ISO 13061-4:2014/Amd 1:2017

Physical and mechanical properties of wood — Test methods for small clear wood specimens — Part 4: Determination of modulus of elasticity in static bending — Amendment 1

Propriétés physiques et mécaniques du bois — Méthodes d'essais sur petites éprouvettes de bois sans défauts — Partie 4: Détermination du module d'élasticité en flexion statique — Amendement 1

General Information

• Status: Published
• Publication Date: 11-Jul-2017
• ICS: 79.040 - Wood, sawlogs and sawn timber
• Technical Committee: ISO/TC 218 - Timber
• Drafting Committee: ISO/TC 218/WG 4 - Test methods
• Current Stage: 6060 - International Standard published
• Due Date: 10-Jan-2020
• Completion Date: 12-Jul-2017

Relations

• Amends: ISO 13061-4:2014 - Physical and mechanical properties of wood — Test methods for small clear wood specimens — Part 4: Determination of modulus of elasticity in static bending
• Effective Date: 18-Dec-2021
• Consolidated By: ISO 9053-2:2020 - Acoustics — Determination of airflow resistance — Part 2: Alternating airflow method
• Effective Date: 06-Jun-2022

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 13061-4
First edition
2014-12-01
AMENDMENT 1
2017-06
Physical and mechanical properties of
wood — Test methods for small clear
wood specimens —
Part 4:
Determination of modulus of elasticity
in static bending
AMENDMENT 1
Propriétés physiques et mécaniques du bois — Méthodes d’essais sur
petites éprouvettes de bois sans défauts —
Partie 4: Détermination du module d’élasticité en flexion statique
AMENDEMENT 1
Reference number
ISO 13061-4:2014/Amd.1:2017(E)
©
ISO 2017

---------------------- Page: 1 ----------------------
ISO 13061-4:2014/Amd.1:2017(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2017 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 13061-4:2014/Amd.1:2017(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This
...