ISO 8121:2007

Textile machinery — Knitting machines — Nameplate information

ISO 8121:2007 specifies the minimum information for the nameplates on knitting machines used in the textile industry.

Matériel pour l'industrie textile — Machines à tricoter — Caractéristiques des plaques d'identification

General Information

• Status: Published
• Publication Date: 29-Jul-2007
• ICS: 59.120.40 - Knitting machines
• Technical Committee: ISO/TC 72/SC 3 - Machinery for fabric manufacturing including preparatory machinery and accessories
• Drafting Committee: ISO/TC 72/SC 3 - Machinery for fabric manufacturing including preparatory machinery and accessories
• Current Stage: 9060 - Close of review
• Start Date: 02-Dec-2028

Relations

• Revises: ISO 8121:1986 - Textile machinery — Knitting machines — Nameplate information
• Effective Date: 15-Apr-2008
• Revises: ISO 8121:1986/Cor 1:1992 - Textile machinery — Knitting machines — Nameplate information — Technical Corrigendum 1
• Effective Date: 15-Apr-2008

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 8121
Second edition
2007-08-01

Textile machinery — Knitting machines —
Nameplate information
Matériel pour l'industrie textile — Machines à tricoter —
Caractéristiques des plaques d'identification




Reference number
ISO 8121:2007(E)
©
ISO 2007

---------------------- Page: 1 ----------------------
ISO 8121:2007(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2007
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland

ii © ISO 2007 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 8121:2007(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of t
...