SIST EN 54-5:2001/A1:2002
(Amendment)Fire detection and fire alarm systems - Part 5: Heat detectors - Point detectors
Fire detection and fire alarm systems - Part 5: Heat detectors - Point detectors
Created exceptionnally without the corresponding TC resolution (at the request of A. Ganesh) - UAP of 4 months (CC/010423)
+++ DOW = DAV + 36 months - accepted by EC at SCC of 8/9 April 2002 (with EC list n°8 - doc. Construct 02/529 Rev 1)+++
Brandmeldeanlagen - Teil 5: Wärmemelder - Punktförmige Melder
Systemes de détection et d'alarme incendie - Partie 5: Détecteurs de chaleur - Détecteurs ponctuels
Sistemi za odkrivanje in javljanje požara ter alarmiranje – 5. del: Toplotni javljalniki – Točkovni javljalniki
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 54-5:2001/A1:2002
01-december-2002
6LVWHPL]DRGNULYDQMHLQMDYOMDQMHSRåDUDWHUDODUPLUDQMH±GHO7RSORWQLMDYOMDOQLNL
±7RþNRYQLMDYOMDOQLNL
Fire detection and fire alarm systems - Part 5: Heat detectors - Point detectors
Brandmeldeanlagen - Teil 5: Wärmemelder - Punktförmige Melder
Systemes de détection et d'alarme incendie - Partie 5: Détecteurs de chaleur -
Détecteurs ponctuels
Ta slovenski standard je istoveten z: EN 54-5:2000/A1:2002
ICS:
13.220.20 3RåDUQD]DãþLWD Fire protection
13.320 Alarmni in opozorilni sistemi Alarm and warning systems
SIST EN 54-5:2001/A1:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 54-5:2001/A1:2002
---------------------- Page: 2 ----------------------
SIST EN 54-5:2001/A1:2002
EUROPEAN STANDARD
EN 54-5:2000/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
June 2002
ICS 13.220.20
English version
Fire detection and fire alarm systems - Part 5: Heat detectors -
Point detectors
Systèmes de détection et d'alarme incendie - Partie 5: Brandmeldeanlagen - Teil 5: Wärmemelder - Punktförmige
Détecteurs de chaleur - Détecteurs ponctuels Melder
This amendment A1 modifies the European Standard EN 54-5:2000; it was approved by CEN on 5 April 2002.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Management Centre or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2002 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 54-5:2000/A1:2002 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 54-5:2001/A1:2002
EN 54-5:2000/A1:2002 (E)
Contents
page
Foreword.3
Annex ZA (informative) Clauses of this European Standard addressing essential requirements or other
provisions of EU Directives. .5
Bibliography .11
2
---------------------- Page: 4 ----------------------
SIST EN 54-5:2001/A1:2002
EN 54-5:2000/A1:2002 (E)
Foreword
This document EN 54-5:2000/A1:2002 has been prepared by Technical Committee CEN/TC 72 "Fire detection and
fire alarm systems", the secretariat of which is held by BSI.
This Amendment to the European Standard EN 54-5:2000 shall be given the status of a national standard, either
by publication of an identical text or by endorsement, at the latest by December 2002, and conflicting national
standards shall be withdrawn at the latest by June 2005.
This document has been prepared under a mandate given to CEN by the European Commission and the European
Free Trade Association, and supports essential requirements of the EU Construction Products Directive
(89/106/EEC).
For relationship with EU Directive(s), see informative annex ZA, which is an integral part of this document.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland,
France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain,
Sweden, Switzerland and the United Kingdom.
3
---------------------- Page: 5 ----------------------
SIST EN 54-5:2001/A1:2002
EN 54-5:2000/A1:2002 (E)
Contents
At the end of the existing table of contents, insert the following new entries:
Annex ZA (informative) Clauses of this European Standard addressing essential requirements or other
provisions of EU Directives
Bibliography
New annex ZA and Bibliography
After the existing annex D, add annex ZA and Bibliography as follows
4
---------------------- Page: 6 ----------------------
SIST EN 54-5:2001/A1:2002
EN 54-5:2000/A1:2002 (E)
Annex ZA
(informative)
Clauses of this European Standard addressing essential requirements or
other provisions of EU Directives
ZA.1 Scope and relevant clauses
This European Standard has been prepared under the mandate M/109 given to CEN by the European Commission
and the European Free Trade Association.
The clauses of this European Standard, shown in this annex, meet the requirements of the Mandate given under
the EU Construction Products Directive (89/106/EEC).
Compliance with these clauses confers a presumption of fitness of the construction product covered by this
European Standard for its intended use according to clause 1 (Scope) of this standard.
WARNING : Other requirements and other EU Directives may be applicable to the product(s) falling within the
scope of this standard.
NOTE 1 In addition to any specific clauses relating to dangerous substances contained in this standard, there may be other
requirements applicable to the products falling within its scope (e.g. transposed European legislation and national laws,
regulations and administrative provisions). These requirements need also to be complied with, when and where they apply.
NOTE 2 An informative database of European and national provisions on dangerous substances is available at the
Construction web site on EUROPA (CREATE, accessed through
http://europa.eu.int/comm/enterprise/construction/internal/hygiene.htm )
This annex ZA has the same scope, in relation to the products covered, as clause 1 of this standard. This annex
establishes the conditions for the CE marking of point heat detectors intended for the use shown below and
identifies the relevant clauses applicable.
5
---------------------- Page: 7 ----------------------
SIST EN 54-5:2001/A1:2002
EN 54-5:2000/A1:2002 (E)
Construction Product: Heat detectors - Point detectors for fire detection and fire alarm systems for
buildings.
Intended use: Fire Safety.
Table ZA.1 - Relevant clauses
Essential characteristics Clauses in this Mandated Notes
European Standard level(s)
a
Nominal activation conditions / Sensitivity, 4.2, 4.3, 5.2 to 5.6, 5.8, Suffix S detectors
a b
Response delay (response time) and 6.1 , 6.2 only
Performance under fire conditions
b
Suffix R detectors
only
Operational reliability 4.4 to 4.11
Tolerance to supply voltage 5.7
Durability of operational reliability and response 5.9, 5.10 None
delay; temperature resistance
Durability of operational reliability; vibration 5.14 to 5.17
resistance
Durability of operational reliability; humidity 5.11, 5.12
resistance
Durability of operational reliability; corrosion 5.13
resistance
Durability of operational reliability; electrical 5.18
stability
ZA.2 Procedures for the attestation of conformity of point heat detectors covered by this standard
ZA.2.1 System of attestation of conformity
The mandate requires tha
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.