ISO 6460-1:2007/Amd 1:2015

Motorcycles — Measurement method for gaseous exhaust emissions and fuel consumption — Part 1: General test requirements — Amendment 1

Motocycles — Méthode de mesure des émissions de gaz d'échappement et de la consommation de carburant — Partie 1: Exigences générales d'essai — Amendement 1

General Information

• Status: Withdrawn
• Publication Date: 05-Nov-2015
• ICS: 13.040.50 - Transport exhaust emissions
• ICS: 43.140 - Motorcycles and mopeds
• Technical Committee: ISO/TC 22/SC 38 - Motorcycles and mopeds
• Drafting Committee: ISO/TC 22/SC 38/WG 1 - Pollution and energy
• Current Stage: 9599 - Withdrawal of International Standard
• Completion Date: 10-Feb-2022

Relations

• Revised: ISO 6460-1:2022 - Motorcycles — Measurement method for gaseous exhaust emissions and fuel consumption — Part 1: General test requirements
• Effective Date: 23-Apr-2020
• Amends: ISO 6460-1:2007 - Motorcycles — Measurement method for gaseous exhaust emissions and fuel consumption — Part 1: General test requirements
• Effective Date: 14-Oct-2020

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 6460-1
First edition
2007-08-15
AMENDMENT 1
2015-11-01
Motorcycles — Measurement method
for gaseous exhaust emissions and
fuel consumption —
Part 1:
General test requirements
AMENDMENT 1
Motocycles — Méthode de mesure des émissions de gaz
d’échappement et de la consommation de carburant —
Partie 1: Exigences générales d’essai
AMENDEMENT 1
Reference number
ISO 6460-1:2007/Amd.1:2015(E)
©
ISO 2015

---------------------- Page: 1 ----------------------
ISO 6460-1:2007/Amd.1:2015(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2015 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 6460-1:2007/Amd.1:2015(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standar
...