SIST EN 50083-10:2000
(Main)Cable networks for television signals, sound signals and interactive services -- Part 10: System performance for return paths
Cable networks for television signals, sound signals and interactive services -- Part 10: System performance for return paths
This standard is dealing with the transparent return path of cable networks operated in the frequency range between 5 MHz and 65 MHz or parts thereof. Higher frequencies may be used in fibre based networks. NOTE: In addition it is possible to use the frequency range from 0 to 5 MHz for return path transmissions, e.g. for NMS or other control, monitoring and signaling purposes. Applications below 5 MHz are not covered by this standard. An active return path carries typically only return signals. A passive return path can be used for both return and forward signals. This standard lays down the basic methods of measurement for signals typically used in the return path of cable networks in order to assess the performance of those signals and their performance limits. All requirements refer to the performance limits which shall be obtained between the reference points (figure 1) of the return path system. One reference point is the network termination close to the subscriber. It is the last point where all forward and return signals are present and carried on the same cable. If no network termination point exists, the reference point is the system outlet. The other reference point is the input of the return signal receiver (or transceiver). At this point the transparent signal path ends and behind this point the signal is treated in a non-transparent way. The return signal receiver can be situated at the headend but can also be at the node of the coaxial cell or at any other point of the network.
Kabelnetze für Fernsehsignale, Tonsignale und interaktive Dienste -- Teil 10: Rückkanal-Systemanforderungen
Réseaux de distribution par câbles pour signaux de télévision, signaux de radiodiffusion sonore et services interactifs -- Partie 10: Caractéristiques des systèmes de voie de retour
Cable networks for television signals, sound signals and interactive services - Part 10: System preformance for return
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 50083-10:2000
01-april-2000
Cable networks for television signals, sound signals and interactive services - Part
10: System preformance for return
Cable networks for television signals, sound signals and interactive services -- Part 10:
System performance for return paths
Kabelnetze für Fernsehsignale, Tonsignale und interaktive Dienste -- Teil 10: Rückkanal-
Systemanforderungen
Réseaux de distribution par câbles pour signaux de télévision, signaux de radiodiffusion
sonore et services interactifs -- Partie 10: Caractéristiques des systèmes de voie de
retour
Ta slovenski standard je istoveten z: EN 50083-10:1999
ICS:
33.060.40 Kabelski razdelilni sistemi Cabled distribution systems
SIST EN 50083-10:2000 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 50083-10:2000
---------------------- Page: 2 ----------------------
SIST EN 50083-10:2000
---------------------- Page: 3 ----------------------
SIST EN 50083-10:2000
---------------------- Page: 4 ----------------------
SIST EN 50083-10:2000
---------------------- Page: 5 ----------------------
SIST EN 50083-10:2000
---------------------- Page: 6 ----------------------
SIST EN 50083-10:2000
---------------------- Page: 7 ----------------------
SIST EN 50083-10:2000
---------------------- Page: 8 ----------------------
SIST EN 50083-10:2000
---------------------- Page: 9 ----------------------
SIST EN 50083-10:2000
---------------------- Page: 10 ----------------------
SI
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.