ISO 23873:2010
(Main)Hard coal — Method for the measurement of the swelling of hard coal using a dilatometer
Hard coal — Method for the measurement of the swelling of hard coal using a dilatometer
ISO 23873:2010 describes a method for the measurement of the swelling of hard coal using a dilatometer.
Houille — Méthode pour le mesurage du gonflement de la houille au moyen d'un dilatomètre
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 23873
First edition
2010-11-15
Hard coal — Method for the measurement
of the swelling of hard coal using a
dilatometer
Houille — Méthode pour le mesurage du gonflement de la houille au
moyen d'un dilatomètre
Reference number
ISO 23873:2010(E)
©
ISO 2010
---------------------- Page: 1 ----------------------
ISO 23873:2010(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2010
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2010 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 23873:2010(E)
Contents Page
Foreword .iv
Introduction.v
1 Scope.1
2 Normative references.1
3 Terms and definitions .1
4 Principle .2
5 Materials .2
6 Apparatus.2
6.1 Mould and accessories.2
6.2 Dilatometer.3
6.3 Dilatometer furnace.3
6.4 Temperature controller .4
6.5 Temperature recorder .4
6.6 Retort and piston.4
6.7 Means of recording piston movement .4
6.8 Cleaning instruments.4
7 Procedure.5
7.1 Temperature calibration.5
7.2 Preparation of test sample and test pieces .5
7.3 Determination .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.