SIST EN ISO 5398-4:2019
(Main)Leather - Chemical determination of chromic oxide content - Part 4: Quantification by inductively coupled plasma (ICP) (ISO 5398-4:2018)
Leather - Chemical determination of chromic oxide content - Part 4: Quantification by inductively coupled plasma (ICP) (ISO 5398-4:2018)
This document describes a method for the determination of chromium in aqueous solution obtained
from leather. This is an analysis for total chromium in leather; it is not compound specific or specific to
its oxidation state.
This method describes the determination of chromium by inductively coupled plasma (ICP) and is
applicable to leathers which are expected to have chromic oxide contents in excess of 1 mg/kg. Two
techniques for the preparation of the solution to be analysed are included. In the event of dispute, the
wet oxidation technique is intended to be used.
Leder - Chemische Bestimmung des Chromoxidgehalts - Teil 4: Quantitative Bestimmung durch induktiv gekoppeltes Plasma (ICP) (ISO 5398-4:2018)
Cuir - Dosage chimique de l'oxyde de chrome - Partie 4: Quantification par plasma à couplage inductif (ICP) (ISO 5398-4:2018)
Le présent document décrit une méthode permettant de doser le chrome dans une solution aqueuse obtenue à partir de cuir. C'est une analyse du chrome total dans le cuir; elle est non spécifique du composé chromé ou de l'état d'oxydation du chrome.
La présente méthode indique comment doser le chrome par plasma à couplage inductif (ICP) et elle s'applique aux cuirs susceptibles de contenir de l'oxyde de chrome dans des proportions supérieures à 1 mg/kg. Deux techniques de préparation de la solution à analyser sont décrites. En cas de litige, il est prévu d'utiliser la méthode d'oxydation en milieu humide.
Usnje - Kemijsko določevanje kromovega oksida - 4. del: Kvantitativno določevanje z induktivno sklopljeno plazmo (ICP) (ISO 5398-4:2018)
Ta dokument opisuje metodo za določevanje kroma v vodni raztopini, pridobljeni iz usnja. To je analiza skupne vsebnosti kroma v usnju, pri čemer ne obravnava določene spojine ali določenega oksidacijskega stanja kroma.
Ta metoda opisuje določevanje kroma z induktivno sklopljeno plazmo (ICP) in se uporablja za usnje, za katerega se pričakuje, da vsebuje več kot 1 mg/kg kromovega oksida. Vključeni sta dve tehniki priprave raztopine, namenjene za analizo. V primeru spora je predvideno, da se uporabi tehnika mokre oksidacije.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN ISO 5398-4:2019
01-april-2019
1DGRPHãþD
SIST EN ISO 5398-4:2009
8VQMH.HPLMVNRGRORþHYDQMHNURPRYHJDRNVLGDGHO .YDQWLWDWLYQR
GRORþHYDQMH]LQGXNWLYQRVNORSOMHQRSOD]PR ,&3 ,62
Leather - Chemical determination of chromic oxide content - Part 4: Quantification by
inductively coupled plasma (ICP) (ISO 5398-4:2018)
Leder - Chemische Bestimmung des Chromoxidgehalts - Teil 4: Quantitative
Bestimmung durch induktiv gekoppeltes Plasma (ICP) (ISO 5398-4:2018)
Cuir - Dosage chimique de l'oxyde de chrome - Partie 4: Quantification par plasma à
couplage inductif (ICP) (ISO 5398-4:2018)
Ta slovenski standard je istoveten z: EN ISO 5398-4:2019
ICS:
59.140.30 Usnje in krzno Leather and furs
SIST EN ISO 5398-4:2019 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 5398-4:2019
---------------------- Page: 2 ----------------------
SIST EN ISO 5398-4:2019
EN ISO 5398-4
EUROPEAN STANDARD
NORME EUROPÉENNE
February 2019
EUROPÄISCHE NORM
ICS 59.140.30 Supersedes EN ISO 5398-4:2007
English Version
Leather - Chemical determination of chromic oxide content
- Part 4: Quantification by inductively coupled plasma
(ICP) (ISO 5398-4:2018)
Cuir - Dosage chimique de l'oxyde de chrome - Partie 4: Leder - Chemische Bestimmung des Chromoxidgehalts
Quantification par plasma à couplage inductif (ICP) - Teil 4: Quantitative Bestimmung durch induktiv
(ISO 5398-4:2018) gekoppeltes Plasma (ICP) (ISO 5398-4:2018)
This European Standard was approved by CEN on 16 December 2018.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 5398-4:2019 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN ISO 5398-4:2019
EN ISO 5398-4:2019 (E)
Contents Page
European foreword . 3
2
---------------------- Page: 4 ----------------------
SIST EN ISO 5398-4:2019
EN ISO 5398-4:2019 (E)
European foreword
This document (EN ISO 5398-4:2019) has been prepared by Technical Committee ISO/IULTCS
"International Union of Leather Technologists and Chemists Societies" in collaboration with Technical
Committee CEN/TC 289 “Leather” the secretariat of which is held by UNI.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by August 2019, and conflicting national standards shall
be withdrawn at the latest by August 2019.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 5398-4:2007.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta,
Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
Endorsement notice
The text of ISO 5398-4:2018 has been approved by CEN as EN ISO 5398-4:2019 without any
modification.
3
---------------------- Page: 5 ----------------------
SIST EN ISO 5398-4:2019
---------------------- Page: 6 ----------------------
SIST EN ISO 5398-4:2019
INTERNATIONAL ISO
STANDARD 5398-4
IULTCS/IUC 8-4
Second edition
2018-12
Leather — Chemical determination of
chromic oxide content —
Part 4:
Quantification by inductively coupled
plasma (ICP)
Cuir — Dosage chimique de l'oxyde de chrome —
Partie 4: Quantification par plasma à couplage inductif (ICP)
Reference numbers
ISO 5398-4:2018(E)
IULTCS/IUC 8-4:2018(E)
©
ISO 2018
---------------------- Page: 7 ----------------------
SIST EN ISO 5398-4:2019
ISO 5398-4:2018(E)
IULTCS/IUC 8-4:2018(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved
---------------------- Page: 8 ----------------------
SIST EN ISO 5398-4:2019
ISO 5398-4:2018(E)
IULTCS/IUC 8-4:2018(E)
Contents Page
Foreword .iv
Introduction .vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 2
5 Sampling and sample preparation . 2
6 Reagents . 2
7 Apparatus . 2
8 Methods . 2
8.1 Preparation of analytical solution . 2
8.1.1 Wet oxidation method . 2
8.1.2 Microwave digestion or other method of digestion . 3
8.2 Measurement of the aqueous solution . 3
8.2.1 General. 3
8.2.2 Preparation of calibration graph . 3
8.2.3 Analysis of the test solution . 3
9 Calculation and expression of results . 4
10 Test report . 4
Annex A (informative) Determination of water and other volatile matter . 5
Annex B (informative) Suitable ICP equipment . 6
© ISO 2018 – All rights reserved iii
---------------------- Page: 9 ----------------------
SIST EN ISO 5398-4:2019
ISO 5398-4:2018(E)
IULTCS/IUC 8-4:2018(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www .iso .org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www .iso .org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to the
World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT) see www .iso
.org/iso/foreword .html.
This document was prepared by the Chemical Tests Commission of the International Union of Leather
Technologists and Chemists Societies (IUC Commission, IULTCS) in collaboration with the European
Committee for Standardization (CEN) Technical Committee CEN/TC 289, Leather, the secretariat of
which is held by UNI, in accordance with the Agreement on technic
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.