Hydrometric determinations — Flow measurements in open channels using structures — Use of vertical underflow gates

This International Standard specifies methods for the determination of discharge in open channels in steady flow conditions using vertical underflow gates on a flat horizontal floor between vertical side walls under modular or non-modular conditions.

Déterminations hydrométriques — Mesure de débit dans les canaux découverts au moyen de structures — Emploi de portes verticales à passage subaquatique

General Information

Status
Published
Publication Date
17-Apr-2002
Current Stage
9093 - International Standard confirmed
Completion Date
15-Dec-2023
Ref Project

Buy Standard

Standard
ISO 13550:2002 - Hydrometric determinations -- Flow measurements in open channels using structures -- Use of vertical underflow gates and radial gates
English language
25 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 13550
First edition
2002-04-01


Hydrometric determinations — Flow
measurements in open channels using
structures — Use of vertical underflow
gates
Déterminations hydrométriques — Mesure de débit dans les canaux
découverts au moyen de structures — Emploi de portes verticales à
passage subaquatique




Reference number
ISO 13550:2002(E)
©
 ISO 2002

---------------------- Page: 1 ----------------------
ISO 13550:2002(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not
be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this
area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.


©  ISO 2002
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body
in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.ch
Web www.iso.ch
Printed in Switzerland

ii © ISO 2002 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 13550:2002(E)
Contents Page
Foreword.iv
1 Scope .1
2 Normative references.1
3 Terms, definitions and symbols.1
4 Units of measurement.2
5 General requirements.2
5.1 General.2
5.2 Site selection.2
5.3 Installation conditions.3
6 Maintenance .4
7 Measurement of head.4
7.1 General.4
7.2 Stilling or float well.4
7.3 Zero setting .5
8 Vertical underflow gates .5
8.1 Description of vertical underflow gates .5
8.2 Location of the head measurement section .7
8.3 Location of the tailwater level measurement section.7
8.4 Flow types .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.