ISO 1215:2015
(Main)Virgin cork, raw reproduction cork, ramassage, gleanings, burnt cork, corkwaste, boiled cork pieces and raw corkwaste — Definitions and packaging
Virgin cork, raw reproduction cork, ramassage, gleanings, burnt cork, corkwaste, boiled cork pieces and raw corkwaste — Definitions and packaging
ISO 1215:2015 applies to commercially dry virgin cork, raw reproduction cork, ramassage, gleanings, burnt cork, corkwaste, boiled cork pieces, and boiled corkwaste and specifies the conditions of packaging for each type.
Liège mâle, liège de reproduction cru, liège de ramassage, liège gisant, liège flambé, déchets, morceaux de liège bouillis et rebuts bouillis — Définitions et emballage
ISO 1215:2015 définit le liège mâle, liège de reproduction cru, liège de ramassage, liège gisant, liège flambé, déchets, morceaux de liège bouillis et rebuts bouillis, et spécifie leur emballages.
General Information
Relations
Buy Standard
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 1215
Redline version
compares Third edition to
Second edition
Virgin cork, raw reproduction cork,
ramassage, gleanings, burnt cork,
corkwaste, boiled cork pieces and
raw corkwaste — Definitions and
packaging
Liège mâle, liège de reproduction cru, liège de ramassage, liège
gisant, liège flambé, déchets, morceaux de liège bouillis et rebuts
bouillis — Définitions et emballage
Reference number
ISO 1215:redline:2015(E)
©
ISO 2015
---------------------- Page: 1 ----------------------
ISO 1215:redline:2015(E)
IMPORTANT — PLEASE NOTE
This is a mark-up copy and uses the following colour coding:
Text example 1 — indicates added text (in green)
Text example 2 — indicates removed text (in red)
— indicates added graphic figure
— indicates removed graphic figure
1.x . — Heading numbers containg modifications are highlighted in yellow in
the Table of Contents
All changes in this document have yet to reach concensus by vote and as such should only
be used internally for review purposes.
DISCLAIMER
This Redline version provides you with a quick and easy way to compare the main changes
between this edition of the standard and its previous edition. It doesn’t capture all single
changes such as punctuation but highlights the modifications providing customers with
the most valuable information. Therefore it is important to note that this Redline version is
not the official ISO standard and that the users must consult with the clean version of the
standard, which is the official standard, for implementation purposes.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 1215:redline:2015(E)
Contents Page
Foreword .iv
1 Scope and field of application . 1
2 References Normative references. 1
3 Definitions Terms and definitions . 1
4 Packaging . 1
5 Marking . 2
6 Loss in transit Losses during transport . 2
© ISO 2015 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 1215:redline:2015(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
Draft International Standards adopted by the technical committees are circulated to the member
bodies for approval before their acceptance as International Standards by the ISO Council. They are
approvedThe procedures used to develop this document and those intended for its further maintenance
are described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for
the different types of ISO documents should be noted. This document was drafted in accordance with
ISO procedures requiring at least 75 % approval by the member bodies votingthe editorial rules of the
ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held resp
...
INTERNATIONAL ISO
STANDARD 1215
Third edition
2015-05-15
Virgin cork, raw reproduction cork,
ramassage, gleanings, burnt cork,
corkwaste, boiled cork pieces and raw
corkwaste — Definitions and packaging
Liège mâle, liège de reproduction cru, liège de ramassage, liège
gisant, liège flambé, déchets, morceaux de liège bouillis et rebuts
bouillis — Définitions et emballage
Reference number
ISO 1215:2015(E)
©
ISO 2015
---------------------- Page: 1 ----------------------
ISO 1215:2015(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 1215:2015(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Packaging . 1
5 Marking . 1
6 Losses during transport . 2
© ISO 2015 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 1215:2015(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different
...
NORME ISO
INTERNATIONALE 1215
Troisième édition
2015-05-15
Liège mâle, liège de reproduction
cru, liège de ramassage, liège gisant,
liège flambé, déchets, morceaux de
liège bouillis et rebuts bouillis —
Définitions et emballage
Virgin cork, raw reproduction cork, ramassage, gleanings, burnt
cork, corkwaste, boiled cork pieces and raw corkwaste — Definitions
and packaging
Numéro de référence
ISO 1215:2015(F)
©
ISO 2015
---------------------- Page: 1 ----------------------
ISO 1215:2015(F)
DOCUMENT PROTÉGÉ PAR COPYRIGHT
© ISO 2015
Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduite ni utilisée
sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie, l’affichage sur
l’internet ou sur un Intranet, sans autorisation écrite préalable. Les demandes d’autorisation peuvent être adressées à l’ISO à
l’adresse ci-après ou au comité membre de l’ISO dans le pays du demandeur.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Publié en Suisse
ii © ISO 2015 – Tous droits réservés
---------------------- Page: 2 ----------------------
ISO 1215:2015(F)
Sommaire Page
Avant-propos .iv
1 Domaine d’application . 1
2 Références normatives . 1
3 Termes et définitions . 1
4 Emballage. 1
5 Marquage . 1
6 Pertes lors du transport . 2
© ISO 2015 – Tous droits réservés iii
---------------------- Page: 3 ----------------------
ISO 1215:2015(F)
Avant-propos
L’ISO (Organisation internationale de normalisation) est une fédération mondiale d’organismes
nationaux de normalisation (comités membres de l’ISO). L’élaboration des Normes internationales est
en général confiée aux comités techniques de l’ISO. Chaque comité membre intéressé par une étude
a le droit de faire partie du comité technique créé à cet effet. Les organisations internationales,
gouvernementales et non gouvernementales, en liaison avec l’ISO participent également aux travaux.
L’ISO collabore étroitement avec la Commission électrotechnique internationale (IEC) en ce qui concerne
la normalisation électrotechnique.
Les procédures utilisées pour élaborer le présent document et celles destinées à sa mise à jour sont
décrites dans les Directives ISO/IEC, Partie 1. Il convient, en particulier de prendre note des différents
critères d’approbation requis pour les différents types de documents ISO. Le présent document a été
rédigé conformément aux règles de rédaction données dans les Directives ISO/IEC, Partie 2 (voir www.
iso.org/directives).
L’attention est
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.