ISO 13061-2:2014/Amd 1:2017

Physical and mechanical properties of wood - Test methods for small clear wood specimens - Part 2: Determination of density for physical and mechanical tests - Amendment 1

Propriétés physiques et mécaniques du bois — Méthodes d'essais sur petites éprouvettes de bois sans défauts — Partie 2: Détermination de la masse volumique en vue des essais physiques et mécaniques — Amendement 1

General Information

• Status: Published
• Publication Date: 11-Jul-2017
• ICS: 79.040 - Wood, sawlogs and sawn timber
• Technical Committee: ISO/TC 218 - Timber
• Drafting Committee: ISO/TC 218/WG 4 - Test methods
• Current Stage: 6060 - International Standard published
• Start Date: 12-Jul-2017
• Due Date: 10-Jan-2020
• Completion Date: 10-Jan-2020

Relations

• Consolidated By: ISO 15876-3:2017/Amd 1:2020 - Plastics piping systems for hot and cold water installations - Polybutene (PB) - Part 3: Fittings - Amendment 1
• Effective Date: 06-Jun-2022
• Amends: ISO 13061-2:2014 - Physical and mechanical properties of wood - Test methods for small clear wood specimens - Part 2: Determination of density for physical and mechanical tests
• Effective Date: 09-May-2020

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 13061-2
First edition
2014-10-01
AMENDMENT 1
2017-06
Physical and mechanical properties of
wood — Test methods for small clear
wood specimens —
Part 2:
Determination of density for physical
and mechanical tests
AMENDMENT 1
Propriétés physiques et mécaniques du bois — Méthodes d’essais sur
petites éprouvettes de bois sans défauts —
Partie 2: Détermination de la masse volumique en vue des essais
physiques et mécaniques
AMENDEMENT 1
Reference number
ISO 13061-2:2014/Amd.1:2017(E)
©
ISO 2017
ISO 13061-2:2014/Amd.1:2017(E)

© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2017 – All rights reserved

ISO 13061-2:2014/Amd.1:2017(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to devel
...