FprEN 13880-4
(Main)Hot applied joint sealants - Part 4: Test method for the characterization of heat resistance - Change in penetration value
Hot applied joint sealants - Part 4: Test method for the characterization of heat resistance - Change in penetration value
This document specifies a method to characterize the heat resistance on samples of hot applied joint sealants according to EN 14188 1 by comparing the cone penetration and resilience values before and after exposure.
Heiß verarbeitbare Fugenmassen - Teil 4: Prüfverfahren zur Bestimmung der Wärmebeständigkeit - Änderung der Konus-Penetration
Dieses Dokument legt ein Verfahren zur Charakterisierung der Wärmebeständigkeit von Proben von heiß verarbeitbaren Fugenmassen nach EN 14188 1 durch Vergleich der Werte von Konus-Penetration und Rückstellvermögen vor und nach der Exposition fest.
Produits de scellement de joints appliqués à chaud - Partie 4 : Méthode d'essai pour la détermination de la résistance à la chaleur - Variation de la pénétrabilité
Ce document décrit une méthode pour caractériser la résistance à une température élevée sur des échantillons de mastics de joints appliqués à chaud selon la norme EN 14188-1 en comparant les valeurs de pénétration du cône et de résilience avant et après exposition.
Tesnilne mase za stike, ki se vgrajujejo po vročem postopku - 4. del: Preskusna metoda za karakterizacijo odpornosti proti toploti - Sprememba penetracije
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
oSIST prEN 13880-4:2022
01-december-2022
Tesnilne mase za stike, ki se vgrajujejo po vročem postopku - 4. del: Preskusna
metoda za karakterizacijo odpornosti proti toploti - Sprememba penetracije
Hot applied joint sealants - Part 4: Test method for the characterization of heat resistance
- Change in penetration value
Heiß verarbeitbare Fugenmassen - Teil 4: Prüfverfahren zur Bestimmung der
Wärmebeständigkeit - Änderung der Konus-Penetration
Produits de scellement de joints appliqués à chaud - Partie 4 : Méthode d'essai pour la
détermination de la résistance à la chaleur - Variation de la pénétrabilité
Ta slovenski standard je istoveten z: prEN 13880-4
ICS:
91.100.50 Veziva. Tesnilni materiali Binders. Sealing materials
93.080.20 Materiali za gradnjo cest Road construction materials
oSIST prEN 13880-4:2022 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 13880-4:2022
---------------------- Page: 2 ----------------------
oSIST prEN 13880-4:2022
DRAFT
EUROPEAN STANDARD
prEN 13880-4
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2022
ICS 93.080.20 Will supersede EN 13880-4:2003
English Version
Hot applied joint sealants - Part 4: Test method for the
characterization of heat resistance - Change in penetration
value
Produits de scellement de joints appliqués à chaud - Heiß verarbeitbare Fugenmassen - Teil 4:
Partie 4 : Méthode d'essai pour la détermination de la Prüfverfahren zur Bestimmung der
résistance à la chaleur - Variation de la pénétrabilité Wärmebeständigkeit - Änderung der Konus-
Penetration
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 227.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2022 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 13880-4:2022 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 13880-4:2022
prEN 13880-4:2022 (E)
Contents Page
European foreword . 3
1 Scope . 4
2 Normative references . 4
3 Terms and definitions . 4
4 Principle . 4
5 Apparatus . 5
6 Procedure. 5
6.1 General . 5
6.2 Expo
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.