This document specifies a method for the measurement of 210Po in all types of waters by alpha spectrometry.
The method is applicable to test samples of supply/drinking water, rainwater, surface and ground water, marine water, as well as cooling water, industrial water, domestic, and industrial wastewater after proper sampling and handling, and test sample preparation. Filtration of the test sample may be required.
The detection limit depends on the sample volume, the instrument used, the count...
view more

    • sale 10% off
    • Standard
      28 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      24 pages
      English language
    • e-Library read for
      1 day

This standard describes the requirements for rapid testing of water samples under emergency situations in laboratories:
- taking into account a special context for analyses, e.g. an unknown and unusual contamination;
- using or adapting if possible radioactivity measurements methods used in routine to get a result
rapidly or applying specific rapid methods previously tested by the laboratory, e.g. for 89Sr determination ;
- preparing the laboratory to analyse a large number of potentially co...
view more

    • sale 10% off
    • Standard
      29 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      25 pages
      English language
    • e-Library read for
      1 day

This document provides guidelines for testing laboratories wanting to use rapid test methods on water samples that may be contaminated following a nuclear or radiological emergency incident. In an emergency situation, consideration should be given to: — taking into account the specific context for the tests to be performed, e.g. a potentially high level of contamination; — using or adjusting, when possible, radioactivity test methods implemented during routine situations to obtain a result rapid...view more

    • sale 15% off
    • Standard
      20 pages
      English language
    • sale 15% off
    • Standard
      22 pages
      French language
    • sale 15% off
    • Draft
      20 pages
      English language

This document specifies the conditions for the determination of uranium isotope activity concentration in samples of environmental water (including sea waters) using alpha-spectrometry and 232U as a yield tracer. A chemical separation is required to separate and purify uranium from a test portion of the sample.

    • sale 15% off
    • Standard
      19 pages
      English language
    • sale 15% off
    • Standard
      21 pages
      French language
    • sale 15% off
    • Draft
      19 pages
      English language

This document specifies a method for the measurement of 210Po in all types of waters by alpha spectrometry. The method is applicable to test samples of supply/drinking water, rainwater, surface and ground water, marine water, as well as cooling water, industrial water, domestic, and industrial wastewater after proper sampling and handling, and test sample preparation. Filtration of the test sample may be required. The detection limit depends on the sample volume, the instrument used, the countin...view more

    • sale 15% off
    • Standard
      19 pages
      English language
    • sale 15% off
    • Standard
      20 pages
      French language
    • sale 15% off
    • Draft
      19 pages
      English language

ISO 13164-1:2013 gives general guidelines for sampling, packaging, and transporting of all kinds of water samples, for the measurement of the activity concentration of radon-222.
The test methods fall into two categories: a) direct measurement of the water sample without any transfer of phase (see ISO 13164‑2); b) indirect measurement involving the transfer of the radon-222 from the aqueous phase to another phase (see ISO 13164‑3).
The test methods can be applied either in the laboratory or on...
view more

    • sale 10% off
    • Standard
      33 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      30 pages
      English language
    • e-Library read for
      1 day

ISO 13164-3:2013 specifies a test method for the determination of radon-222 activity concentration in a sample of water following its transfer from the aqueous phase to the air phase by degassing and its detection. It gives recommendations for rapid measurements performed within less than 1 h.
The radon-222 activity concentrations, which can be measured by this test method utilizing currently available instruments, range from 0,1 Bq l−1 to several hundred thousand becquerels per litre for a 100...
view more

    • sale 10% off
    • Standard
      31 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      28 pages
      English language
    • e-Library read for
      1 day

ISO 13164-2:2013 specifies a test method for the determination of radon-222 activity concentration in a sample of water following the measurement of its short-lived decay products by direct gamma-spectrometry of the water sample.
The radon-222 activity concentrations, which can be measured by this test method utilizing currently available gamma-ray instruments, range from a few becquerels per litre to several hundred thousand becquerels per litre for a 1 l test sample.
This test method can be ...
view more

    • sale 10% off
    • Standard
      21 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      18 pages
      English language
    • e-Library read for
      1 day

ISO 13165-1:2013 specifies the determination of radium-226 (226Ra) activity concentration in non-saline water samples by extraction of its daughter radon-222 (222Rn) and its measurement using liquid scintillation counting.
Radium-226 activity concentrations which can be measured by this test method utilizing currently available liquid scintillation counters goes down to 50 mBq l−1. This method is not applicable to the measurement of other radium isotopes.

    • sale 10% off
    • Standard
      22 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      19 pages
      English language
    • e-Library read for
      1 day

ISO 13165-2:2014 specifies the determination of radium-226 (226Ra) activity concentration in all types of water by emanometry. The method specified is suitable for the determination of the soluble, suspended, and total 226Ra activity concentration in all types of water with soluble 226Ra activity concentrations greater than 0,02 Bq l−1. In water containing high activity concentrations of 228Th, interference from 220Rn decay products can lead to overestimation of measured levels.

    • sale 10% off
    • Standard
      23 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      20 pages
      English language
    • e-Library read for
      1 day

ISO 13164-4:2015 describes a test method for the determination of radon-222 (222Rn) activity concentration in non-saline waters by extraction and liquid scintillation counting.
The radon-222 activity concentrations, which can be measured by this test method utilizing currently available instruments, are at least above 0,5 Bq l−1 for a 10 ml test sample and a measuring time of 1 h.
This test method can be used successfully with drinking water samples and it is the responsibility of the laborato...
view more

    • sale 10% off
    • Standard
      20 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      17 pages
      English language
    • e-Library read for
      1 day

ISO 13165-3:2016 specifies the determination of radium-226 (226Ra) activity concentration in all types of water by coprecipitation followed by gamma-spectrometry (see ISO 18589‑3).
The method described is suitable for determination of soluble 226Ra activity concentrations greater than 0,02 Bq l−1 using a sample volume of 1 l to 100 l of any water type.
For water samples smaller than a volume of 1 l, direct gamma-spectrometry can be performed following ISO 10703 with a higher detection limit.
...
view more

    • sale 10% off
    • Standard
      22 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      19 pages
      English language
    • e-Library read for
      1 day

ISO 13165-3:2016 specifies the determination of radium-226 (226Ra) activity concentration in all types of water by coprecipitation followed by gamma-spectrometry (see ISO 18589‑3).
The method described is suitable for determination of soluble 226Ra activity concentrations greater than 0,02 Bq l−1 using a sample volume of 1 l to 100 l of any water type.
For water samples smaller than a volume of 1 l, direct gamma-spectrometry can be performed following ISO 10703 with a higher detection limit.
...
view more

    • sale 10% off
    • Standard
      22 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      19 pages
      English language
    • e-Library read for
      1 day

ISO 13164-2:2013 specifies a test method for the determination of radon-222 activity concentration in a sample of water following the measurement of its short-lived decay products by direct gamma-spectrometry of the water sample.
The radon-222 activity concentrations, which can be measured by this test method utilizing currently available gamma-ray instruments, range from a few becquerels per litre to several hundred thousand becquerels per litre for a 1 l test sample.
This test method can be ...
view more

    • sale 10% off
    • Standard
      21 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      18 pages
      English language
    • e-Library read for
      1 day

ISO 13165-1:2013 specifies the determination of radium-226 (226Ra) activity concentration in non-saline water samples by extraction of its daughter radon-222 (222Rn) and its measurement using liquid scintillation counting.
Radium-226 activity concentrations which can be measured by this test method utilizing currently available liquid scintillation counters goes down to 50 mBq l−1. This method is not applicable to the measurement of other radium isotopes.

    • sale 10% off
    • Standard
      22 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      19 pages
      English language
    • e-Library read for
      1 day

ISO 13164-3:2013 specifies a test method for the determination of radon-222 activity concentration in a sample of water following its transfer from the aqueous phase to the air phase by degassing and its detection. It gives recommendations for rapid measurements performed within less than 1 h.
The radon-222 activity concentrations, which can be measured by this test method utilizing currently available instruments, range from 0,1 Bq l−1 to several hundred thousand becquerels per litre for a 100...
view more

    • sale 10% off
    • Standard
      31 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      28 pages
      English language
    • e-Library read for
      1 day

ISO 13165-2:2014 specifies the determination of radium-226 (226Ra) activity concentration in all types of water by emanometry. The method specified is suitable for the determination of the soluble, suspended, and total 226Ra activity concentration in all types of water with soluble 226Ra activity concentrations greater than 0,02 Bq l−1. In water containing high activity concentrations of 228Th, interference from 220Rn decay products can lead to overestimation of measured levels.

    • sale 10% off
    • Standard
      23 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      20 pages
      English language
    • e-Library read for
      1 day

ISO 13164-4:2015 describes a test method for the determination of radon-222 (222Rn) activity concentration in non-saline waters by extraction and liquid scintillation counting.
The radon-222 activity concentrations, which can be measured by this test method utilizing currently available instruments, are at least above 0,5 Bq l−1 for a 10 ml test sample and a measuring time of 1 h.
This test method can be used successfully with drinking water samples and it is the responsibility of the laborato...
view more

    • sale 10% off
    • Standard
      20 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      17 pages
      English language
    • e-Library read for
      1 day

ISO 13164-1:2013 gives general guidelines for sampling, packaging, and transporting of all kinds of water samples, for the measurement of the activity concentration of radon-222.
The test methods fall into two categories: a) direct measurement of the water sample without any transfer of phase (see ISO 13164‑2); b) indirect measurement involving the transfer of the radon-222 from the aqueous phase to another phase (see ISO 13164‑3).
The test methods can be applied either in the laboratory or on...
view more

    • sale 10% off
    • Standard
      33 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      30 pages
      English language
    • e-Library read for
      1 day

This document specifies the determination of radium-226 (226Ra) and radium-228 (228Ra) activity concentrations in drinking water samples by chemical separation of radium and its measurement using liquid scintillation counting.
Massic activity concentrations of 226Ra and 228Ra which can be measured by this test method utilizing currently available liquid scintillation counters go down to 0,01 Bq/kg for 226Ra and 0,06 Bq/kg for 228Ra for a 0,5 kg sample mass and a 1 h counting time in a low backg...
view more

    • sale 10% off
    • Standard
      37 pages
      English language
    • e-Library read for
      1 day
    • sale 10% off
    • Draft
      34 pages
      English language
    • e-Library read for
      1 day