SIST EN 3741:2004

Aerospace series - Nuts, clip, metric - Installation holes and assembly

This standard specifies the characteristics of the installation holes required for the utilization of clip nuts with design configuration to EN-Standards for aerospace applications.

Ecrous a pincer, métrique - Trou d'installation

Aerospace series - Nuts, clip, metric - Installation holes and assembly

General Information

• Status: Withdrawn
• Publication Date: 30-Apr-2004
• Withdrawal Date: 31-May-2005
• ICS: 49.030.30 - Nuts
• Technical Committee: I08 - Imaginarni 08
• Current Stage: 9900 - Withdrawal (Adopted Project)
• Start Date: 01-Jun-2005
• Due Date: 01-Jun-2005
• Completion Date: 01-Jun-2005
• Ref Project: EN 3741:2003 - Aerospace series - Nuts, clip, metric - Installation holes and assembly

Relations

• Replaced By: SIST EN 3741:2005 - Aerospace series - Nuts, clip, metric - Installation holes and assembly
• Effective Date: 01-Jun-2005

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Aerospace series - Nuts, clip, metric - Installation holes and assemblyEcrous a pincer, métrique - Trou d'installationAerospace series - Nuts, clip, metric - Installation holes and assembly49.030.30MaticeNutsICS:Ta slovenski standard je istoveten z:EN 3741:2003SIST EN 3741:2004en01-maj-2004SIST EN 3741:2004SLOVENSKI
STANDARD



SIST EN 3741:2004



EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 3741January 2003ICS 49.030.30English versionAerospace series - Nuts, clip, metric - Installation holes andassemblyThis European Standard was approved by CEN on 2 June 2002.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the officialversions.CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and UnitedKingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2003 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 3741:2003 ESIST EN 3741:2004



EN 3741:2003 (E)2ContentspageForeword.31Scope.32Normative references.33Principle.34Design instructions.44.1Support design.44.1.1Installation A : " on flank of support".44.1.2.Installation B : "with slot".54.1.3Dimensions.54.2Type of installation.54.2.1Installation A.54.2.2Installation B.65Indication on drawings.
...