ISO/IEC 18092:2023

Telecommunications and information exchange between systems — Near Field Communication Interface and Protocol 1 (NFCIP-1)

This document defines: — communication modes for Near Field Communication Interface and Protocol 1 (NFCIP-1) using inductive coupled devices operating at the centre frequency of 13,56 MHz for interconnection of computer peripherals; — both the active and the passive communication modes of NFCIP-1 to realize a communication network using Near Field Communication (NFC) devices for networked products and for consumer equipment; — a transport protocol including protocol activation and data exchange methods. This document specifies: — modulation schemes; — codings; — bit rates; — frame format of the radio frequency (RF) interface; — initialisation schemes and conditions required for data collision control during initialisation. Information interchange between systems is based on agreement between the interchange parties upon the interchange codes and the data structure.

Télécommunications et échange d'information entre systèmes — Interface et protocole 1 de communication en champ proche (NFCIP-1)

General Information

• Status: Published
• Publication Date: 07-Dec-2023
• ICS: 35.100.10 - Physical layer
• Technical Committee: ISO/IEC JTC 1/SC 6 - Telecommunications and information exchange between systems
• Drafting Committee: ISO/IEC JTC 1/SC 6 - Telecommunications and information exchange between systems
• Current Stage: 6060 - International Standard published
• Start Date: 08-Dec-2023
• Due Date: 12-Nov-2023
• Completion Date: 08-Dec-2023

Relations

• Revises: ISO/IEC 18092:2013 - Information technology — Telecommunications and information exchange between systems — Near Field Communication — Interface and Protocol (NFCIP-1)
• Effective Date: 06-Jun-2022

Standards Content (Sample)

INTERNATIONAL ISO/IEC
STANDARD 18092
Third edition
2023-12
Telecommunications and information
exchange between systems — Near
Field Communication Interface and
Protocol 1 (NFCIP-1)
Télécommunications et échange d'information entre systèmes —
Interface et protocole 1 de communication en champ proche
(NFCIP-1)
Reference number
ISO/IEC 18092:2023(E)
© ISO/IEC 2023

---------------------- Page: 1 ----------------------
ISO/IEC 18092:2023(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO/IEC 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii
  © ISO/IEC 2023 – All rights reserved

---------------------- Page: 2 ----------------------
ISO/IEC 18092:2023(E)
Contents Page
Foreword .v
Introduction . vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols and abbreviated terms.3
5 Conventions and notations . .6
5.1 Representation of numbers . 6
5.2 Names . 6
6 Conformance . 6
7 General . 6
8 RF field . 6
8.1 Values . 6
8.2 Passive communication mode . 7
8.3 Active communication mode. 7
8.4 External RF field detection . . 7
9 RF signal interface . 7
9.1 General .
...

FINAL
INTERNATIONAL ISO/IEC
DRAFT
STANDARD FDIS
18092
ISO/IEC JTC 1/SC 6
Telecommunications and information
Secretariat: KATS
exchange between systems — Near
Voting begins on:
2023-09-01 Field Communication Interface and
Protocol 1 (NFCIP-1)
Voting terminates on:
2023-10-27
Télécommunications et échange d'information entre systèmes —
Communication de champ proche — Interface et protocole (NFCIP-1)
RECIPIENTS OF THIS DRAFT ARE INVITED TO
SUBMIT, WITH THEIR COMMENTS, NOTIFICATION
OF ANY RELEVANT PATENT RIGHTS OF WHICH
THEY ARE AWARE AND TO PROVIDE SUPPOR TING
DOCUMENTATION.
IN ADDITION TO THEIR EVALUATION AS
Reference number
BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO-
ISO/IEC FDIS 18092:2023(E)
LOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON
OCCASION HAVE TO BE CONSIDERED IN THE
LIGHT OF THEIR POTENTIAL TO BECOME STAN-
DARDS TO WHICH REFERENCE MAY BE MADE IN
NATIONAL REGULATIONS. © ISO/IEC 2023

---------------------- Page: 1 ----------------------
ISO/IEC FDIS 18092:2023(E)
FINAL
INTERNATIONAL ISO/IEC
DRAFT
STANDARD FDIS
18092
ISO/IEC JTC 1/SC 6
Telecommunications and information
Secretariat: KATS
exchange between systems — Near
Voting begins on:
Field Communication Interface and
Protocol 1 (NFCIP-1)
Voting terminates on:
Télécommunications et échange d'information entre systèmes —
Communication de champ proche — Interface et protocole (NFCIP-1)
COPYRIGHT PROTECTED DOCUMENT
© ISO/IEC 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
RECIPIENTS OF THIS DRAFT ARE INVITED TO
ISO copyright office
SUBMIT, WITH THEIR COMMENTS, NOTIFICATION
OF ANY RELEVANT PATENT RIGHTS OF WHICH
CP 401 • Ch. de Blandonnet 8
THEY ARE AWARE AND TO PROVIDE SUPPOR TING
CH-1214 Vernier, Geneva
DOCUMENTATION.
Phone: [phone]
IN ADDITION TO THEIR EVALUATION AS
Reference number
Email: [e-mail]
BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO­
ISO/IEC FDIS 18092:2023(E)
Website: www.iso.org
LOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON
Published in Switzerland
OCCASION HAVE TO BE CONSIDERED IN THE
LIGHT OF THEIR POTENTIAL TO BECOME STAN­
DARDS TO WHICH REFERENCE MAY BE MADE IN
ii
  © ISO/IEC 2023 – All rights reserved
NATIONAL REGULATIONS. © ISO/IEC 2023

---------------------- Page: 2 ----------------------
ISO/IEC FDIS 18092:2023(E)
Contents Page
Foreword .v
Introduction . vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols and abbreviated terms.3
5 Conventions and notations . .6
5.1 Representation of numbers . 6
5.2 Names . 6
6 Conformance . 6
7 General .
...

2023-04-25
ISO/IEC FDIS 18092:2023(E)
ISO/IEC JTC 1/SC 6 N
ISO/IEC FDIS 18092
ISO/IEC JTC 1/SC 6
Secretariat:  KATSKATS
Telecommunications and information exchange between systems — Near
Field Communication Interface and Protocol 1 (NFCIP-1)
Télécommunications et échange d'information entre systèmes — Communication de champ
proche Interface et protocole (NFCIP-1)
Document type:
Document subtype:
Document stage:
Document language:

---------------------- Page: 1 ----------------------
Copyright notice
This ISO document is a working draftDate: 2023-08-18
Telecommunications and information exchange between
systems — Near Field Communication Interface and Protocol 1
(NFCIP-1)
Télécommunications et échange d'information entre systèmes — Communication de champ proche —
Interface et protocole (NFCIP-1)
FDIS stage
Document type:
Document subtype:
Document stage:
Document language:

---------------------- Page: 2 ----------------------
ISO/IEC FDIS 18092:2023(E)
© ISO/IEC 2023
All rights reserved. Unless otherwise specified, or committee draft and is copyright-protected by ISO. While
required in the reproductioncontext of working drafts or committee drafts in any form for use by participants in
the ISO standards development process is permitted without prior permission from ISO, neither its
implementation, no part of this document nor any extract from itpublication may be reproduced, stored or
utilized otherwise in any form or transmitted in any form for any other purposeby any means, electronic or
mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission.
Permission can be requested from either ISO.
Requests for permission to reproduce this document for at the purpose of selling it should be addressed as
shownaddress below or to ISO'sISO’s member body in the country of the requester:.
[Indicate the full address, telephone number, fax number, telex number, and electronic mail address, as
appropriate, of the Copyright Manager of the ISO member body responsible for the secretariat of the TC or SC
within the framework of which the working document has been prepared.]
Reproduction for sales purposes may be subject to royalty payments or a licensing agreement.
Violators may be prosecuted.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: + 41 22 749 01 11
E-mail: [e-mail]
Website: www.iso.org
Published in Switzerland
ISO/IEC 2022 – All rights reserved
iii
© ISO/IEC 2023 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO/IEC FDIS 18092:2023(E)


ISO/IEC 2022 – All rights reserved
iv
iv © ISO/IEC 2023 – All rights reserved

---------------------- Page: 4 ----------------------
ISO/IEC FDIS 18092:2023(E)
Foreword
ISO (the International Organization for Standardization) and IEC (the International Electrotechnical
Commission) form the specialized system for worldwide standardization. National bodies that are
members of ISO or IEC participate in the development of International Standards through technical
committees established by the respective organization to deal with particular fields of technical activity.
ISO and IEC technical committees collaborate in fields of mutual interest. Other international
organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the
work.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of document should be noted. This document was drafted in accordance with the editorial
rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directiveswww.iso.org/directives or
www.iec.ch/members_experts/refdocs).
Field Code Changed
Attention is drawnISO and IEC draw attention to the possibility that some of the elementsimplementation
of this document may beinvolve the subjectuse of (a) patent(s). ISO and IEC take no position concerning
the evidence, validity or applicability of any claimed patent rights. in respect thereof. As of the date of
publication of this document, ISO and IEC had not received notice of (a) patent(s) which may be required
to implement this document. However, implementers are cautioned that this may not represent the latest
information, which may be obtained from the patent database available at www.iso.org/patents and
https://patents.iec.ch. ISO and IEC shall not be held responsible for identifying any or all such patent
rights. Details of any patent rights identified during the development of the document will be in the
Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents) or the IEC
list of patent declarations received (see https://patents.iec.ch).
Any trade name used in this document is information
...