ISO 579:1999
(Main)Coke — Determination of total moisture
Coke — Determination of total moisture
Coke — Détermination de l'humidité totale
Koks - Ugotavljanje celotne vlage
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 579
Third edition
1999-12-15
Coke — Determination of total moisture
Coke — Détermination de l´humidité totale
Reference number
ISO 579:1999(E)
©
ISO 1999
---------------------- Page: 1 ----------------------
ISO 579:1999(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not
be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this
area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 1999
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body
in the country of the requester.
ISO copyright office
Case postale 56 � CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 734 10 79
E-mail copyright@iso.ch
Web www.iso.ch
Printed in Switzerland
ii © ISO 1999 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 579:1999(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO
member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has
the right to be represented on that committee. International organizations, governmental and non-governmental, in
liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical
Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
International Standard ISO 579 was prepared by Technical Committee ISO/TC 27, Solid mineral fuels,
Subcommittee SC 5, Methods of analysis.
This third edition cancels and replaces the second edition (ISO 579:1981), which has been technically revised.
© ISO 1999 – All rights reserved iii
---------------------- Page: 3 ----------------------
INTERNATIONAL STANDARD ISO 579:1999(E)
Coke — Determination of total moisture
1 Scope
This International Standard specifies a method for determining the total moisture of coke. It can be used for the
determination of moisture of blast-furnace coke, foundry coke and other high-temperature carbonization products.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of
this International Standard. For dated references, subsequent amendments to, or revisions of, any of these
publications do not apply. However, parties to agreements based on this International Standard are encouraged to
investigate the possibility of applying the most recent editions of the normative documents indicated below. For
undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC
maintain registers of currently valid International Standards.
ISO 9411-2, Solid mineral fuels — Mechanical sampling from moving streams — Part 2: Coke.
1)
ISO 13909-6:— , Hard coal and coke — Mechanical sampling — Part 6: Coke — Preparation of test samples.
3Principle
A sample is heated in air at 120 °C to 200 °C and maintained at this temperature until constant in mass. The
moistu
...
SLOVENSKI STANDARD
SIST ISO 579:2002
01-januar-2002
Koks - Ugotavljanje celotne vlage
Coke -- Determination of total moisture
Coke -- Détermination de l'humidité totale
Ta slovenski standard je istoveten z: ISO 579:1999
ICS:
75.160.10 Trda goriva Solid fuels
SIST ISO 579:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 579:2002
---------------------- Page: 2 ----------------------
SIST ISO 579:2002
INTERNATIONAL ISO
STANDARD 579
Third edition
1999-12-15
Coke — Determination of total moisture
Coke — Détermination de l´humidité totale
Reference number
ISO 579:1999(E)
©
ISO 1999
---------------------- Page: 3 ----------------------
SIST ISO 579:2002
ISO 579:1999(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not
be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this
area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 1999
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body
in the country of the requester.
ISO copyright office
Case postale 56 � CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 734 10 79
E-mail copyright@iso.ch
Web www.iso.ch
Printed in Switzerland
ii © ISO 1999 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 579:2002
ISO 579:1999(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO
member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has
the right to be represented on that committee. International organizations, governmental and non-governmental, in
liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical
Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
International Standard ISO 579 was prepared by Technical Committee ISO/TC 27, Solid mineral fuels,
Subcommittee SC 5, Methods of analysis.
This third edition cancels and replaces the second edition (ISO 579:1981), which has been technically revised.
© ISO 1999 – All rights reserved iii
---------------------- Page: 5 ----------------------
SIST ISO 579:2002
---------------------- Page: 6 ----------------------
SIST ISO 579:2002
INTERNATIONAL STANDARD ISO 579:1999(E)
Coke — Determination of total moisture
1 Scope
This International Standard specifies a method for determining the total moisture of coke. It can be used for the
determination of moisture of blast-furnace coke, foundry coke and other high-temperature carbonization products.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of
this International Standard. For dated references, subsequent amendments to, or revisions of, any of these
publications do not apply. However, parties to agreements based on this International Standard are encouraged to
investigate the possibility of applying the most recent editions of the normative documents indicated below. For
undated references, the latest edition of the normative document referred to applies. Members of ISO a
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.