ISO 6182-2:2012
(Main)Fire protection — Automatic sprinkler systems — Part 2: Requirements and test methods for wet alarm valves, retard chambers and water motor alarms
Fire protection — Automatic sprinkler systems — Part 2: Requirements and test methods for wet alarm valves, retard chambers and water motor alarms
ISO 6182-2:2012 specifies performance, requirements, methods of test and marking requirements, for wet alarm valves, retard chambers, water motor alarms and manufacturers' specified relevant trim used in wet pipe automatic fire protection systems. ISO 6182-2:2012 is not applicable to performance and test requirements for other auxiliary components or attachments to alarm valves.
Protection contre l'incendie — Systèmes d'extinction automatiques du type sprinkler — Partie 2: Exigences et méthodes d'essai des soupapes d'alarme hydrauliques, des limiteurs de surpression et des dispositifs d'alarme à moteur hydraulique
Požarna zaščita - Avtomatski sprinklerski sistemi - 2. del: Zahteve in preskusne metode za mokre alarmne ventile, zadrževalne komore in alarmne naprave na vodni pogon
Ta del standarda ISO 6182 opredeljuje zahteve glede delovanja, preskusne metode in zahteve glede označevanja za mokre alarmne ventile, zadrževalne komore in alarmne naprave na vodni pogon ter s strani proizvajalca določeno relevantno dodatno opremo ventila (»trim«), ki se uporablja v mokrih avtomatskih sistemih za požarno zaščito.
Ta del standarda ISO 6182 se ne uporablja za zahteve glede delovanja in preskušanja za druge dodatne komponente ali priključke na alarmne ventile.
General Information
Relations
Buy Standard
Standards Content (Sample)
SLOVENSKI STANDARD
SIST ISO 6182-2:2018
01-september-2018
1DGRPHãþD
SIST ISO 6182-2:1995
3RåDUQD]DãþLWD$YWRPDWVNLVSULQNOHUVNLVLVWHPLGHO=DKWHYHLQSUHVNXVQH
PHWRGH]DPRNUHDODUPQHYHQWLOH]DGUåHYDOQHNRPRUHLQDODUPQHQDSUDYHQD
YRGQLSRJRQ
Fire protection -- Automatic sprinkler systems -- Part 2: Requirements and test methods
for wet alarm valves, retard chambers and water motor alarms
Protection contre l'incendie -- Systèmes d'extinction automatiques du type sprinkler --
Partie 2: Exigences et méthodes d'essai des soupapes d'alarme hydrauliques, des
limiteurs de surpression et des dispositifs d'alarme à moteur hydraulique
Ta slovenski standard je istoveten z: ISO 6182-2:2012
ICS:
13.220.20 3RåDUQD]DãþLWD Fire protection
SIST ISO 6182-2:2018 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 6182-2:2018
---------------------- Page: 2 ----------------------
SIST ISO 6182-2:2018
INTERNATIONAL ISO
STANDARD 6182-2
Third edition
2012-12-01
Fire protection — Automatic
sprinkler systems —
Part 2:
Requirements and test methods for
wet alarm valves, retard chambers
and water motor alarms
Protection contre l’incendie — Systèmes d’extinction automatiques du
type sprinkler —
Partie 2: Exigences et méthodes d’essai des soupapes d’alarme
hydrauliques, des limiteurs de surpression et des dispositifs d’alarme à
moteur hydraulique
Reference number
ISO 6182-2:2012(E)
©
ISO 2012
---------------------- Page: 3 ----------------------
SIST ISO 6182-2:2018
ISO 6182-2:2012(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2012
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any
means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the
address below or ISO’s member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 6182-2:2018
ISO 6182-2:2012(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Requirements . 3
4.1 Nominal sizes . 3
4.2 Connections . 3
4.3 Rated working pressure . 3
4.4 Bodies and covers . 3
4.5 Strength (see 6.9) . 4
4.6 Access for maintenance . 4
4.7 Components . 4
4.8 Leakage (see 6.8) .
...
INTERNATIONAL ISO
STANDARD 6182-2
Third edition
2012-12-01
Fire protection — Automatic
sprinkler systems —
Part 2:
Requirements and test methods for
wet alarm valves, retard chambers
and water motor alarms
Protection contre l’incendie — Systèmes d’extinction automatiques du
type sprinkler —
Partie 2: Exigences et méthodes d’essai des soupapes d’alarme
hydrauliques, des limiteurs de surpression et des dispositifs d’alarme à
moteur hydraulique
Reference number
ISO 6182-2:2012(E)
©
ISO 2012
---------------------- Page: 1 ----------------------
ISO 6182-2:2012(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2012
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any
means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the
address below or ISO’s member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 6182-2:2012(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Requirements . 3
4.1 Nominal sizes . 3
4.2 Connections . 3
4.3 Rated working pressure . 3
4.4 Bodies and covers . 3
4.5 Strength (see 6.9) . 4
4.6 Access for maintenance . 4
4.7 Components . 4
4.8 Leakage (see 6.8) . 5
4.9 Non-metallic components (excluding gaskets, seals and other elastomeric parts) (see 6.4
and 6.5) . 5
4.10 Sealing assembly elements (see 6.3). 5
4.11 Clearances . 5
4.12 Hydraulic friction loss (see 6.7) . 7
4.13 Endurance (see 6.6) .
...
SLOVENSKI STANDARD
oSIST ISO 6182-2:2018
01-julij-2018
3RåDUQD]DãþLWD$YWRPDWVNLVSULQNOHUVNLVLVWHPLGHO=DKWHYHLQSUHVNXVQH
PHWRGH]DPRNUHDODUPQHYHQWLOH]DGUåHYDOQHNRPRUHLQDODUPQHQDSUDYHQD
YRGQLSRJRQ
Fire protection -- Automatic sprinkler systems -- Part 2: Requirements and test methods
for wet alarm valves, retard chambers and water motor alarms
Protection contre l'incendie -- Systèmes d'extinction automatiques du type sprinkler --
Partie 2: Exigences et méthodes d'essai des soupapes d'alarme hydrauliques, des
limiteurs de surpression et des dispositifs d'alarme à moteur hydraulique
Ta slovenski standard je istoveten z: ISO 6182-2:2012
ICS:
13.220.20 3RåDUQD]DãþLWD Fire protection
oSIST ISO 6182-2:2018 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST ISO 6182-2:2018
---------------------- Page: 2 ----------------------
oSIST ISO 6182-2:2018
INTERNATIONAL ISO
STANDARD 6182-2
Third edition
2012-12-01
Fire protection — Automatic
sprinkler systems —
Part 2:
Requirements and test methods for
wet alarm valves, retard chambers
and water motor alarms
Protection contre l’incendie — Systèmes d’extinction automatiques du
type sprinkler —
Partie 2: Exigences et méthodes d’essai des soupapes d’alarme
hydrauliques, des limiteurs de surpression et des dispositifs d’alarme à
moteur hydraulique
Reference number
ISO 6182-2:2012(E)
©
ISO 2012
---------------------- Page: 3 ----------------------
oSIST ISO 6182-2:2018
ISO 6182-2:2012(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2012
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any
means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the
address below or ISO’s member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved
---------------------- Page: 4 ----------------------
oSIST ISO 6182-2:2018
ISO 6182-2:2012(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Requirements . 3
4.1 Nominal sizes . 3
4.2 Connections . 3
4.3 Rated working pressure . 3
4.4 Bodies and covers . 3
4.5 Strength (see 6.9) . 4
4.6 Access for maintenance . 4
4.7 Components . 4
4.8 Leakage (see 6.8) .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.