ASTM D5564-95

Standard Test Method for Determination of the Total Ammonia Contained in Sulfonated or Sulfated Oils

SCOPE
1.1 This test method covers determination of the total ammonia contained in sulfonated or sulfated oils.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

General Information

• Status: Historical
• Publication Date: 14-May-1995
• Technical Committee: D31 - Leather
• Drafting Committee: D31.08 - Fats and Oils

Relations

• Replaced By: ASTM D5564-95(2001) - Standard Test Method for Determination of the Total Ammonia Contained in Sulfonated or Sulfated Oils
• Effective Date: 15-May-1995

Standards Content (Sample)

NOTICE: This standard has either been superseded and replaced by a new version or discontinued.
Contact ASTM International (www.astm.org) for the latest information.
Designation: D 5564 – 95
Standard Test Method for
Determination of the Total Ammonia Contained in
Sulfonated or Sulfated Oils
This standard is issued under the fixed designation D 5564; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (e) indicates an editorial change since the last revision or reapproval.
1. Scope
1.1 This test method covers determination of the total
ammonia contained in sulfonated or sulfated oils.
1.2 The values stated in SI units are to be regarded as the
standard.
1.3 This standard does not purport to address all of the
safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish appro-
priate safety and health practices and determine the applica-
bility of regulatory limitations prior to use.
2. Referenced Documents
2.1 ASTM Standards:
D 500 Test Methods for Chemical Analysis of Sulfonated
and Sulfated Oils
D 5350 Test Method for Determination of Organically
Combined Sulfuric Anhydride by Titration, Test Method
A
FIG. 1 Apparatus for Determination of Organically Combined
Sulfuric Anhydride, Method A
3. Significance and Use
3.1 This test method of analysis is intended to determine the
4.1.3 Glass Beads—Perforated glass beads, made of chemi-
total ammonia in a sample of sulfonated or sulfated oil, or both,
cally resistant glass, approximately 4 mm ( ⁄32 in.) in diameter.
by boiling a water solution of the sample with excess alkali and
Before using, the glass beads shall be boiled thoroughly in
determining by titration the loss in alkali after the boiling.
several portions of water or until the wash water reacts neutral
to a methyl orange indicator.
4. Apparatus
4.1 The apparatus required consists of a glass flask provided
5. Reagents
with a glass stopper and an air condenser. The connection
5.1 Ethyl Ether.
between the flask and the condenser shall be a ground joint.
5.2 Methyl Orange Indicator Solution (1 g/L)—Dissolve
Perforated glass beads shall be used to prevent bumping.
0.1 g of methyl orange in 100 mL of water.
4.1.1 Flask—An Erlenmeyer flask (Fig. 1) made of a
5.3 Sodium Chloride (NaCl), solid.
borosilicate glass, having a capacity of approximately 300 mL
5.4 Sodium Hydroxide, Standard Solution (1 N)—
and provided with a glass stopper.
Accurately prepare and standardize a 1 N sodium hydroxide
4.1.2 Condenser, consisting of a glass tube, 915 mm (36 in.)
(NaOH) solution. Express the strength or concentration of the
in length and 8 mm ( ⁄16 in.) in outside diameter. The lower end
solution as mg of KOH per mL; 1 mL of 1 N NaOH solution
of the tube shall be flared and ground to fit the mouth of the
is equivalent to 56.1 mg of KOH.
Erlenmeyer flask.
5.5 Sodium Hydroxide, Standard Solution (0.5 N)— Accu-
rately prepare and standardize a 0.5 N NaOH solution. Express
1 the strength of the solution as mg of KOH per mL; 1 mL of 0.5
This test method is under the jurisdiction of ASTM Committee D-31 on Leather
N NaOH solution is equivalent to 28.05 mg of KOH.
and is the direct responsibility of Subcommittee D31.08 on Fats and Oils. This test
method was developed in cooperation with the American Leather Chemists Assn.
5.6 Sulfuric Acid, Standard (0.5 N)—Accurately prepare
(Method H 49-1957).
and standardize a 0.5 N sulfuric acid (H SO ) solution. Express
2 4
Current edition approved May 15, 1995. Published July 1995. Originally
the strength of the solution as mg of KOH per mL; 1
...