ISO/TS 22809:2007

Non-destructive testing — Discontinuities in specimens for use in qualification examinations

ISO/TS 22809:2007 has been established to consider and define types of discontinuities to be exhibited in test specimens for use in non-destructive testing examinations.

Essais non destructifs — Discontinuités dans les échantillons d'essai utilisés pour les examens de qualification

General Information

• Status: Published
• Publication Date: 05-Nov-2007
• ICS: 03.100.30 - Management of human resources
• ICS: 19.100 - Non-destructive testing
• Technical Committee: ISO/TC 135/SC 7 - Personnel qualification
• Drafting Committee: ISO/TC 135/SC 7 - Personnel qualification
• Current Stage: 9020 - International Standard under periodical review
• Start Date: 15-Apr-2024
• Completion Date: 15-Apr-2024

Standards Content (Sample)

TECHNICAL ISO/TS
SPECIFICATION 22809
First edition
2007-11-15

Non-destructive testing — Discontinuities
in specimens for use in qualification
examinations
Essais non destructifs — Discontinuités dans les échantillons d'essai
utilisés pour les examens de qualification




Reference number
ISO/TS 22809:2007(E)
©
ISO 2007

---------------------- Page: 1 ----------------------
ISO/TS 22809:2007(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2007
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland

ii © ISO 2007 – All rights reserved

---------------------- Page: 2 ----------------------
ISO/TS 22809:2007(E)
Contents Page
Foreword. iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions. 1
4 Specimens . 1
5 Product sectors. 2
5.1 General. 2
5.2 Castings (c) . 2
5.3 Welded test specimens (w). 2
5.4 Wrought test specimen (wp). 3
5.5 Forgings (f) . 3
5.6 Tubes and pipes (t). 3
6 Minimum size of discontinuity . 4
6.1 General. 4
6.2 Radiographic testing (RT). 4
6.3 Ultrasonic testing (UT) . 4
6.4 Magnetic particle (MT) and liquid penetrant testing (PT) . 5
6.5 Eddy current testing (ET). 5
6.6 Visual testing (VT). 5
7 Surface conditions.
...