SIST EN 50272-4:2007
(Main)Safety requirements for secondary batteries and battery installations -- Part 4: Batteries for use in portable appliances
Safety requirements for secondary batteries and battery installations -- Part 4: Batteries for use in portable appliances
This standard applies to the safety aspects associated with the accommodation, the arrangements of circuits and the operation of secondary cells and batteries in portable appliances. Requirements are specified which oblige the manufacturers of appliances and secondary batteries to prevent the misuse of batteries in the course of operation to provide protective measures avoiding injury to persons in case of battery failure and to provide sufficient information to users.
Sicherheitsanforderungen an Batterien und Batterieanlagen -- Teil 4: Batterien für tragbare Geräte
Diese Norm gilt für Sicherheitsfragen, die mit der Unterbringung, der Schaltungsanordnung und dem Betrieb von Sekundär-Batterien in tragbaren Geräten in Verbindung stehen. Es werden Anforderungen festgelegt, die die Hersteller von Geräten und von Sekundär-Batterien verpflichten, die missbräuchliche Nutzung von Batterien beim Betrieb zu verhindern, Schutzmaßnahmen vorzusehen, die verhindern, dass im Falle eines Batteriefehlers Personen verletzt werden, und dem Anwender ausreichende Informationen zur Verfügung zu stellen.
Règles de sécurité pour les batteries d’accumulateurs et leur installation -- Partie 4: Batteries d’accumulateurs utilisées dans les appareils portables
La présente norme s’applique aux aspects de sécurité liés à l'emplacement, la disposition des circuits et le fonctionnement des éléments et batteries d’accumulateurs dans les appareils portables. Des exigences sont spécifiées pour que les fabricants d’appareils et de batteries d’accumulateurs soient tenus d’empêcher l’utilisation impropre des batteries d’accumulateurs au cours de leur fonctionnement, de fournir des mesures de protection pour éviter de blesser les personnes en cas de défaillance de la batterie d’accumulateurs et de fournir des informations suffisantes aux utilisateurs.
Varnostne zahteve za sekundarne baterije in baterijske naprave - 4. del: Baterije za prenosne aparate
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 50272-4:2007
01-december-2007
Varnostne zahteve za sekundarne baterije in baterijske naprave – 4. del: Baterije za
prenosne aparate
Safety requirements for secondary batteries and battery installations -- Part 4: Batteries
for use in portable appliances
Sicherheitsanforderungen an Batterien und Batterieanlagen -- Teil 4: Batterien für
tragbare Geräte
Regles de sécurité pour les batteries d’accumulateurs et leur installation -- Partie 4:
Batteries d’accumulateurs utilisées dans les appareils portables
Ta slovenski standard je istoveten z: EN 50272-4:2007
ICS:
29.220.20 .LVOLQVNLVHNXQGDUQLþOHQLLQ Acid secondary cells and
EDWHULMH batteries
SIST EN 50272-4:2007 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
EN 50272-4
NORME EUROPÉENNE
March 2007
EUROPÄISCHE NORM
ICS 29.220.20
English version
Safety requirements for secondary batteries and battery installations -
Part 4: Batteries for use in portable appliances
Règles de sécurité pour les batteries Sicherheitsanforderungen an Batterien
d’accumulateurs et leur installation - und Batterieanlagen -
Partie 4: Batteries d’accumulateurs Teil 4: Batterien für tragbare Geräte
utilisées dans les appareils portables
This European Standard was approved by CENELEC on 2006-03-01. CENELEC members are bound to
comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and
notified to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Cyprus, the
Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia,
Slovenia, Spain, Sweden, Switzerland and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2007 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 50272-4:2007 E
---------------------- Page: 2 ----------------------
EN 50272-4:2007 - 2 -
Foreword
This European Standard was prepared by the Technical Committee CENELEC TC 21X, Secondary cells
and batteries. The text of the draft was submitted to the formal vote and was approved by CENELEC as
EN 50272-4 on 2006-03-01.
The following dates were fixed:
- latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2007-10-01
- latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2009-03-01
__________
---------------------- Page: 3 ----------------------
- 3 - EN 50272-4:2007
Contents
Page
Introduction .4
1 Scope .4
2 Normative references.4
3 Definitions.5
4 Operating instructions .5
5 Dimensions and interchangeability of cells and batteries .6
6 Electrical safety .6
6.1 Protection against incorrect connection polarity .6
6.2 Design of battery and battery compartments .6
6.3 Compartments for consumer replaceable batteries .6
7 Safe handling and protection against misuse .6
7.1 Charging.6
7.2 Thermal abuse .7
7.3 Mechanical impact.7
7.4 Protection against pole reversal in the event of deep discharge .7
7.5 Protection against electrical overload .7
7.6 Safe handling .7
8 Battery compartments .7
8.1 Battery accommodation.7
8.2 Replacement battery enclosures.7
8.3 Battery contacts.7
8.4 Protection against hazards caused by released gas .7
9 Measures in the event of accidents with batteries .8
9.1 Swallowing button cells .7
9.2 Burns or positioning caused byleaking batteries.8
10 Marking and disposal of batteries for use in portable appliances .9
Annex A (informative)…….10
A.1 Instructions for use.10
A.2 Recommendations to the end-users .10
Bibliography.12
---------------------- Page: 4 ----------------------
EN 50272-4:2007 - 4 -
Introduction
This standard gives information about the safety and health protection of persons when applying
secondary batteries, which are used for DC power supply systems in portable appliances. Therefore the
standard applies for commercially available secondary batteries and battery systems according to the
requirements of the “Low Voltage Directive”.
In the European countries similar relevant standards or specifications or parts of it exist, which shall be
taken into account and will be replaced by this new standard.
In certain portable appliances or toys the discharge of both primary and secondary cells or batteries is
possible. In case of interchange ability of these cells or batteries the standards for primary batteries of the
EN 60086 series, Parts 1 to 5, shall have preference.
1 Scope
This standard applies to the safety aspects associated with the accommodation, the arrangements of
circuits and the operation of secondary cells and batteries in portable appliances. Requirements are
specified which oblige the manufacturers of appliances and secondary batteries to prevent the misuse of
batteries in the course of operation to provide protective measures avoiding injury to persons in case of
battery failure and to provide sufficient information to users.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
EN 50272-2 Safety requirements for secondary batteries and battery installations -
Part 2: Stationary batteries
EN 60086-1 Primary batteries - Part 1: General (IEC 60086-1)
EN 60086-2 Primary batteries - Part 2: Physical and electrical specifications (IEC 60086-2)
EN 60086-3 Primary batteries - Part 3: Watch batteries (IEC 60086-3)
EN 60086-4 Primary batteries - Part 4: Safety of lithium batteries (IEC 60086-4)
EN 60086-5 Primary batteries - Part 5: Safety of batteries with aqueous electrolyte
(IEC 60086-5)
EN 60335-1 Household and similar electrical appliances - Safety - Part 1: General requirements
(IEC 60335-1)
EN 61056-2 General purpose lead-acid batteries (valve-regulated types) - Part 2: Dimensions,
terminals and marking (IEC 61056-2)
EN 61429 Marking of secondary cells and batteries with the international recycling symbol
+ A11 ISO 7000-1135 and indications regarding directives 93/86/EEC and 91/157/EEC
(IEC 61429)
EN 61951-1 Secondary cells and batteries containing alkaline or other non-acid electrolytes -
Portable sealed rechargeable single cells - Part 1: Nickel-cadmium (IEC 61951-1)
---------------------- Page: 5 ----------------------
- 5 - EN 50272-4:2007
EN 61951-2 Secondary cells and batteries containing alkaline or other non-acid electrolytes -
Portable sealed rechargeable single cells - Part 2: Nickel-metal hydride
(IEC 61951-2)
EN 61960 Secondary cells and batteries containing alkaline or other non-acid electrolytes -
Secondary lithium cells and batteries for portable applications (IEC 61960)
EN 62133 Secondary cells and batteries containing alkaline or other non-acid electrolytes -
Safety requirements for portable sealed secondary cells, and for batteries made from
them, for use in portable application (IEC 62133)
IEC 60050-482 International Electrotechnical Vocabulary - Chapter 482: Primary and secondary
cells and batteries
IEC 60417 Graphical symbols for use on equipment
database
3 Definitions
3.1
battery for use in portable appliances
mainly used for the power supply of the electrical equipment or parts of it forming an integral, functional
unit. Batteries for use in portable equipment are usually maintenance-free types. For further definitions
see International Electrotechnical Vocabulary IEC 60050-482
3.2
secondary cell / battery
cell which is designed to be electrically recharged, basic functional unit providing a source of electrical
energy by direct conversion of chemical energy, the cell (or battery) consists of an assembly of
electrodes, separators, electrolyte, container and terminals
[IEV 482-01-03]
4 Operating instructions
Users of appliances shall be informed through operating instructions about the following items, with
specific reference to batteries:
a) proposed or applicable battery systems and battery dimensions according to the applicable standard,
b) correct insertion of batteries into the equipment in terms of polarity,
c) charging instructions for secondary batteries,
d) prohibition of charging when using primary batteries,
e) storage and temperature conditions,
f) maintenance instructions,
g) instructions for the prevention of hazard and measures to be taken following an accident,
h)
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.