3
6.8 Flexible coupling . 3
6.9 Vacuum (see 7.2) .
...