SIST EN 50174-1:2009/A2:2014
(Amendment)Information technology - Cabling installation - Part 1: Installation specification and quality assurance
Information technology - Cabling installation - Part 1: Installation specification and quality assurance
D145/C116: NWI approved * 2013-03-14: UAP text allocated to cpalagi@cencenelec.eu
Informationstechnik - Installation von Kommunikationsverkabelung - Teil 1: Installationsspezifikation und Qualitätssicherung
Technologies de l'information - Installation de câblages - Partie 1: Spécification de l'installation et assurance de la qualité
Informacijska tehnologija - Polaganje kablov - 1. del: Specifikacija in zagotavljanje kakovosti - Dopolnilo A2
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 50174-1:2009/A2:2014
01-december-2014
Informacijska tehnologija - Polaganje kablov - 1. del: Specifikacija in zagotavljanje
kakovosti - Dopolnilo A2
Information technology - Cabling installation - Part 1: Installation specification and quality
assurance
Informationstechnik - Installation von Kommunikationsverkabelung - Teil 1:
Installationsspezifikation und Qualitätssicherung
Technologies de l'information - Installation de câblages - Partie 1: Spécification de
l'installation et assurance de la qualité
Ta slovenski standard je istoveten z: EN 50174-1:2009/A2:2014
ICS:
33.040.50 Vodi, zveze in tokokrogi Lines, connections and
circuits
35.110 Omreževanje Networking
SIST EN 50174-1:2009/A2:2014 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 50174-1:2009/A2:2014
---------------------- Page: 2 ----------------------
SIST EN 50174-1:2009/A2:2014
EUROPEAN STANDARD EN 50174-1:2009/A2
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2014
ICS 35.110
English Version
Information technology - Cabling installation - Part 1: Installation
specification and quality assurance
Technologies de l'information - Installation de câblages - Informationstechnik - Installation von
Partie 1: Spécification de l'installation et assurance de la Kommunikationsverkabelung - Teil 1:
qualité Installationsspezifikation und Qualitätssicherung
This amendment A2 modifies the European Standard EN 50174-1:2009; it was approved by CENELEC on 2014-08-18. CENELEC
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this amendment the
status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as
the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2014 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN 50174-1:2009/A2:2014 E
---------------------- Page: 3 ----------------------
SIST EN 50174-1:2009/A2:2014
EN 50174-1:2009/A2:2014 – 2 –
Foreword
This document (EN 50174-1:2009/A2:2014) has been prepared by CLC/TC 215 "Electrotechnical aspects of
telecommunication equipment".
The following dates are fixed:
• latest date by which this document has to be (dop) 2015-08-18
implemented at national level by publication of
an identical national standard or by
endorsement
(dow) 2017-08-18
• latest date by which the national standards
conflicting with this document have to
be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such patent rights.
This Amendment covers
− some technical and editorial changes to the Introduction, Clauses 3 and 4.
− a new Annex F.
---------------------- Page: 4 ----------------------
SIST EN 50174-1:2009/A2:2014
- 3 - EN 50174-1:2009/A2:2014
Introduction
Replace Figure 1 with the following
EENN 5009500988--1:1: C Cususttomomerer pr preemmiisseses ccablabliing fng foror EENN 5017501733--2:2: I Infnforormmatatiion ton tecechnolhnoloogygy --
iinfnforormmatatiion ton tecechnolhnoloogygy -- IISSDDNN b baassiicc a acccceessss GGenenereriicc c cablabliing ng ssyysstteemmss -- OOffffiicce pre prememiisseses
EENN 5017501733--3:3: I Infnforormmatatiion ton tecechnolhnoloogygy --
GGenenereriicc c cablabliing ng ssyysstteemmss -- IIndusndusttrriialal prprememiisseses
EENN 5009500988--2:2: C Cususttomomerer pr preemmiisseses ccablabliing fng foror
iinfnforormmatatiion ton tecechnolhnoloogygy -- 202048 48 kkbbiit/st/s IISSDN pDN prriimmaarryy
EENN 5017501733--4:4: I Infnforormmatatiion ton tecechnolhnoloogygy -- EENN 5017501733--1:1: I Infnforormmatatiion ton tecechnolhnoloogygy --
acacccesesss and l and leaseased ed lliine ne nnetetwwororkk i intntererffacacee
Generic cabling systems - Homes Generic cabling systems - General
Generic cabling systems - Homes Generic cabling systems - General
rrequiequirrememententss
EENN 5017501733--5:5: I Infnforormmatatiion ton tecechnolhnoloogygy --
GGenenereriicc c cablabliing ng ssyysstteemmss -- DDatata a ccententrreses
EENN 5017501733--6:6: I Infnforormmatatiion ton tecechnolhnoloogygy --
GGenenereriicc c cablabliing ng ssyysstteemmss -- DDiissttrriibutbuted buied builldidinng g
sserervviicceses
EENN 5017501744--1:1: I Infnforormmatatiion ton tecechnolhnoloogygy -- CCablabliing ng
iinsnsttalalllatatiion on -- IInsnsttalalllatatiion son specpeciiffiiccatatiion on aand qnd qualualiittyy
asasssururancancee
EENN 5017501744--2:2: I Infnforormmatatiion ton tecechnolhnoloogygy -- CCablabliing ng EENN 503150310:0: A Applppliiccatatiion ofon of eqequiuipotpoteentntiialal bonbondiding ng
iinsnsttalalllatatiion on -- IInsnsttalalllatatiion on plplannianninng g and and prpracacttiicceses and and eareartthihinngg iin bn buiuilldidingsngs w wiitth ih infnforormmaattiion on
iinsnsiide buide builldidingsngs ttecechnolhnoloogygy e equiquipmpmentent
EENN 5017501744--3:3: I Infnforormmatatiion ton tecechnolhnoloogygy -- CCablabliing ng
iinsnsttalalllatatiion on -- IInsnsttalalllatatiion on plplannianninng g and and prpracacttiicceses
outoutssiide buide builldidinngsgs
EENN 503450346:6: I Infnforormmatatiion ton tecechnolhnologogyy -- CCablabliing ng
iinsnsttalalllatatiion on -- TTeessttiing ofng of i insnsttalallled ced cablabliingng
Figure 1 – Schematic relationship between the EN 50174 series
and other relevant standards
3.1 Terms and definitions
Insert the following definitions and renumber the remaining ones accordingly:
3.1.3
automated infrastructure management system
integrated hardware and software which automatically records the nature of, and identifies changes to,
connections between the cabling infrastructure and of the interconnected transmission and terminal
equipment
3.1.10
discoverable equipment
equipment with a network address
Note 1 to entry: Discoverable equipment can be treated as non-discoverable equipment per end user choice.
3.2 Abbreviations
Insert the following abbreviations:
AIM Automated infrastructure management
MAC Move, add, change
---------------------- Page: 5 ----------------------
SIST EN 50174-1:2009/A2:2014
EN 50174-1:2009/A2:2014 – 4 –
4 Requirements for planning installations of information technology cabling
4.2.2.1 Requirements
Replace the 2nd paragraph by the following:
Information technology cables that do not comply with the minimum recommended performance
requirements of EN 60332-1-2 shall be either:
a) terminated in an entrance facility which is outside the external fire barrier of the building;
or
b) terminated inside the building, within 2 m (unless an alternative distance is specified by local
regulations) of the point of internal penetration of the external fire barrier or a
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.