EN 15433-1:2007
(Main)Transportation loads - Measurement and evaluation of dynamic mechanical loads - Part 1: General requirements
Transportation loads - Measurement and evaluation of dynamic mechanical loads - Part 1: General requirements
This standard specifies the general requirements to be observed during the measurement and evaluation of dynamic-mechanical transportation loads, should the results raise a claim of generalization and be incorporated in this series of standards as fundamental data.
Transportbelastungen - Messen und Auswerten von mechanisch-dynamischen Belastungen - Teil 1: Allgemeine Anforderungen
Diese Norm legt allgemeine Anforderungen fest, die bei der Messung und Auswertung mechanisch-dynamischer
Transportbelastungen zu erfüllen sind, wenn die Ergebnisse den Anspruch der Verallgemeinerungsfähigkeit
erheben und als grundlegende Daten in diese Normenreihe aufgenommen werden sollen.
Charges de transport - Mesurage et analyse des charges mécaniques dynamiques - Partie 1 : Exigences générales
La présente norme spécifie les exigences générales à respecter lors du mesurage et de l'évaluation des charges de transport mécaniques dynamiques, si les résultats devaient susciter une revendication de généralisation et être intégrés dans la présente série de normes comme données fondamentales.
Obremenitve pri transportu - Merjenje in analiza dinamično mehanskih obremenitev - 1. del: Splošne zahteve
General Information
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Transportation loads - Measurement and analysis of dynamic mechanical loads - Part 1: General requirementsNLKCharges de transport - Mesurage et analyse des charges mécaniques dynamiques - Partie 1 : Exigences généralesTransportbelastungen - Messen und Auswerten von mechanisch-dynamischen Belastungen - Teil 1: Allgemeine AnforderungenTa slovenski standard je istoveten z:EN 15433-1:2007SIST EN 15433-1:2008en,de55.180.01ICS:SLOVENSKI
STANDARDSIST EN 15433-1:200801-februar-2008
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 15433-1December 2007ICS 55.180.01 English VersionTransportation loads - Measurement and evaluation of dynamicmechanical loads - Part 1: General requirementsCharges de transport - Mesurage et analyse des chargesmécaniques dynamiques - Partie 1 : Exigences généralesTransportbelastungen - Messen und Auswerten vonmechanisch-dynamischen Belastungen - Teil 1: AllgemeineAnforderungenThis European Standard was approved by CEN on 28 October 2007.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the CEN Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as theofficial versions.CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2007 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 15433-1:2007: E
EN 15433-1:2007 (E) 2 Contents Page Foreword.3 Introduction.4 1 Scope.5 2 Normative references.5 3 Requirements.5 3.1 Fundamental requirements.5 3.2 Location of measuring points.5 3.3 Source data.6 3.4 Care during data acquisition and documentation.6 3.5 Measuring report.6 3.6 Measurement on a transported item.6 3.7 Data validity check.6 3.8 Data analysis.6 3.9 Derivation of test specifications.7 3.10 Transportation monitoring with automatic recording equipment.7 Bibliography.8
EN 15433-1:2007 (E) 3 Foreword This document (EN 15433-1:2007) has been prepared by Technical Committee CEN/TC 261 “Packaging”, the secretariat of which is held by AFNOR. This European Standard shall be gi
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.