oSIST prEN 50583-1:2024
(Main)Photovoltaics in buildings - Part 1: BIPV modules
Photovoltaics in buildings - Part 1: BIPV modules
This document applies to photovoltaic modules that contain at least one glass pane and which are used as construction products. It focuses on the properties of these photovoltaic modules relevant to essential building requirements as specified in the European Construction Product Regulation CPR 305/2011, and the applicable electro-technical requirements as stated in the Low Voltage Directive 2014/35/EU / or CENELEC standards. The CE mark of building integrated photovoltaic (BIPV) modules will thus state properties based on both documents as they are both equally applicable.
This document references international standards, technical reports and guidelines. For some mounting categories, in addition, national standards (or regulations) for building products may apply in individual countries, which are not explicitly referenced here and for which harmonized European Standards are not yet available.
The document is addressed to manufacturers, planners, system designers, installers, testing institutes and building authorities.
This document does not address concentrating or building-attached photovoltaic modules (BAPV).
This document addresses requirements on the PV modules in the specific ways they are intended to be mounted. Separable mounting structures are within the scope of EN 50583 2.
NOTE For the definition of building-attached photovoltaic modules (BAPV) refer to Clause 3.
Photovoltaik im Bauwesen - Teil 1 BIPV-Module
Photovoltaïque dans la construction - Partie 1: Modules photovoltaïques intégrés au bâtiment
Le présent document s'applique aux modules photovoltaïques qui comprennent au moins un panneau de verre et qui sont utilisés comme des produits de construction. Il cible les propriétés des modules photovoltaïques qui se rapportent aux exigences de construction essentielles spécifiées dans le règlement européen sur les produits de construction (CPR - Construction Product Regulation) 305/2011, et les exigences électrotechniques applicables indiquées dans la directive basse tension 2014/35/EU ou dans les normes CENELEC. Le marquage CE des modules photovoltaïques intégrés au bâtiment modules (modules BIPV) sert à indiquer leurs propriétés sur la base de ces deux documents, car ils sont tout aussi applicables.
Le présent document fait référence à des normes internationales, des rapports techniques et des lignes directrices. Pour certaines catégories de montage, d'autres normes nationales (ou règlements nationaux) relatives aux produits de construction peuvent s'appliquer dans certains pays, qui ne sont pas référencées de manière explicite dans la présente norme et pour lesquelles il n'existe pas encore de normes européennes harmonisées.
Ce document est destiné aux fabricants, aux planificateurs, aux concepteurs de systèmes, aux installateurs, aux organismes d'essai et aux autorités compétentes en matière de construction.
Le présent document ne traite pas des modules photovoltaïques à concentration ou attenants à un bâtiment (BAPV - building-attached photovoltaic modules).
Le présent document traite des exigences relatives aux méthodes spécifiques selon lesquelles les modules BIPV sont destinés à être montés. Les structures de montage détachables relèvent du domaine d'application de l'EN 50583 2.
NOTE Voir l’Article 3 pour la définition des modules photovoltaïques attenants au bâtiment (modules BAPV).
Fotonapetostni elementi v stavbah - 1. del: Moduli, vgrajeni v stavbo (BIPV)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
oSIST prEN 50583-1:2024
01-marec-2024
Fotonapetostni elementi v stavbah - 1. del: Moduli, vgrajeni v konstrukcijo (BIPV)
Photovoltaics in buildings - Part 1: BIPV modules
Photovoltaik im Bauwesen - Teil 1 BIPV-Module
Photovoltaïque dans la construction - Partie 1: Modules photovoltaïques intégrés au
bâtiment
Ta slovenski standard je istoveten z: prEN 50583-1
ICS:
27.160 Sončna energija Solar energy engineering
oSIST prEN 50583-1:2024 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 50583-1:2024
---------------------- Page: 2 ----------------------
oSIST prEN 50583-1:2024
EUROPEAN STANDARD DRAFT
prEN 50583-1
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2023
ICS 27.160 Will supersede EN 50583-1:2016
English Version
Photovoltaics in buildings - Part 1: BIPV modules
Photovoltaïque dans la construction - Partie 1: Modules Photovoltaik im Bauwesen - Teil 1 BIPV-Module
photovoltaïques intégrés au bâtiment
This draft European Standard is submitted to CENELEC members for enquiry.
Deadline for CENELEC: 2024-03-08.
It has been drawn up by CLC/TC 82.
If this draft becomes a European Standard, CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CENELEC in three official versions (English, French, German).
A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to
the CEN-CENELEC Management Centre has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Türkiye and the United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Project: 74287 Ref. No. prEN 50583-1 E
---------------------- Page: 3 ----------------------
oSIST prEN 50583-1:2024
prEN 50583-1:2023 (E)
Contents Page
1 European foreword . 3
2 1 Scope . 4
3 2 Normative references . 4
4 3 Terms and definitions . 6
5 4 Requirements . 7
6 4.1 General . 7
7 4.2 Electrical requirements . 7
8 4.3 Building/construction works related requirements . 8
9 5 Mounting categories .11
10 6 Labelling .13
11 7 Documentation and declaration of performance.13
12 7.1 Data sheet .13
13 7.2 EU Declaration of Conformity and Declaration of Performance .13
14
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.