kSIST FprEN ISO 13165-3:2024
(Main)Water quality - Radium-226 - Part 3: Test method using coprecipitation and gamma-spectrometry (ISO/FDIS 13165-3:2024)
Water quality - Radium-226 - Part 3: Test method using coprecipitation and gamma-spectrometry (ISO/FDIS 13165-3:2024)
ISO 13165-3:2016 specifies the determination of radium-226 (226Ra) activity concentration in all types of water by coprecipitation followed by gamma-spectrometry (see ISO 18589‑3).
The method described is suitable for determination of soluble 226Ra activity concentrations greater than 0,02 Bq l−1 using a sample volume of 1 l to 100 l of any water type.
For water samples smaller than a volume of 1 l, direct gamma-spectrometry can be performed following ISO 10703 with a higher detection limit.
NOTE This test method also allows other isotopes of radium, 223Ra, 224Ra, and 228Ra, to be determined.
Wasserbeschaffenheit - Radium-226 - Teil 3: Verfahren mittels Kopräzipitation und Gammaspektrometrie (ISO/FDIS 13165-3:2024)
Dieses Dokument legt ein Verfahren zur Bestimmung der Aktivitätskonzentration von Radium 226 (226Ra) in allen Arten von Wasser durch Mitfällung und anschließende Gammaspektrometrie fest (siehe ISO 20042 [7]).
Das Verfahren beschreibt die Bestimmung der Aktivitätskonzentrationen von löslichem 226Ra von mehr als 0,002 Bq ⋅ l-1 unter dem Einsatz eines Probenvolumens von bis zu 100 l eines beliebigen Wassertyps.
Für Wasserproben mit einem Volumen von weniger als 1 l kann eine direkte Gammaspektrometrie nach ISO 10703 jedoch mit einer höheren Nachweisgrenze durchgeführt werden. Die typischen Nachweisgrenzen für Proben von 1 l bis 5 l liegt im Bereich von 0,002 bis 0,000 40 Bq·l−1[8].
ANMERKUNG Dieses Prüfverfahren kann angepasst werden, um andere natürlich vorkommenden Radiumisotope, wie 223Ra, 224Ra und 228Ra, zu bestimmen, sofern deren Aufwachszeiten berücksichtigt werden.
WARNUNG — Anwender dieses Dokuments sollten mit der üblichen Laborpraxis vertraut sein. Dieses Dokument gibt nicht vor, alle unter Umständen mit der Anwendung des Verfahrens verbundenen Sicherheitsaspekte anzusprechen. Es liegt in der Verantwortung des AnwendersN1, angemessene Sicherheits und Schutzmaßnahmen zu treffen und sicherzustellen, dass diese mit nationalen Festlegungen übereinstimmen.
WICHTIG — Es ist unbedingt erforderlich, dass die Untersuchungen nach diesem Dokument von entsprechend qualifiziertem Personal durchgeführt werden.
Qualité de l'eau - Radium 226 - Partie 3: Méthode d'essai par co-précipitation et spectrométrie gamma (ISO/FDIS 13165-3:2024)
L'ISO 13165-3:2016 spécifie la détermination de l'activité volumique du radium 226 (226Ra), dans tous les types d'eaux par coprécipitation suivie d'une spectrométrie gamma (voir l'ISO 18589‑3).
La méthode décrite est applicable pour la détermination de l'activité volumique du 226Ra soluble ayant une activité volumique en 226Ra supérieure à 0,02 Bq l−1 en utilisant un volume d'échantillon compris entre 1 l et 100 l de tout type d'eau.
Pour des échantillons d'eau inférieurs à un volume de 1 l, la spectrométrie gamma directe peut être effectuée en se conformant à l'ISO 10703 avec une limite de détection supérieure.
NOTE Cette méthode d'essai permet également le mesurage d'autres isotopes du radium (223Ra, 224Ra et 228Ra).
Kakovost vode - Radij Ra-226 - 3. del: Preskusna metoda s soobarjanjem in gama spektrometrijo (ISO/FDIS 13165-3:2024)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
oSIST prEN ISO 13165-3:2023
01-maj-2023
Kakovost vode - Radij Ra-226 - 3. del: Preskusna metoda s soobarjanjem in gama
spektrometrijo (ISO/DIS 13165-3:2023)
Water quality - Radium-226 - Part 3: Test method using coprecipitation and gamma-
spectrometry (ISO/DIS 13165-3:2023)
Wasserbeschaffenheit - Radium-226 - Teil 3: Verfahren mittels Kopräzipitation und
Gammaspektrometrie (ISO/DIS 13165-3:2023)
Qualité de l'eau - Radium 226 - Partie 3: Méthode d'essai par co-précipitation et
spectrométrie gamma (ISO/DIS 13165-3:2023)
Ta slovenski standard je istoveten z: prEN ISO 13165-3
ICS:
13.060.60 Preiskava fizikalnih lastnosti Examination of physical
vode properties of water
17.240 Merjenje sevanja Radiation measurements
oSIST prEN ISO 13165-3:2023 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
oSIST prEN ISO 13165-3:2023
oSIST prEN ISO 13165-3:2023
DRAFT INTERNATIONAL STANDARD
ISO/DIS 13165-3
ISO/TC 147/SC 3 Secretariat: AFNOR
Voting begins on: Voting terminates on:
2023-03-16 2023-06-08
Water quality — Radium-226 —
Part 3:
Test method using coprecipitation and gamma-
spectrometry
Qualité de l'eau — Radium 226 —
Partie 3: Méthode d'essai par coprécipitation et spectrométrie gamma
ICS: 17.240; 13.060.60
This document is circulated as received from the committee secretariat.
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENT AND APPROVAL. IT IS
ISO/CEN PARALLEL PROCESSING
THEREFORE SUBJECT TO CHANGE AND MAY
NOT BE REFERRED TO AS AN INTERNATIONAL
STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS
BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
Reference number
NATIONAL REGULATIONS.
ISO/DIS 13165-3:2023(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
PROVIDE SUPPORTING DOCUMENTATION. © ISO 2023
oSIST prEN ISO 13165-3:2023
ISO/DIS 13165-3:2023(E)
DRAFT INTERNATIONAL STANDARD
ISO/DIS 13165-3
ISO/TC 147/SC 3 Secretariat: AFNOR
Voting begins on: Voting terminates on:
Water quality — Radium-226 —
Part 3:
Test method using coprecipitation and gamma-
spectrometry
Qualité de l'eau — Radium 226 —
Partie 3: Méthode d'essai par coprécipitation et spectrométrie gamma
ICS: 17.240; 13.060.60
This document is circulated as received from the committee secretariat.
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENT AND APPROVAL. IT IS
© ISO 2023
ISO/CEN PARALLEL PROCESSING
THEREFORE SUBJECT TO CHANGE AND MAY
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
NOT BE REFERRED TO AS AN INTERNATIONAL
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on STANDARD UNTIL PUBLISHED AS SUCH.
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
IN ADDITION TO THEIR EVALUATION AS
or ISO’s member body in the country of the requester. BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
ISO copyright office
USER PURPOSES, DRAFT INTERNATIONAL
CP 401 • Ch. de Blandonnet 8
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
CH-1214 Vernier, Geneva
POTENTIAL TO BECOME STANDARDS TO
Phone: +41 22 749 01 11
WHICH REFERENCE MAY BE MADE IN
Reference number
Email: copyright@iso.org
NATIONAL REGULATIONS.
Website: www.iso.org ISO/DIS 13165-3:2023(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
Published in Switzerland
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
ii
PROVIDE SUPPORTING DOCUMENTATION. © ISO 2023
oSIST prEN ISO 13165-3:2023
ISO/DIS 13165-3:2023(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols . 2
5 Principle of the measurement .3
6 Reagents and equipment . 3
6.1 Reagents . 3
6.2 Equipment . 4
7 Sampling . 4
7.1 Sample collection . . . 4
7.2 Sample transport and storage . 4
8 Procedures . 5
8.1 Blank sample preparation . 5
8.2 Sample preparation . 5
8.3 Counting procedure . 5
9 Quality assurance and quality control programme . 6
9.1 General . 6
9.2 Influence quantities . 6
9.3 Method verification . 6
9.4 Demonstration of analyst capability . 6
10 Expression of results . 7
10.1 General . 7
10.2 Water-soluble Ra activity concentration . 7
10.3 Standard uncertainty of activity concentration . 7
10.4 Decision threshold . 8
10.5 Detection limit . 8
10.6 Limits of the coverage intervals . . 8
10.6.1 Limits of the probabilistically symmetric coverage interval . 8
10.6.2 The shortest coverage interval . 9
10.7 Corrections for contributions from other radionuclides and background . 9
10.7.1 General . 9
10.7.2 Contribution from other radionuclides . 10
10.7.3 Contribution from background . 11
11 Test report .11
Annex A (informative) Uranium, Thorium and Neptunium and their decay chains .13
Bibliography .15
iii
oSIST prEN ISO 13165-3:2023
ISO/DIS 13165-3:2023(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www.iso.org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to
the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see
www.iso.org/iso/foreword.html.
This document was prepared by Technical Committee ISO/TC 147 Water quality, Subcommittee SC 3,
Radioactivity measurements.
This second edition cancels and replaces the first edition (ISO 13165-3:2016), which has been
technically revised.
The main changes are as follows:
— complete revision of the introduction
— the principal of measurement (Clause 5) was expanded
— the instrument verification (formerly subclause 9.3) was deleted
— formulae for the coverage intervals according to ISO 11929 series were updated
— requirements of the test report were updated
A list of all parts in the ISO 13165 series can be found on the ISO website.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www.iso.org/members.html.
iv
oSIST prEN ISO 13165-3:2023
ISO/DIS 13165-3:2023(E)
Introduction
Radionuclides are present throughout the environment; thus, water bodies (e.g., surface waters, ground
waters, sea waters) contain radionuclides, which can be of either natural or anthropogenic origin:
3 14 40
— naturally-occurring radionuclides, including H, C, K and those origin
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.